Characterization of polymer monolithic columns for small-molecule separations using total-pore-blocking conditions.

This study involves the investigation of the meso- and micropores in polymer monolithic materials and the performance characterization of polymer monoliths for the separation of small molecules. Pore-blocking experiments, that involve the blocking of the stagnant pores with a solvent which is immiscible with the mobile phase, were conducted to determine interstitial volumes of a commercially-available polymer monolithic column. After blocking the meso- and micropores a clear reduction in the column void time was observed. Using this approach, the internal porosity (defined as the sum of the meso- and micropores with respect to the volume of the monolithic material) was determined at 12.5%. Peak-dispersion measurements were conducted by applying reversed-phase (RP) conditions. The high plate-height values for small-molecule separations are mainly attributed to the large eddy-diffusion and mobile-phase mass-transfer contributions to band broadening, related to the inhomogeneous structure and presence of parabolic profiles in the macropores. The C-term contribution of early eluting (retained) compounds was higher than that of the late eluting compounds. This could be attributed to the low zone-retention factors of early-eluting compounds and consequently a large stationary-phase mass-transfer contribution. However, peak-dispersion measurements with blocked meso- and micropores carried out at RP conditions indicated that the Cs-contribution alone is likely not be the main cause of peak broadening. Finally, (1)H spin-spin (T2) relaxometry NMR measurements were conducted with water and ACN in the monolithic material.

Quantitative analysis of polymer mixtures in solution by pulsed field-gradient spin echo NMR spectroscopy.

Pulsed Field-Gradient Spin Echo (PGSE) NMR, which associates to a spectral dimension the measure of diffusion coefficients, is a convenient technique for mixture analysis. Unfortunately, because of relaxation, the quantification of mixtures by PGSE NMR is far from straightforward for mixtures with strong spectral overlap. Antalek (J. Am. Chem. Soc. 128 (2006) 8402-8403) proposed a quantification strategy based on DECRA analysis and extrapolation to zero of the diffusion delay. More recently, Barrère et al. (J. Magn. Reson. 216 (2012) 201-208) presented a new strategy based also on DECRA and on the renormalization of the intensities using estimates of the T1 and T2 relaxation times. Here we report an alternative quantification approach in which the fractions are obtained by analyzing the PGSE attenuation profile with a general Stejskal-Tanner equation that explicitly includes the relaxation effects. The required values of T1 and T2 relaxation times are either independently measured with conventional sequences or determined, along with the fractions and the diffusion coefficients, from the simultaneous analysis of up to 6 PGSE data sets recorded with different diffusion delays. This method yields errors lower than 3% for the fractions, even for complete spectral overlap, as demonstrated on model binary and ternary mixtures of polystyrene in the case of a convection compensating double stimulated echo (DSTE) sequence.

A top-down synthesis route to ultrasmall multifunctional Gd-based silica nanoparticles for theranostic applications.

New, ultrasmall nanoparticles with sizes below 5 nm have been obtained. These small rigid platforms (SRP) are composed of a polysiloxane matrix with DOTAGA (1,4,7,10-tetraazacyclododecane-1-glutaric anhydride-4,7,10-triacetic acid)-Gd(3+) chelates on their surface. They have been synthesised by an original top-down process: 1) formation of a gadolinium oxide Gd2O3 core, 2) encapsulation in a polysiloxane shell grafted with DOTAGA ligands, 3) dissolution of the gadolinium oxide core due to chelation of Gd(3+) by DOTAGA ligands and 4) polysiloxane fragmentation. These nanoparticles have been fully characterised using photon correlation spectroscopy (PCS), transmission electron microscopy (TEM), a superconducting quantum interference device (SQUID) and electron paramagnetic resonance (EPR) to demonstrate the dissolution of the oxide core and by inductively coupled plasma mass spectrometry (ICP-MS), mass spectrometry, fluorescence spectroscopy, (29)Si solid-state NMR, (1)H NMR and diffusion ordered spectroscopy (DOSY) to determine the nanoparticle composition. Relaxivity measurements gave a longitudinal relaxivity r1 of 11.9 s(-1) mM(-1) per Gd at 60 MHz. Finally, potentiometric titrations showed that Gd(3+) is strongly chelated to DOTAGA (complexation constant logß110 =24.78) and cellular tests confirmed the that nanoconstructs had a very low toxicity. Moreover, SRPs are excreted from the body by renal clearance. Their efficiency as contrast agents for MRI has been proved and they are promising candidates as sensitising agents for image-guided radiotherapy.

