ABSTRACT
Aim: The aim of this study was to compare the effect of two calcium silicate-based and an epoxy resin-based root canal sealers on postoperative pain and analgesic intake following single-visit root canal treatment. Materials and Method: Ninety patients with at least one first or second molar tooth diagnosed as symptomatic irreversible pulpitis and symptomatic apical periodontitis were selected and allocated into three groups (n=30) according to the sealer used. Root canals were prepared using Protaper Gold instruments (Dentsply Sirona) in a crown down technique and irrigated with 2.5% NaOCl (Calyx, India) and saline solution. Root canal filling was then accomplished with a single cone obturation technique and treated in a single visit by the same endodontist. Patients were told to use a Visual Analog Scale (VAS) to rate their postoperative pain severity as none, minimal, moderate, or severe after 6 h, 24 h, 48 h, 5 days and 7 days following obturation using the appropriate sealers. The need for analgesic intake was also recorded. The data were statistically analyzed. Results: Results showed a significant difference among the studied groups. Bio-C Sealer Ion+ reported the least pain score followed by Nishika Canal Sealer BG and AH plus sealer at all the time intervals recorded. The intergroup analysis, revealed was a significant difference in postoperative pain at 6 h (p=0.000) and 24 h (p = 0.028), but not at 48 h, 5 day or 7 days (P > 0.05). VAS ratings for all the three groups decreased over time. Also, there were significant differences between the means of analgesic intake among 3 groups (p=0.022). Analgesic intake in group BIO-C Sealer Ion+ is significantly lesser than AH Plus and Nishika Canal Sealer BG group. Conclusion: Calcium silicate-based sealer (Nishika Canal Sealer BG and Bio-C Sealer Ion+) resulted in significantly lower levels of pain as compared to epoxy resin-based sealer (AH Plus) at 6h and 24-h interval, there was no significant difference in postoperative pain occurrence at 48-h, 5 day and 7-day period. The analgesic intake in Bio-C Sealer Ion+ group is significantly lesser than Nishika Canal Sealer BG and AH Plus group.
ABSTRACT
Introduction: Root resorption poses a significant challenge in dental practice, with external cervical resorption (ECR) being a common manifestation. ECR is often asymptomatic until advanced stages, complicating its diagnosis and management. Various factors contribute to its etiology, ranging from trauma to orthodontic treatment. The classification system proposed by Patel et al. (2018) offers a comprehensive framework for characterizing ECR lesions based on location and extent. Treatment strategies for ECR involve a combination of endodontic intervention and restorative techniques, with bioactive materials like mineral trioxide aggregate (MTA) and Biodentine emerging as promising options. However, the biomechanical behavior of teeth restored with these materials in the context of ECR remains underexplored. Materials and methods: This study utilized finite element analysis (FEA) to assess stress distribution in teeth with simulated ECR lesions of varying sizes and locations, restored with MTA or Biodentine. Three-dimensional models of maxillary central incisors were generated based on CBCT scans, incorporating periodontal ligament and surrounding bone structures. Eight experimental models representing different ECR configurations were created and subjected to FEA using Optistruct software based on dimensional classification given by Patel et al., in 2018, A70 M & A70B: 1Ap, A130 M & A130B: 1Bp, B70 M & B70B: 2Ap, B130 M & B130B: 2Bp. All the models were tested for stress distribution by restoring the lesions with either M: MTA or B: Biodentine. Oblique load of 100 N was applied at 45°angle to the long axis 2 mm lingual to incisal edge. vonMises Stress distribution in enamel, dentine, restoration and at all the interfaces were observed. Results: The analysis revealed that both MTA and Biodentine restorations exhibited uniform stress distribution around ECR lesions, with no significant differences based on lesion location or size. Maximum stress concentrations were observed around the restorations, particularly in subcrestal lesions. However, overall stress levels were comparable between MTA and Biodentine restorations, indicating similar biomechanical performance. Conclusion: Finite element analysis provides valuable insights into the biomechanical behavior of teeth with ECR lesions restored with MTA and Biodentine. Both materials exhibit similar stress distribution patterns and offer adequate reinforcement against mechanical forces. Clinicians can confidently utilize MTA or Biodentine in the management of ECR, considering their favorable biomechanical properties and clinical outcomes. Further research is necessary to validate these findings and optimize treatment protocols for ECR.
ABSTRACT
Objective: The escalating prevalence of noncarious tooth wear stands as a critical concern in the backdrop of evolving lifestyles and dietary patterns. Dental erosion, a progressive condition induced by both endogenous and exogenous acidic influences, directly impacts enamel integrity, resulting in surface loss. The contemporary surge in carbonated beverage consumption further exacerbates this erosive milieu, underscoring the urgency for dental practitioners to adopt meticulous treatment strategies. Existing literature underscores a noteworthy 94% reduction in tooth erosion risk for individuals abstaining from sweetened soft beverages, emphasizing the imperative for a well-devised remineralization protocol to counter demineralized surfaces. Methodology: Seventy-three enamel specimens were taken. Forty samples were subjected to pre-operative hardness testing, and five samples were subjected to baseline EDX evaluation followed by grouping of samples (Group 1 = control Group; Group 2 = casein phosphopeptide-amorphous calcium phosphate fluoride [CPP-ACPF] Group; Group 3 = Biomin F Group; and Group 4 = self-assembling peptide [SAP] P-114 Group). A demineralization-remineralization cycle was carried out for 5 days followed by testing through Vickers Microhardness Tester, EDX Evaluation, and Scanning Electron Microscopy (SEM) Imaging. Statistical analysis was performed using one-way analysis of variance followed by intergroup analysis using Tukey's post hoc test with SPSS software 25.0 version. Results: The mean percentage change in microhardness values was 30.05% in Group 1, 24.21% in Group 2, 18.85% in Group 3, and 12.08% in Group 4. The mean Ca/P ratio of samples tested through EDAX was 2.20 at baseline, 1.40 in Group 1 (Control Group), 1.62 in Group 2 (CPP-ACPF), 1.82 in Group 3 (Biomin F), and 2.01 in Group 4 (SAP-P114). Postintervention values were statistically significant from baseline values in both parameters. Conclusion: Curodont Protect exhibits superior efficacy, offering valuable insights for future in vivo studies and clinical applications. The multifaceted evaluation, encompassing microhardness testing, SEM analysis, and EDXS assessment, contributes to a nuanced interpretation of the agents' impact, paving the way for informed decisions in clinical practice and future research endeavors.
