ABSTRACT
The use of soft X-rays in electron probe microanalysis (EPMA) has gained renewed interest over the past decades due to the advent of new detector technologies. Because X-ray absorption is the dominant correction for soft X-rays, a reliable set of mass attenuation coefficients (MACs) is needed for accurate composition determination. Although several MAC tabulations cover the soft X-ray range, the accuracy of such tabulations below 1 keV is not firmly established. In this study, we assess the accuracy of MAC tabulations in the soft X-ray region by comparing tabulated values for Be, B, C, N, O, and F Kα X-rays with experimental data available in the literature. We find that the 1993 semi-empirical MAC compilation of Henke et al. [(1993). Low-energy X-ray interaction coefficients: Photoabsorption, scattering, transmission and reflection at E=50-30000 eV, Z=1-92. Atom Data Nucl Data Tables54, 181-342] and the more recent theoretical MAC calculations of Sabbatucci and Salvat [(2016). Theory and calculation of the atomic photoeffect. Rad Phys Chem121, 122-140] perform slightly better than the rest of the considered tabulations. The Sabbatucci-Salvat dataset also provides the best agreement with the few existing experimental measurements for Al L2,3M X-rays.
ABSTRACT
Electron microprobe-based quantitative compositional measurement of first-row transition metals using their L$\alpha$ X-ray lines is hampered by, among other effects, self-absorption. This effect, which occurs when a broad X-ray line is located close to a broad absorption edge, is not accounted for by matrix corrections. To assess the error due to neglecting self-absorption, we calculate the L$\alpha$ X-ray intensity emitted from metallic Fe, Ni, Cu, and Zn targets, assuming a Lorentzian profile for the X-ray line and taking into account the energy dependence of the mass absorption coefficient near the absorption edge. We find that calculated X-ray intensities depart increasingly, for increasing electron beam energy, from those obtained assuming a narrow X-ray line and a single fixed absorption coefficient (conventional approach), with a maximum deviation of $\sim$15% for Ni and of $\sim$10% for Fe. In contrast, X-ray intensities calculated for metallic Zn and Cu do not differ significantly from those obtained using the conventional approach. The implications of these results for the analysis of transition-metal compounds by electron probe microanalysis as well as strategies to account for self-absorption effects are discussed.
ABSTRACT
Although calcareous anatomical structures have evolved in diverse animal groups, such structures have been unknown in insects. Here, we report the discovery of high-magnesium calcite [CaMg(CO3)2] armor overlaying the exoskeletons of major workers of the leaf-cutter ant Acromyrmex echinatior. Live-rearing and in vitro synthesis experiments indicate that the biomineral layer accumulates rapidly as ant workers mature, that the layer is continuously distributed, covering nearly the entire integument, and that the ant epicuticle catalyzes biomineral nucleation and growth. In situ nanoindentation demonstrates that the biomineral layer significantly hardens the exoskeleton. Increased survival of ant workers with biomineralized exoskeletons during aggressive encounters with other ants and reduced infection by entomopathogenic fungi demonstrate the protective role of the biomineral layer. The discovery of biogenic high-magnesium calcite in the relatively well-studied leaf-cutting ants suggests that calcareous biominerals enriched in magnesium may be more common in metazoans than previously recognized.
