Application of ultrasound to enhance the silt drying process: An experimental study.

Scientific and reasonable treatment of dredged silt can not only protect the ecological environment but also play an essential role in the utilization of silt resources. Due to high water content, low permeability and high organic matter content of the silt, a large amount of bacteria and harmful gases are often produced during the process of silt sedimentation. Thermal drying has been taken as a technically attractive method for harmless treatment of contaminated dredged silt. In this study, ultrasound technology is introduced to shorten the time needed for silt drying. A preliminary laboratory study is carried out to assess the effectiveness of ultrasound on thermal drying. A series of thermal drying tests, with and without ultrasound, were conducted on kaolin soil specimens that were prepared by settling and self-weight consolidation. The test results show that the length of drying time can be shortened by increasing temperature and ultrasound power. The drying time plays a dominant role in the determination of the total energy consumption. This is because reduction of drying time leads to significant decrease in energy consumption for thermal drying, and the energy consumption for additional ultrasound is relatively marginal. For thermal drying at temperatures 60 and 100°C, when combined with 100 W ultrasound, the length of drying time was shortened by 44.19% and 45.16%, and the energy consumption was saved by 30.07% and 38.16%, respectively; when combined with 60 W ultrasound, the length of drying time was shortened by 4.65% and 6.45%, but the energy consumption was increased by 9.79% and 0.48%, respectively. The combination of thermal drying and 100 W ultrasound is found to be optimal in terms of drying rate and energy consumption for silt drying.

Photooxidation of arsenic(III) to arsenic(V) on the surface of kaolinite clay.

As one of the most toxic heavy metals, the oxidation of inorganic arsenic has drawn great attention among environmental scientists. However, little has been reported on the solar photochemical behavior of arsenic species on top-soil. In the present work, the influencing factors (pH, relative humidity (RH), humic acid (HA), trisodium citrate, and additional iron ions) and the contributions of reactive oxygen species (ROS, mainly HO and HO2/O2(-)) to photooxidation of As(III) to As(V) on kaolinite surfaces under UV irradiation (λ=365nm) were investigated. Results showed that lower pH facilitated photooxidation, and the photooxidation efficiency increased with the increase of RH and trisodium citrate. Promotion or inhibition of As(III) photooxidation by HA was observed at low or high dosages, respectively. Additional iron ions greatly promoted the photooxidation, but excessive amounts of Fe(2+) competed with As(III) for oxidation by ROS. Experiments on scavengers indicated that the HO radical was the predominant oxidant in this system. Experiments on actual soil surfaces proved the occurrence of As(III) photooxidation in real topsoil. This work demonstrates that the photooxidation process of As(III) on the soil surface should be taken into account when studying the fate of arsenic in natural soil newly polluted with acidic wastewater containing As(III).

Separation of fine particles at different frequencies and HRTs using acoustic standing waves.

The objective of this study was to evaluate the separation of fine particles using several frequencies and hydraulic retention times (HRTs) in an acoustic standing wave reactor without any separate cooling devices. The acoustic standing wave reactor consisted of sufficient space (over 100 mm) between the transducer and reflector, resulting in a slight increase in temperature. However, the increase in temperature did not affect the formation of standing waves and particle aggregations in our experiments. The results indicated that the turbidity removal efficiencies of fine kaolin particles, when using frequencies of 580 kHz, 1, and 2 MHz, increased with longer standing wave operation time. Especially, the turbidity removal efficiencies for 1 and 2 MHz were higher than that for 580 kHz because the wavelength (λ) of the 580 kHz wave was longer than that of the 1 and 2 MHz waves. Furthermore, the turbidity removal efficiency of kaolin in a continuous reactor improved with increasing hydraulic retention times (HRTs), and the reactor was more effective with 1 and 2 MHz used in parallel instead of 1 and 2 MHz used individually under the same HRT conditions with the entrance length (EL) having no adverse effect.

Antibacterial activity of kaolinite/nanoTiO2 composites in relation to irradiation time.

The paper addresses laboratory preparation and antibacterial activity testing of kaolinite/nanoTiO2 composite in respect of the daylight irradiation time. Kaolinite/nanoTiO2 composites with 20 and 40 wt% of TiO2 were laboratory prepared, dried at 105 °C and calcined at 600 °C. The calcination caused transformation of kaolinite to metakaolinite and origination of the metakaolinite/nanoTiO2 composite. X-ray powder diffraction, Raman and FTIR spectroscopic methods revealed titanium dioxide only in the form of anatase in all evaluated samples (non-calcined and calcined) and also transformation of kaolinite to metakaolinite after the calcination treatment. Scanning electron microscopy was used as a method for characterization of morphology and elemental composition of the studied samples. A standard microdilution test was used to determine the antibacterial activity using four human pathogenic bacterial strains (Staphylococcus aureus, Escherichia coli, Enterococcus faecalis, Pseudomonas aeruginosa). A lamp with a wide spectrum bulb simulating daylight was used for induction of photocatalysis. The antibacterial assays found all the KATI samples to have antibacterial potency with different onset of the activity when calcined samples exhibited antibacterial activity earlier than the non-calcined. Significant difference in antibacterial activity of KATI samples for different bacterial strains was not observed.

Degradation of the pesticide carbofuran on clay and soil surfaces upon sunlight exposure.

In the present study, the photolysis of carbofuran has been undertaken under sunlight conditions and at the surface of model supports such as clay films and different soils collected from two different sites in Morocco (Tirs and Dahs). In all conditions, an efficient degradation occurred owing to direct light absorption and also to photoinduced processes involving either clays or natural organic matter moities. On kaolin films, the photodegradation kinetics appears to follow a first-order process that clearly depends on the film thickness. The diffusion of carbofuran from the lower part to the illuminated surface was found to be negligible when compared to the photolysis process within the range of 20-70 µm. Thus, the photolysis rate constant at the surface of the solid support, k (0), was evaluated to be 7.0 × 10(-3) min(-1). Under these experimental conditions, the quantum yield was found equal to 2.1 × 10(-4). On soil surfaces, the disappearance rate constant was mainly attributed to photoinduced processes arising from natural organic matter. From the analytical point of view, the products were formed through (1) hydroxylation on the aromatic ring, (2) homolytic scission of the carbamate C-O bond leading to radical species formation, and (3) photohydrolysis of the carbamate C-O bond.

The radiolysis and radioracemization of amino acids on clays.

L-Leucine and its hydrochloride salt have been deposited on the clay minerals kaolin and bentonite, and the amino acid/clay preparations have been irradiated in a 3000 Ci60Co gamma-ray source for radiation dosages that achieved 2-89% radiolysis of the leucine. The undecomposed leucine was thereupon recovered and both percent radiolysis and percent radioracemization were determined. Similar studies were made using solid L-leucine and its hydrochloride, and L-leucine in 0.1 M aqueous solution. It has been found that radiolysis and radio-racemization in these and the previously studied leucine systems follow pseudo-first-order rate laws, and the corresponding specific rate constants are evaluated and compared. Leucine and its hydrochloride salt proved to be the most stable to both radiolysis and radioracemization, followed by leucine and its HCl salt on kaolin, followed by leucine and its HCl salt on bentonite, with leucine (and its HCl and Na salts) in aqueous solution being least stable to both radiolysis and (except for the HCl salt) radioracemization. Implications of these observations as regards the Vester-Ulbricht mechanism for the origin of optical activity are discussed.