ABSTRACT
Soil moisture profile sensors (SMPSs) have a high potential for climate-smart agriculture due to their easy handling and ability to perform simultaneous measurements at different depths. To date, an accurate and easy-to-use method for the evaluation of long SMPSs is not available. In this study, we developed laboratory and field experiments to evaluate three different SMPSs (SoilVUE10, Drill&Drop, and SMT500) in terms of measurement accuracy, sensor-to-sensor variability, and temperature stability. The laboratory experiment features a temperature-controlled lysimeter to evaluate intra-sensor variability and temperature stability of SMPSs. The field experiment features a water level-controlled sandbox and reference TDR measurements to evaluate the soil water measurement accuracy of the SMPS. In both experiments, a well-characterized fine sand was used as measurement medium to ensure homogeneous dielectric properties in the measurement domain of the sensors. The laboratory experiments with the lysimeter showed that the Drill&Drop sensor has the highest temperature sensitivity with a decrease of 0.014 m3 m-3 per 10 °C, but at the same time showed the lowest intra- and inter-sensor variability. The field experiment with the sandbox showed that all three SMPSs have a similar performance (average RMSE ≈ 0.023 m3 m-3) with higher uncertainties at intermediate soil moisture contents. The presented combination of laboratory and field tests were found to be well suited to evaluate the performance of SMPSs and will be used to test additional SMPSs in the future.
ABSTRACT
Soil water content (SWC) monitoring is often used to optimize agricultural irrigation. Commonly, capacitance sensors are used for this task. However, the factory calibrations have been often criticized for their limited accuracy. The aim of this paper is to test the degree of improvement of various sensor- and soil-specific calibration options compared to factory calibrations by taking the 10HS sensor as an example. To this end, a two-step sensor calibration was carried out. In the first step, the sensor response was related to dielectric permittivity using calibration in media with well-defined permittivity. The second step involved the establishment of a site-specific relationship between permittivity and soil water content using undisturbed soil samples and time domain reflectometry (TDR) measurements. Our results showed that a model, which considered the mean porosity and a fitted dielectric permittivity of the solid phase for each soil and depth, provided the best fit between bulk permittivity and SWC. Most importantly, it was found that the two-step calibration approach (RMSE: 1.03 vol.%) provided more accurate SWC estimates compared to the factory calibration (RMSE: 5.33 vol.%). Finally, we used these calibrations on data from drip-irrigated almond and apple orchards and compared the factory calibration with our two-step calibration approach.
ABSTRACT
Soil water content is a key variable for understanding and modelling ecohydrological processes. Low-cost electromagnetic sensors are increasingly being used to characterize the spatio-temporal dynamics of soil water content, despite the reduced accuracy of such sensors as compared to reference electromagnetic soil water content sensing methods such as time domain reflectometry. Here, we present an effective calibration method to improve the measurement accuracy of low-cost soil water content sensors taking the recently developed SMT100 sensor (Truebner GmbH, Neustadt, Germany) as an example. We calibrated the sensor output of more than 700 SMT100 sensors to permittivity using a standard procedure based on five reference media with a known apparent dielectric permittivity (1 < Ka < 34.8). Our results showed that a sensor-specific calibration improved the accuracy of the calibration compared to single "universal" calibration. The associated additional effort in calibrating each sensor individually is relaxed by a dedicated calibration setup that enables the calibration of large numbers of sensors in limited time while minimizing errors in the calibration process.
