Fire frequency effects on cleistogamy expression and progeny performance in Cologania broussonetii.

Increased fire frequency usually erodes microenvironmental conditions, causing a drastic limitation of edaphic resources. Thus, the production of permanently closed-small flowers (cleistogamous, CL) should increase in sites with high fire frequency as this implies a less expensive reproductive assurance strategy. However, because open, insect-pollinated flowers (chasmogamous, CH) have the potential capacity to outcross via pollinators, CH progeny produced at any site should outperform selfed CL progeny. We evaluate the effect of fire frequency on the relative production of CL/CH flowers and fruits, and their seed set, along with several progeny performance parameters in Cologania broussonetii (Fabaceae), a resprouting herb with dimorphic cleistogamy native to the Chaco Serrano. Fire frequency increased cleistogamy expression, reaching extreme levels in high fire frequency sites. Seed set was similarly high for both CH and CL flowers in the unburned condition, while in burned sites the few developed CH flowers set more seeds than CL flowers. However, progeny performance was similar between CH and CL progeny at each and across all fire frequency conditions. Cleistogamy expression in C. broussonetii is maximized in abiotically degraded frequently burned habitats, although the selfed CL progeny is as successful as potentially outcrossed CH progeny. Fire frequency may decreased floral size and abundance, selecting for autogamous reproduction, which restricts not only the genetic potential of plant populations but also the resources offered to pollinators. At the community level, increased cleistogamy expression may potentially have negative implications for non-cleistogamous, more outcrossing species surviving in frequently burned environments.

Novel hydroxyapatite nanorods improve anti-caries efficacy of enamel infiltrants.

OBJECTIVES: Enamel resin infiltrants are biomaterials able to treat enamel caries at early stages. Nevertheless, they cannot prevent further demineralization of mineral-depleted enamel. Therefore, the aim of this work was to synthesize and incorporate specific hydroxyapatite nanoparticles (HAps) into the resin infiltrant to overcome this issue. METHODS: HAps were prepared using a hydrothermal method (0h, 2h and 5h). The crystallinity, crystallite size and morphology of the nanoparticles were characterized through XRD, FT-IR and TEM. HAps were then incorporated (10wt%) into a light-curing co-monomer resin blend (control) to create different resin-based enamel infiltrants (HAp-0h, HAp-2h and HAp-5h), whose degree of conversion (DC) was assessed by FT-IR. Enamel caries lesions were first artificially created in extracted human molars and infiltrated using the tested resin infiltrants. Specimens were submitted to pH-cycling to simulate recurrent caries. Knoop microhardness of resin-infiltrated underlying and surrounding enamel was analyzed before and after pH challenge. RESULTS: Whilst HAp-0h resulted amorphous, HAp-2h and HAp-5h presented nanorod morphology and higher crystallinity. Resin infiltration doped with HAp-2h and HAp-5h caused higher enamel resistance against demineralization compared to control HAp-free and HAp-0h infiltration. The inclusion of more crystalline HAp nanorods (HAp-2h and HAp-5h) increased significantly (p<0.05) the DC. SIGNIFICANCE: Incorporation of more crystalline HAp nanorods into enamel resin infiltrants may be a feasible method to improve the overall performance in the prevention of recurrent demineralization (e.g. caries lesion) in resin-infiltrated enamel.