In situ study of the deposition of (ultra)thin organic phosphonic acid layers on the oxide of aluminum.

The interest in self-assembling monolayer deposition on various oxide substrate surfaces is steeply increasing in the last decades. Although many studies are being performed, literature does not come with a general insight in the adsorption of these layers on oxide surfaces. Also for the deposition of phosphonic acids on aluminum oxides, there is no global consensus. In this paper, we present an original in situ analysis in order to eludicate the real layer formation mechanism. First of all, the state of the phosphonic acid molecules was determined using DOSY NMR, making sure that no structures other than free molecules were present at the concentration used. With in situ atomic force microscopy and in situ visual ellipsometry, multilayers of phosphonic acids, showing 3D island growth, were determined. It was shown that using the variation of the in situ obtained roughness and bearing ratio, together with the equivalent thickness modeled by ellipsometry, the growth of the layers occurs in situ in three different stages. They consist of increasing number of islands growth, followed by filling up the gaps between islands. At last, within the adsorption time frame measured, the islands grow further in dimensions but not in numbers. This closely corresponds with the behavior of the octylphosphonic acid films analyzed by ex situ techniques.

ERETIC implemented in diffusion-ordered NMR as a diffusion reference: a clarification.

Additional information as to the objectives of our previous paper entitled 'ERETIC implemented in diffusion-ordered NMR as a diffusion reference' (Magn. Reson. Chem. 2008, 46, S63) is provided. The need for an optimal instrumental stability for the method proposed to be reliably applicable in view of these objectives is emphasized and illustrated.

Mixed micelles of Triton X-100, sodium dodecyl dioxyethylene sulfate, and synperonic l61 investigated by NOESY and diffusion ordered NMR spectroscopy.

Mixed micelles formed from nonionic surfactant Triton X-100 (TX100), anionic surfactant sodium dodecyl dioxyethylene sulfate (SDP2S), and triblock copolymer Synperonic L61 (SL61) were investigated by 1H NMR spectroscopy. The size and shape of the aggregates were determined by diffusion ordered NMR spectroscopy (DOSY), while 2D nuclear Overhauser enhanced spectroscopy (NOESY) NMR was used to study the mutual spatial arrangement of the surfactant molecules in the aggregated state. An average micellar hydrodynamic radius of 3.6 nm, slightly increasing upon increasing TX100 molar fraction, was found for the mixed systems without additives. Addition of SL61 to the mixed micellar systems results in a slight increase of micellar radii. In the presence of AlCl3, an increase of TX100/SDP2S micellar sizes from 4 to 10 nm was found when increasing the SDP2S molar fraction. The mixed TX100/SDP2S micelles in the presence of both AlCl3 and polymer SL61 are almost spherical, with a radius of 4.5 nm. 2D NOESY data reveal that, as the individual TX100 micelles, mixed TX100/SDP2S and TX100/SDP2S/SL61/AlCl3 micelles also have a multilayer structure, with partially overlapping internal and external layers of TX100 molecules. In these mixed micelles, the SDP2S molecules are located at the level of the external layer of TX100 molecules, whereas the SL61 polymer is partially incorporated inside of the micellar core.

Phase behavior in blends of ethylene oxide-propylene oxide copolymer and poly(ether sulfone) studied by modulated-temperature DSC and NMR relaxometry.

