Model-based comparison of two ways to enhance WWTP capacity under stormwater conditions.

Two different approaches to increase the fraction of combined water treated in the wastewater treatment plant (WWTP) which would otherwise contribute to combined sewer overflows (CSO) are presented and compared based on modelling results with regard to their efficiencies during various rain events. The first option is to generally increase the WWTP inflow according to its actual capacity rather than pre-setting a maximum that applies to worst case loading. In the second option the WWTP inflow is also increased, however, the extra inflow of combined water is bypassing the activated sludge tank and directly discharged to the secondary clarifier. Both approaches have their advantages. For the simulated time series with various rain events, the reduction of total COD load from CSOs and WWTP effluent discharged to the receiving water was up to 20% for both approaches. The total ammonia load reduction was between 6% for the bypass and 11% for inflow increase. A combination of both approaches minimises the adverse effects and the overall emission to the receiving water.

Modelling of enhanced CSO treatment in secondary clarifiers with a modified Activated Sludge Model no. 3.

An alternative approach for combined water treatment as opposed to its CSO discharge into receiving water is its bypass to the inlet of secondary clarifiers (SC). To analyse the processes and to evaluate the performance of this approach, experiments and numerical modelling were carried out. In batch and pilot scale experiments major effects were identified and quantified. The Activated Sludge Model No. 3 (ASM3) was modified to simulate the batch and pilot scale experiments for implementation of the bypass-specific processes and thus to set up an overall balance of the relevant compounds. With some modifications of ASM3, good agreement of the modelling results with measurements of COD, nitrogen and phosphorus were achieved.

Generation of diurnal variation for influent data for dynamic simulation.

When using dynamic simulation for fine tuning of the design of activated sludge (AS) plants diurnal variations of influent data are required. For this application usually only data from the design process and no measured data are available. In this paper a simple method to generate diurnal variations of wastewater flow and concentrations is described. The aim is to generate realistic influent data in terms of flow, concentrations and TKN/COD ratios and not to predict the influent of the AS plant in detail. The work has been prepared within the framework of HSG-Sim (Hochschulgruppe Simulation, http://www.hsgsim.org), a group of researchers from Germany, Austria, Luxembourg, Poland, the Netherlands and Switzerland.

Identification of overall degradation in sewer systems from long-term measurements and consequences for WWTP simulations.

In-sewer transformation processes affect significantly design and operation of large wastewater treatment plants. Especially for long-term simulations the degradation has to be considered in order to avoid over- and underestimation. In this paper a method is presented to derive the overall degradation from available operation data. The application of the results in a long-term simulation of a WWTP shows the relevance of the degradation for design and operation of an activated sludge plant.

A guideline for simulation studies of wastewater treatment plants.

A guideline for simulation studies of wastewater treatment plants is proposed. The aim of the HSG-guideline is to define a reference quality level that helps to make the results of simulation studies comprehensible and comparable and therefore increases the quality and reliability of mathematical modelling in wastewater treatment. The paper gives a summary of the HSG-guideline, written by a group of university members from Germany, Austria and Switzerland.