Subject(s)
Animal Shells/chemistry , Ants/anatomy & histology , Animals , Calcium Carbonate , MagnesiumSubject(s)
Astrocytoma/diagnostic imaging , Cerebellar Nuclei , Contrast Media , Gadolinium , Globus Pallidus , Adolescent , Cerebellar Nuclei/diagnostic imaging , Cerebellar Nuclei/pathology , Female , Globus Pallidus/diagnostic imaging , Globus Pallidus/pathology , Humans , Magnetic Resonance Imaging/methodsABSTRACT
The performance of multi-collector secondary ion mass spectrometry (MC-SIMS) for Mg isotope ratio analysis was evaluated using 17 olivine and 5 pyroxene reference materials (RMs). The Mg isotope composition of these RMs was accurately and precisely determined by multi-collector inductively coupled plasma mass spectrometry (MC-ICP-MS), and these measured isotope ratios were used to evaluate SIMS instrumental mass bias as a function of the forsterite (Fo) content of olivine. The magnitude of the Mg isotope matrix effects were ~3 in δ25Mg, and are a complex function of olivine Fo content, that ranged from Fo59.3 to Fo100. In addition to these Mg isotope matrix effects, Si+ ion yields and Mg+/Si+ ion ratios varied as a complex function of the Fo content of the olivine RMs. For example, Si+ ion yields varied by ~33%. Based on the observations, we propose instrumental bias correction procedures for SIMS Mg isotope analysis of olivine using a combination of Mg+/Si+ ratios and Fo content of olivine. Using this correction method, the accuracy of δ25Mg analyses is 0.3, except for analysis of olivine with Fo86-88 where instrumental biases and Mg+/Si+ ratios change dramatically with Fo content, making it more difficult to assess the accuracy of Mg isotope ratio measurements by SIMS over this narrow range of Fo content. Five pyroxene RMs (3 orthopyroxenes and 2 clinopyroxenes) show smaller ranges of instrumental bias (~1.4 in δ25Mg) as compared to the olivine RMs. The instrumental bias for the 3 orthopyroxene RMs do not define a linear relationship with respect to enstatite (En) content, that ranged from En85.5 -96.3. The clinopyroxene RMs have similar En and wollastonite (Wo) contents but have δ25Mg values that differ by 0.5 relative to their δ25Mg values determined by MC-ICP-MS. These results indicate that additional factors (e.g., minor element abundances) likely contribute to SIMS instrumental mass fractionation. In order to better correct for these SIMS matrix effects, additional pyroxene RMs with various chemical compositions and known Mg isotope ratios are needed.
ABSTRACT
Sedimentological observations from the Paleoproterozoic Huronian Supergroup are suggested to mark the rise in atmospheric oxygen at that time, which is commonly known as the Great Oxidation Event (GOE) and typically coupled with a transition from mass-independent fractionation (MIF) to mass-dependent fractionation (MDF) of sulfur isotopes. An early in situ study of S three-isotopes across the Huronian Supergroup by Papineau et al. ( 2007 ) identified a weak MIF-MDF transition. However, the interpretation and stratigraphic placement of this transition is ambiguous. In this study, all four S isotopes were analyzed for the first time in two Huronian drill cores by secondary ion mass spectrometer (SIMS), and both Δ33S and Δ36S were calculated. Based on improved precision and detailed petrography, we reinterpret the dominance of pyrrhotite in the studied sections, which was previously proposed as "early authigenic" in origin, as resulting from regional metamorphism. Small but analytically resolvable nonzero values of Δ33S (from -0.07 to +0.38) and Δ36S (from -4.1 to +1.0) persist throughout the lower Huronian Supergroup. Neither pronounced MIF-S signals nor a MIF-MDF transition are seen in this study. Four scenarios are proposed for the genesis of small nonzero Δ33S and Δ36S values in the Huronian: homogenization by regional metamorphism, recycling from older pyrite, dilution by magmatic fluids, and the occurrence of MDF. We argue that the precise location of the MIF-MDF transition in the Huronian remains unsolved. This putative transition may have been erased by postdepositional processes in the lower Huronian Supergroup, or may be located in the upper Huronian Supergroup. Our study highlights the importance of integrated scanning electron microscopy and secondary ion mass spectrometry techniques in deep-time studies and suggests that different analytical methods (bulk vs. SIMS) and diagenetic history (primary vs. metamorphic) among different basins may have caused inconsistent interpretations of S isotope profiles of the GOE successions at a global scale. Key Words: Great Oxidation Event (GOE)-Secondary ion mass spectrometer (SIMS)-Paleoproterozoic-Sulfur isotopes-Mass independent fractionation (MIF). Astrobiology 18, 519-538.