ABSTRACT
Objective: The study aimed to compare and evaluate the effect of biodentine (BD) alone, BD along with Lyophilised freeze dried platelet rich concentrate (LPC + BD), and BD along with low-level laser therapy (BD + LLLT) after pulpotomy in mature permanent molars with irreversible pulpitis. Materials and Methods: The study was designed as a randomized, pragmatic, parallel, double-blinded clinical trial registered under the Clinical Trial Registry-India (CTRI/2020/02/023245). 120 permanent molars fulfilling the inclusion and exclusion criteria with symptoms of irreversible pulpitis were randomized after performing pulpotomy into three pulp capping groups: Group 1, BD; Group 2, lyophilized freeze-dried platelet-rich concentrate + BD (LPC + BD); and Group 3, Low level laser therapy + BD Group 3, LLLT + BD. The intergroup comparison was done using one-way analysis of variance followed by the Bonferroni test. The level of significance and confidence interval were 5% and 95%, respectively. Interobserver reliability was measured using Cohen's kappa analysis. Results: At 1 week, there was a significant difference (P < 0.005) observed in the mean postoperative pain levels between the three groups with Group 1 (BD) exhibiting the highest postoperative pain followed by Group 2 (LPC + BD) and least pain was exhibited by Group 3 (LLLT + BD). A similar pattern was observed regarding the analgesic intake with maximum frequency in Group 1 (BD) and least with Group 3 (LLLT + BD). No significant difference in success rates was reported among the groups. Conclusion: Pulpotomy as a treatment option for mandibular molars with irreversible pulpitis has an acceptable clinical success rate; however, long-term overall success rate remains questionable. The outcomes of incorporating adjunctive modalities with BD are remarkable and show tremendous potential for continued development and research.
ABSTRACT
OBJECTIVE: To investigate the concentration of Matrix metalloproteinases-9 (MMP-9) and Tumor necroses fac- tor-alpha (TNF- α) in pulpal blood at various stages of pulpal inflammation in diabetics and to establish the relationship between these two biomarkers. METHODS: 77 patients, each having a tooth with pulpal exposure due to caries presenting with distinct stages of pulpitis were grouped into 2 main study groups as based on the HbA1c Levels-Group 1: Non-Diabetics (Control Group) (HbA1c < 5.6%) and Group 2: Type 2 Diabetics (Experimental Group) (HbA1c>6.5%; Random Plasma Glucose > 200) and diabetes mellitus with less than 10-year history. Depending on the radiological and clinical diagnosis, these two groups were again sub-divided into 2 subgroups: Sub-group A: Tooth with Symptomatic Irreversible Pulpitis. Sub Group B: Tooth with Reversible Pulpitis. Thus, for comparison purposes, a total of 4 sub-divisions were formed: Sub-group 1A- Non-Diabetic, Symtomatic Irreversible Pulpitis, Sub- group 1B: Non-Diabetic, Reversible Pulpitis, Sub-group 2A: Diabetic, Symptomatic Irreversible Pulpitis, Sub- group 2B: Diabetic, Reversible Pulpitis. Blood sample was collected from pulp chamber after partial pulpo- tomy was done. The total levels of MMP-9 and TNF-α were assessed by enzyme linked immunosorbent assays (ELISA). Inter-group comparison in levels of MMP-9 and TNF- α were conducted using the Kruskal Wallis test and pairwise comparison was done Mann-Whitney U test. RESULTS: The inter-group comparison in levels of MMP-9 and TNF- α were conducted using the Kruskal Wallis test and pairwise comparison was done using Mann-Whitney U test. Pearson correlations were conducted in order to investigate correlations between the paired TNF-α and MMP-9 values and also their correlation with the blood sugar levels within the pulp diagnosis groups. MMP-9 and TNF-α levels were significantly higher (p<0.005) in irreversible pulpits than reversible pulpits and also in Type-2 diabetics than non-diabetics. High- est level of MMP-9 and TNF-α was found in Group 2A (Diabetic, symptomaticirreversible pulpitis) and lowest in Group 1B (Non-Diabetic, reversible pulpitis). There exists a very high significant positive correlation between MMP-9 and TNF-α (p<0.005). CONCLUSION: These findings show that the inflammatory mediators MMP-9 and TNF-α are significantly in- creased in pulpal blood samples of diabetic patients. Also, in diabetic patients diagnosed with reversible pul- pitis, higher levels of inflammatory pulpal biomarkers were reported that could compromise the success of Vital Pulp Therapy (VPT) and may necessitate endodontic intervention. MMP-9 and TNF- α were reported to have a positive correlation. (EEJ-2023-01-04).