ABSTRACT
Knowledge of vertical motion patterns of the axial body segments is a prerequisite for the development of algorithms used in automated detection of lameness. To date, the focus has been on the trot. This study investigates the temporal synchronization between vertical motion of the axial body segments with limb kinematic events in walk and trot across three popular types of sport horses (19 Warmbloods, 23 Iberians, 26 Icelandics) that are known to have different stride kinematics, and it presents novel data describing vertical motion of the axial body segments in tölting and pacing Icelandic horses. Inertial measurement unit sensors recorded limb kinematics, vertical motion of the axial body at all symmetrical gaits that the horse could perform (walk, trot, tölt, pace). Limb kinematics, vertical range of motion and lowest/highest positions of the head, withers and pelvis were calculated. For all gaits except walk and pace, lowest/highest positions of the pelvis and withers were found to be closely related temporally to midstance and start of suspension of the hind/fore quarter, respectively. There were differences in pelvic/withers range of motion between all breeds where the Icelandic horses showed the smallest motion, which may explain why lameness evaluation in this breed is challenging.
ABSTRACT
OBJECTIVE: To evaluate the ability of novel legwear designed to limit extension of the metacarpophalangeal joint (MCPJ) to redirect loading forces from the flexor apparatus during walk, trot, and canter on a treadmill and during unrestrained and restrained activity in a stall. ANIMALS: 6 adult horses without musculoskeletal disease. PROCEDURES: Legwear-derived force data were recorded under 4 conditions: inactive state (unlimited legwear extension) and 3 active (restrictive) states (mild, 30° extension; moderate, 20° extension; or maximum, 10° extension). Associations between peak legwear loads and torques among legwear states and treadmill gaits and stall activities were assessed. The hair coat and skin of the forelimbs were examined for any legwear-induced adverse effects after testing. RESULTS: During the treadmill exercises, moderate restriction of legwear extension resulted in significantly higher peak load and torque than mild restriction, and faster speeds (canter vs walk or trot and trot vs walk) yielded significantly higher peak load and torque. During in-stall activity, maximum restriction of legwear extension yielded significantly higher peak load and torque than moderate restriction. Unrestrained in-stall activity resulted in significantly higher peak load and torque than restrained activity. The legwear caused minimal adverse effects on the hair coat and skin of the forelimbs. CONCLUSIONS AND CLINICAL RELEVANCE: Findings suggested that the legwear variably reduced peak loads on the flexor apparatus. Extension of the MCPJ may be incrementally adjusted through the legwear such that return to activity may be controlled, and controlled return to activity is crucial for rehabilitating flexor apparatus injuries.
Subject(s)
Forelimb , Gait , Animals , Biomechanical Phenomena , Horses , Metacarpophalangeal Joint , WalkingABSTRACT
OBJECTIVE: To investigate the effects of novel legwear designed to limit metacarpophalangeal joint (MCPJ) extension and redirect loading forces from the flexor apparatus through analyses of 2-D kinematic and kinetic data. ANIMALS: 6 adult horses without musculoskeletal disease. PROCEDURES: Horses were subjected to 4 treatments: control (no legwear), inactive legwear (unlimited legwear extension), and active legwear with mild (30°) and moderate (20°) legwear extension limitation. Two-dimensional kinematic data were collected for the right forelimb (FL) during walk and trot and from leading and trailing FLs during canter on a treadmill. Ground reaction force (GRF) data were collected from FLs during overground walk and trot. Peak MCPJ angle and angular velocity were calculated from kinematic data, and peak force and average loading rate were calculated from vertical GRF data during the stance phase of the gait. Interactions between gait and treatment were determined via ANOVA. RESULTS: Interactions between gait and treatment for peak MCPJ angle were significant. Significant reductions in MCPJ angle were noted between the control treatment and legwear with moderate extension limitation for trot and canter (leading and trailing FL) and between inactive legwear and legwear with moderate extension limitation for trot and leading FL during canter. Interactions among peak MCPJ angular velocity, peak vertical GRF, and average loading rate of the vertical GRF showed nonsignificance. CONCLUSIONS AND CLINICAL RELEVANCE: Significant reductions in MCPJ extension without significant alterations to peak vertical GRF suggested the legwear's ability to redistribute internal forces. Findings suggested that the legwear may be beneficial for horses rehabilitating from flexor apparatus injuries.