Subject(s)
Geologic Sediments/analysis , Spectrometry, Mass, Secondary Ion , Sulfur Isotopes/analysis , Chemical Fractionation/methods , Geologic Sediments/chemistry , North America , Oxidation-ReductionABSTRACT
Tephra geochemistry and (40)Ar/(39)Ar geochronology are reported for the Waki-Mille area in the northwestern part of the Woranso-Mille paleoanthropological project area in the west central Afar region of Ethiopia. Previous studies documented dentognathic fossils that are morphologically intermediate between Australopithecus anamensis and Australopithecus afarensis and some that are attributed to Australopithecus afarensis. Additional dentognathic remains from the study area were assigned to the newly identified species Australopithecus deyiremeda. These fossil hominin taxa were recovered from volcanic and sedimentary strata containing tuffs ranging in age from more than 3.77 million years ago (Ma) to less than 3.469 Ma. One of the tuffs was correlated based on geochemistry, feldspar mineralogy, and age to the Lokochot Tuff of the Omo-Turkana Basin of southern Ethiopia and Kenya. Variations in major and minor element abundances in volcanic glass demarcate ten geochemically distinct tuffs and tuff sequences, including three that are geochemically similar to widespread regional tuffs, specifically the Lomogol, Lokochot, and ß- Tulu Bor/Sidi Hakoma tuffs. A new (40)Ar/(39)Ar age for the Waki Tuff, which is geochemically similar to the Lomogol Tuff, is 3.664 ± 0.016 Ma. Other tuffs in the Waki-Mille area are geochemically dissimilar to regional tuffs documented to date. Identification of tuffs based on character, stratigraphic position, and geochemistry refines local stratigraphic correlations and delineates the geographic distributions of precisely dated fossiliferous levels within the Waki-Mille area.
Subject(s)
Fossils , Hominidae/anatomy & histology , Hominidae/classification , Animals , Argon/chemistry , Ethiopia , Geologic Sediments/chemistry , Hominidae/physiology , Radiometric Dating/methods , Volcanic EruptionsABSTRACT
Bioremediation strategies that depend on bacterial sulfate reduction for heavy metals remediation harness the reactivity of these metals with biogenic aqueous sulfide. Quantitative knowledge of the degree to which specific toxic metals are partitioned into various sulfide, oxide, or other phases is important for predicting the long-term mobility of these metals under environmental conditions. Here we report the quantitative partitioning into sedimentary biogenic sulfides of a suite of metals and metalloids associated with acid mine drainage contamination of a natural estuarine wetland for over a century.
ABSTRACT
We report the effects of two pseudowollastonite (beta-CaSiO(3)) substrates on the attachment, viability, proliferation and osteogenic differentiation of human mesenchymal stem cells (hMSCs), and provide detailed mechanistic links of surface texture, soluble factors and culture media to cell activities. Cell attachment and viability were lower for psWf (fine-grained, roughness 0.74 microm) than for psWc (coarse-grained, roughness 1.25 microm) surface, and were ascribed to the greater specific area of the finer psWf particles resulting in higher release rate of Si, which is cytotoxic at high levels. Interestingly, proliferation was greater on psWf. Osteogenic differentiation occurred on both surfaces, indicated by calcium phosphate bone nodule formation and by osteocalcin, osteopontin and core-binding factor alpha-1 gene expression. Gene levels were lower on psWf than on psWc at day 8 in growth medium, explained by differences in Ca and/or Si concentrations between the two surfaces. Similar gene expression on both surfaces at day 16 in both growth and osteogenic induction media was attributed to pro-osteogenic effects of Ca and P at specific concentrations and complementary Ca and P levels on the two surfaces. In summary, soluble factors from substrates may be more important for osteogenic differentiation in growth medium than small surface roughness variations within a factor of 2. Optimum concentration ranges exist for individual soluble factors to balance cell toxicity/growth versus osteogenic differentiation, and soluble factors together have complex, cooperative or opposing, effects on a given cell activity.