Two New Steroidal Saponins with Potential Anti-Inflammatory Effects from the Aerial Parts of Gnetum formosum Markgr.

Gnetum formosum Markgr., a member of the Gnetaceae family, is distributed in Vietnam. This plant remains a botanical enigma with an unexplored diversity of chemical constituents and pharmacological effects. In this study, two new steroidal saponins, namely gnetumosides A (1) and B (2), were isolated from the aerial parts of G. formosum. Their chemical structures were elucidated using spectroscopic techniques, including high-resolution electrospray ionization mass spectrometry (HR-ESI-MS) and NMR, along with chemical hydrolysis and comparison with the reported literature. The potential anti-inflammatory effects of the isolated compounds were evaluated by measuring lipopolysaccharide-stimulated nitric oxide (NO) production in murine macrophage cells. Notably, compound 1 exhibited the most potent inhibitory activity (IC50 = 14.10 ± 0.75 µM), comparable to dexamethasone. Additionally, the mechanisms underlying the observed anti-inflammatory effects were investigated through molecular docking and molecular dynamics simulations on inducible nitric oxide synthase (iNOS) and cyclooxygenase-2 (COX-2) proteins. This study is the first to investigate the chemical constituents and pharmacological effects of G. formosum.

Removal of PFAS by hydrotalcite: Adsorption mechanisms, effect of adsorbent aging, and thermal regeneration.

Layered double hydroxides (LDH) have been shown to be effective adsorbents, but their utility for the treatment of per- and polyfluoroalkyl substances (PFAS) in water has not been fully explored. In this study, the adsorption of 9 PFAS on hydrotalcite (HT), a type of LDH, was investigated using reaction solutions with environmentally relevant PFAS concentrations. The adsorption of individual PFAS by HT depended upon a range of factors, including the temperature used to pre-treat (i.e., calcine) the HT, aging conditions, and the presence of anions in the solution. HT calcined near 400 °C most effectively adsorbed PFAS, but its ability to adsorb PFAS was sensitive to storage conditions. The adsorption of CO2 and moisture from air, which likely resulted in the re-intercalation of CO32- into the interlayer regions of HT, was observed to reduce PFAS adsorption and may explain performance loss over time. The adsorption trend among 9 PFAS and the influence on this process by Cl-, NO3-, SO42-, and CO32- indicated that adsorption occurred via a combination of ion exchange, electrostatic attraction, and hydrophobic interactions, although the relative importance of each mechanism deserves further investigation. During this study, we also demonstrated for the first time that HT can be thermally regenerated at 400 °C without affecting its ability to adsorb PFOS and PFBA. Overall, our results suggest that HT may serve as an effective alternative for PFAS treatment.

A Comprehensive Evaluation of Dioxins and Furans Occurrence in River Sediments from a Secondary Steel Recycling Craft Village in Northern Vietnam.

This first study investigated the presence of dioxins and furans in river sediments around a craft village in Vietnam, focusing on Secondary Steel Recycling. Sediment samples were collected from various locations along the riverbed near the Da Hoi Secondary Steel Recycling village in Bac Ninh province. The analysis was conducted using a HRGC/HRMS-DFS device, detecting a total of 17 dioxin/furan isomers in all samples, with an average total concentration of 288.86 ng/kg d.w. The concentrations of dioxin/furan congeners showed minimal variation among sediment samples, ranging from 253.9 to 344.2 ng/kg d.w. The predominant compounds in the dioxin group were OCDD, while in the furan group, they were 1,2,3,4,6,7,8-HpCDF and OCDF. The chlorine content in the molecule appeared to be closely related to the concentration of dioxins and their percentage distribution. However, the levels of furan isomers did not vary significantly. The distribution of these compounds was not dependent on the flow direction, as they were mainly found in solid waste and are not water-soluble. Although the hepta and octa congeners had high concentrations, when converted to TEQ values, the tetra and penta groups (for dioxins) and the penta and hexa groups (for furans) contributed more to toxicity. Furthermore, the source of dioxins in sediments at Da Hoi does not only originate from steel recycling production activities but also from other combustion sites. The average total toxicity was 10.92 ng TEQ/kg d.w, ranging from 4.99 to 17.88 ng TEQ/kg d.w, which did not exceed the threshold specified in QCVN 43:2017/BTNMT, the National Technical Regulation on Sediment Quality. Nonetheless, these levels are still concerning. The presence of these toxic substances not only impacts aquatic organisms in the sampled water environment but also poses potential health risks to residents living nearby.

Assessment of arsenic contamination of milk and dairy products / Evaluación de la contaminación por arsénico de la leche y productos lácteos

ABSTRACTS Introduction: Milk and dairy products are nutritious and can play a significant role in a healthy diet. The safety of milk decreases with increasing concentration of arsenic. The Maximum Residue Limits of arsenic is 500 parts per billion (ppb). Objectives: To evaluate the status of arsenic contamination of milk and dairy products produced and processed in some provinces and cities of Vietnam. Methods: A total of 367 samples were tested. Samples were digested before analysis to remove organic compounds, and the total arsenic content determined by atomic absorption spectrophotometry. Results: The average concentrations of total arsenic in liquid milk were 139.32 ppb; in yogurt, 169.81 ppb; in cheese, 221.38 ppb; in milk cake, 232.80 ppb; and in milk powder, 35.43 ppb, respectively. Conclusion: The arsenic concentrations in some samples are higher than the maximum permitted levels according to national regulations.

RESUMEN Introducción: La leche y los productos lácteos son nutritivos y pueden desempeñar un papel importante en una dieta saludable. La seguridad de la leche disminuye con el aumento de la concentración de arsénico. Los límites máximos de residuos de arsénico son 500 ppb. Objetivos: Evaluar el estado de contaminación por arsénico de la leche y los productos lácteos producidos y procesados ​​en algunas provincias y ciudades de Vietnam. Métodos: Se analizaron un total de 367 muestras. Las muestras se digirieron antes del análisis, para eliminar los compuestos orgánicos y se determinó el contenido total de arsénico mediante espectrofotometría de absorción atómica. Resultados: Las concentraciones promedio de arsénico total en la leche líquida fueron 139,32 ppb; en el yogur, 169,81 ppb; en el queso, 221,38 ppb; en el pastel de leche, 232,80 ppb; y en la leche en polvo, 35,43 ppb, respectivamente. Conclusión: Las concentraciones de arsénico en algunas muestras superan los niveles máximos permitidos según la normativa nacional.