ABSTRACT
Resonant excited state absorption (ESA) and relaxation processes in Tb(3+)-doped aluminosilicate glasses are quantitatively evaluated. A model describing the excitation steps and upconversion emission is developed and applied to interpret the results from laser-induced surface deformation using thermal mirror spectroscopy. The fluorescence quantum efficiency of level (5)D(4) was found to be close to unity and concentration independent while, for the level (5)D(3), it decreases with Tb(3+) concentration. Emission spectroscopy measurements supported these results. ESA cross sections are found to be more than three orders of magnitude higher than the ground state absorption cross section.
Subject(s)
Aluminum Silicates/chemistry , Calcium/chemistry , Lenses , Microscopy, Fluorescence/instrumentation , Surface Plasmon Resonance/methods , Terbium/chemistry , Thermography/instrumentation , Absorption , Equipment Design , Equipment Failure Analysis , Glass/chemistry , Light , Materials Testing/instrumentation , Scattering, RadiationABSTRACT
In this work, an in-house made Loschmidt diffusion cell is used to measure the effective O(2)-N(2) diffusion coefficients through four porous samples of different simple pore structures. One-dimensional through-plane mass diffusion theory is applied to process the experimental data. It is found that both bulk diffusion coefficient and the effective gas diffusion coefficients of the samples can then be precisely determined, and the measured bulk one is in good agreement with the literature value. Numerical computation of three-dimensional mass diffusion through the samples is performed to calculate the effective gas diffusion coefficients. The comparison between the measured and calculated coefficient values shows that if the gas diffusion through a sample is dominated by one-dimensional diffusion, which is determined by the pore structure of the sample, these two values are consistent, and the sample can be used as a standard sample to test a gas diffusion measurement system.