The state diagram of a blend consisting of a copolymer containing ethylene oxide and propylene oxide, P(EO-ran-PO), and poly(ether sulfone), PES, is constructed by using modulated-temperature differential scanning calorimetry (MTDSC), T(2) NMR relaxometry, and light scattering. The apparent heat capacity signal in MTDSC is used for the characterization of polymer miscibility and morphology development. T(2) NMR relaxometry is used to detect the onset of phase separation, which is in good agreement with the onset of phase separation in the apparent heat capacity from MTDSC and the cloud-point temperature as determined from light scattering. The coexistence curve can be constructed from T(2) values at various temperatures by using a few blends with well-chosen compositions. These T(2) values also allow the detection of the boundary between the demixing zones with and without interference of partial vitrification and are in good agreement with stepwise quasi-isothermal MTDSC heat capacity measurements. Important interphases are detected in the heterogeneous P(EO-ran-PO)/PES blends.

ERETIC implemented in diffusion-ordered NMR as a diffusion reference.

The ERETIC (Electronic Reference To access In vivo Concentrations) technique generates an electronic signal in the NMR spectrometer which is detected simultaneously to the sample FID during the acquisition. The implementation of the ERETIC sequence in any 2D DOSY experimental scheme enables one to generate directly into the raw 2D DOSY spectrum a reference signal with an attenuation simulated to describe a well-defined diffusion behavior. This simulated intensity attenuation can be used to evaluate the output generated by any DOSY data treatment algorithm, in a single as well as multichannel approach and provide insight into their precision, accuracy, scope and limitations. The ERETIC sequence implemented in the standard bipolar pulsed field gradient longitudinal eddy current delay (LED) sequence is illustrated on various algorithms presented previously in the literature for the analysis of the generated ERETIC-DOSY spectra of simulated model systems representing discrete and continuous diffusion profiles in mono- and bi-Gaussian diffusion regimes.

Investigation of the dynamic stereochemistry of dimesityl-2,4,6-trimethoxyphenylmethane by complete lineshape analysis and 2D EXSY NMR spectroscopy.

The static and dynamic stereochemistry of dimesityl-2,4,6-trimethoxyphenylmethane in solution was investigated by lineshape analysis of 1D NMR spectra and cross-peak amplitude processing in 2D EXSY spectra, recorded at variable temperatures. Previous studies on this propeller-shaped chiral compound show that the stereomer threshold interconversion is associated with helicity reversal and occurs through [1,2]- and [1,3]-two ring flips of one mesityl and the 2,4,6-trimethoxyphenyl rings. In the present study, the experimental rate constants of the [1,2]- and [1,3]-two ring flips, which are identical, were determined at various temperatures by combining quantitative 2D EXSY spectra processing and complete lineshape analysis (CLSA) of 1D NMR spectra. The latter were subjected to reference deconvolution and linear prediction in order to eliminate the lineshape distortions due to magnetic field inhomogeneity. The activation parameters of these ring flips were determined by an Eyring equation analysis of the temperature dependence of the rate constant. The experimentally determined activation enthalpy and entropy for the two-ring flips, and those obtained from theoretical ab initio calculations at different levels of theory and basis sets, were found to be in good agreement.

Characterization of titanium dioxide nanoparticles dispersed in organic ligand solutions by using a diffusion-ordered spectroscopy-based strategy.

Diffusion-ordered NMR spectroscopy (DOSY NMR) is presented as a tool for the determination of the diffusion coefficients of organic ligands in suspensions of titanium dioxide nanoparticles. The nanoparticles were prepared by a sol-gel process by hydrolysis and condensation reactions of titanium tetra-n-butoxide in the presence of pentane-2,4-dione (acacH: acetylacetone), as well as para-toluenesulfonic acid (pTsA) and n-butanol (nBuOH). NMR spectroscopic studies were performed in various deuterated solvents, on both dispersed xerosols and diluted sols. The bipolar-pulsed field gradient longitudinal eddy-current delay (LED) pulse sequence was used for data acquisition. The data were processed by inverse Laplace transformation (ILT), by using a maximum entropy algorithm, to afford 2D DOSY spectra. Different diffusion regimes for organic ligands in the bound and unbound states were successfully discriminated, more particularly in [D3]acetonitrile, thus allowing assessment of their interactions with the nanoparticles.