ABSTRACT
Climate change and stagnating crop yields may cause a decline of SOC stocks in agricultural soils leading to considerable CO2 emissions and reduced agricultural productivity. Regional model-based SOC projections are needed to evaluate these potential risks. In this study, we simulated the future SOC development in cropland and grassland soils of Bavaria in the 21(st) century. Soils from 51 study sites representing the most important soil classes of Central Europe were fractionated and derived SOC pools were used to initialize the RothC soil carbon model. For each site, long-term C inputs were determined using the C allocation method. Model runs were performed for three different C input scenarios as a realistic range of projected yield development. Our modelling approach revealed substantial SOC decreases of 11-16% under an expected mean temperature increase of 3.3 °C assuming unchanged C inputs. For the scenario of 20% reduced C inputs, agricultural SOC stocks are projected to decline by 19-24%. Remarkably, even the optimistic scenario of 20% increased C inputs led to SOC decreases of 3-8%. Projected SOC changes largely differed among investigated soil classes. Our results indicated that C inputs have to increase by 29% to maintain present SOC stocks in agricultural soils.
ABSTRACT
Sequestration of atmospheric carbon (C) in soils through improved management of forest and agricultural land is considered to have high potential for global CO2 mitigation. However, the potential of soils to sequester soil organic carbon (SOC) in a stable form, which is limited by the stabilization of SOC against microbial mineralization, is largely unknown. In this study, we estimated the C sequestration potential of soils in southeast Germany by calculating the potential SOC saturation of silt and clay particles according to Hassink [Plant and Soil 191 (1997) 77] on the basis of 516 soil profiles. The determination of the current SOC content of silt and clay fractions for major soil units and land uses allowed an estimation of the C saturation deficit corresponding to the long-term C sequestration potential. The results showed that cropland soils have a low level of C saturation of around 50% and could store considerable amounts of additional SOC. A relatively high C sequestration potential was also determined for grassland soils. In contrast, forest soils had a low C sequestration potential as they were almost C saturated. A high proportion of sites with a high degree of apparent oversaturation revealed that in acidic, coarse-textured soils the relation to silt and clay is not suitable to estimate the stable C saturation. A strong correlation of the C saturation deficit with temperature and precipitation allowed a spatial estimation of the C sequestration potential for Bavaria. In total, about 395 Mt CO2 -equivalents could theoretically be stored in A horizons of cultivated soils - four times the annual emission of greenhouse gases in Bavaria. Although achieving the entire estimated C storage capacity is unrealistic, improved management of cultivated land could contribute significantly to CO2 mitigation. Moreover, increasing SOC stocks have additional benefits with respect to enhanced soil fertility and agricultural productivity.
Subject(s)
Agriculture , Carbon Sequestration , Ecosystem , Soil/chemistry , Carbon/analysis , GermanyABSTRACT
The chemical complexity of emissions from bitumen applications is a challenge in the assessment of exposure. Personal sampling of vapours and aerosols of bitumen was organized in 320 bitumen-exposed workers and 69 non-exposed construction workers during 2001-2008. Area sampling was conducted at 44 construction sites. Area and personal sampling of vapours and aerosols of bitumen showed similar concentrations between 5 and 10 mg/m(3), while area sampling yielded higher concentrations above the former occupational exposure limit (OEL) of 10 mg/m(3). The median concentration of personal bitumen exposure was 3.46 mg/m(3) (inter-quartile range 1.80-5.90 mg/m(3)). Only few workers were exposed above the former OEL. The specificity of the method measuring C-H stretch vibration is limited. This accounts for a median background level of 0.20 mg/m³ in non-exposed workers which is likely due to ubiquitous aliphatic hydrocarbons. Further, area measurements of polycyclic aromatic hydrocarbons (PAHs) were taken at 25 construction sites. U.S. EPA PAHs were determined with GC/MS, with the result of a median concentration of 2.47 µg/m(3) at 15 mastic asphalt worksites associated with vapours and aerosols of bitumen, with a Spearman correlation coefficient of 0.45 (95% CI -0.13 to 0.78). PAH exposure at mastic-asphalt works was higher than at reference worksites (median 0.21 µg/m(3)), but about one order of magnitude lower compared to coke-oven works. For a comparison of concentrations of vapours and aerosols of bitumen and PAHs in asphalt works, differences in sampling and analytical methods must to be taken into account.
Subject(s)
Air Pollutants, Occupational/analysis , Hydrocarbons/analysis , Occupational Exposure/analysis , Polycyclic Aromatic Hydrocarbons/analysis , Aerosols , Air Pollution, Indoor/analysis , Cross-Sectional Studies , Environmental Monitoring/methods , Humans , Inhalation Exposure/analysis , Male , Risk AssessmentABSTRACT
In the framework of the German environmental specimen bank one-year old spruce shoots (Picea abies) and pine shoots (Pinus sylvestris) serve as bioindicators for the atmospheric pollution. Sampling is performed in two urbanized areas in western and eastern Germany (Warndt and Duebener Heide, respectively), and in seven different rural locations. Prior to archiving conifer shoots are continuously analyzed for a set of 17 individual polycyclic aromatic hydrocarbons (PAHs). The results from the two urbanized areas show that the atmospheric contamination with PAH has declined by about 75% between 1985 and 2004 at Warndt and by about 85% between 1991 and 2004 at Duebener Heide. However, summation operatorPAH concentrations stayed virtually constant at both locations since the end of the 1990s at levels of about 100 ng g(-1) wet weight (ww). In spruce shoots from rural areas current concentrations of PAHs are significantly lower and vary between 8 and 61 ng g(-1) ww. In all shoot samples the four low molecular aromatics phenanthrene, fluoranthene, pyrene, and chrysene dominate the pattern by contributing 60 to 90% to summation operatorPAH. The group of high molecular weight aromatics is dominated by benzo[b,j,k]fluoranthene, especially in spruce shoots originating from greater altitudes remarkable amounts of six and seven ringed PAHs could be detected. Despite the strong decrease of PAH concentrations in urban areas patterns of aromatics remained nearly unchanged in the observation period 1985 to 2004.
Subject(s)
Environmental Pollutants/analysis , Plant Shoots/chemistry , Polycyclic Compounds/analysis , Trees/chemistry , GermanyABSTRACT
Integral equation theory is used for extrapolating free energy data from molecular simulations of a reference state with respect to a modification of the interaction potential. The methodology is applied to the correction of artefacts arising from potential shifting and truncation. Corrective contributions for the hydration free energy with respect to the full potential are analysed for the case that both the solute-solvent as well as the solvent-solvent potentials are truncated and modified by a shifted-force term, reaching beyond the range of the dielectric continuum approximation and simple long-range correction expressions. The model systems argon in water and pure water are used as examples for apolar and polar solutes, revealing significant correction contributions even for the short-ranged dispersive interactions and the magnitude of solute-solvent and solvent-solvent components. In comparison with simulation-based extrapolation techniques the integral equation method is shown to be capable of quantitatively predicting truncation artefacts at negligible computational overhead.
Subject(s)
Computer Simulation , Thermodynamics , Artifacts , Solutions , Solvents , Water/chemistryABSTRACT
Only few data are available on the carcinogenic potency of individual PCB congeners. In this study, we tested the 'non-dioxinlike' congeners PCB 28 and 101 for their potency as liver tumor promoters in female rats which received diethyl-N-nitrosamine as an initiator. After 8 or 16 weeks of PCB treatment (50 and 150 micromol/kg body weight per week), each congener was recovered in the liver according to the dose levels applied, with PCB 28, at the same dose level, showing nine- to 16-fold higher hepatic levels than PCB 101 (approximately, 44 micromol/kg versus 5 micromol/kg liver at low dose, 145 micromol/kg versus 9 micromol/kg liver at high dose). PCB 28 was found to mildly induce hepatic EROD activity, while both congeners induced PROD activity. With each congener, no significant increase in the number of ATPase-deficient or GSTP-positive preneoplastic foci was obtained, while a significant increase in the relative hepatic volume of ATPase-deficient foci was found in the livers of DEN pre-treated animals having received 50 micromol/kg body weight of PCB 101 per week over 16 weeks. Our results revealed that neither the accumulative PCB 28 nor the more readily metabolisable PCB 101 was an efficacious tumor promoter in the livers of female rats.