Subject(s)
Gait , Walking , Animals , Biomechanical Phenomena , Exercise Test/veterinary , Forelimb , Horses , Metacarpophalangeal JointABSTRACT
In running analyses where both kinetic and kinematic information is recorded, participants are required to make foot contact with a force and/or pressure measuring transducer. Problems arise if participants modify their gait patterns to ensure contact with the device. There is currently a paucity of research investigating the influence of different underfoot kinetic measuring devices on 3-dimensional kinematics of running. Fifteen participants ran at 4.0 m/s in four different conditions: over a floor embedded force plate, Footscan, Matscan, and with no device. Three-dimensional angular kinematic parameters were collected using an eight camera motion analysis system. Hip, knee, and ankle joint kinematics were contrasted using repeated-measures ANOVAs. Participants also rated their subjective comfort in striking each of the three force measuring devices. Significant differences from the uninhibited condition were observed using the Footscan and Matscan in all three planes of rotation, whereas participants subjectively rated the force plate significantly more comfortable than either the Footscan/Matscan devices. The findings of the current investigation therefore suggest that the disguised floor embedded force plate offers the most natural running condition. It is recommended that analyses using devices such as the Footscan/Matscan mats overlying the laboratory surface during running should be interpreted with caution.
Subject(s)
Adaptation, Physiological/physiology , Artifacts , Leg/physiology , Monitoring, Ambulatory/instrumentation , Range of Motion, Articular/physiology , Running/physiology , Transducers, Pressure , Adult , Equipment Design , Equipment Failure Analysis , Foot/physiology , Humans , Male , Reproducibility of Results , Sensitivity and Specificity , Stress, MechanicalABSTRACT
A link between surface characteristics and injury has been identified in equine disciplines. Maintenance procedures are reported to affect surface characteristics and could influence horse movement. The study investigated limb and hoof movement on a synthetic surface following two different preparations (harrowing and rolling). Nine horses were recorded using infrared cameras and retro-reflective markers at walk, trot and canter on two surface preparations in a cross-over design. Hoof rotation and displacement, metacarpophalangeal joint (MCPJ) extension and third metacarpal (McIII) inclination (roll, pitch and yaw) were analysed using a general linear model. Surface hardness and traction were also measured. No differences in hoof rotations or hoof displacements were found between preparations. However, following harrowing, greater (P<0.05) MCPJ extension at mid-stance and greater (P<0.05) McIII adduction at impact was found when gait was grouped. Hardness and traction were statistically similar for both preparations. Alteration to the surface cushion appears to be sufficient to produce subtle changes in stride characteristics.
Subject(s)
Hoof and Claw/physiology , Horses/physiology , Metacarpophalangeal Joint/physiology , Motor Activity/physiology , Animals , Biomechanical Phenomena , Forelimb , Gait/physiologyABSTRACT
The treadmill is an attractive device for the investigation of human locomotion, yet the extent to which lower limb kinematics differ from overground running remains a controversial topic. This study aimed to provide an extensive three-dimensional kinematic comparison of the lower extremities during overground and treadmill running. Twelve participants ran at 4.0 m/s (+/- 5%) in both treadmill and overground conditions. Angular kinematic parameters of the lower extremities during the stance phase were collected at 250 Hz using an eight-camera motion analysis system. Hip, knee, and ankle joint kinematics were quantified in the sagittal, coronal, and transverse planes, and contrasted using paired t-tests. Of the analysed parameters hip flexion at footstrike and ankle excursion to peak angle were found to be significantly reduced during treadmill running by 12 degrees (p = 0.001) and 6.6 degrees (p = 0.010), respectively. Treadmill running was found to be associated with significantly greater peak ankle eversion (by 6.3 degrees, p = 0.006). It was concluded that the mechanics of treadmill running cannot be generalized to overground running.
Subject(s)
Gait/physiology , Joints/physiology , Running/physiology , Adolescent , Adult , Ankle Joint/physiology , Biomechanical Phenomena , Female , Hip Joint/physiology , Humans , Imaging, Three-Dimensional , Knee Joint/physiology , Male , Young AdultABSTRACT
The aims of this study were to measure ground reaction forces (GRFs) of concurrently loaded limbs and to evaluate spatial relationships between the centre of pressure (COP) and centre of mass (COM) in trotting horses. Kinematic (120Hz) and GRF data were collected at trot from three trials of eight horses using four force plates (960 Hz). Forelimb and hind limb GRFs were measured, COP was calculated from the resultant vertical GRF vector and COM was calculated by summation of weighted segmental COMs. Peak total vertical force (19.3 ± 1.3N/kg at 45.1 ± 2.3% diagonal stance) coincided with zero total longitudinal force (45.1 ± 2.4% stance). Initially, COP position corresponded with the fore or hind hoof of the diagonal that contacted the ground earlier. During diagonal overlap, COP position reflected forelimb contribution to total vertical GRF; it maintained a fairly constant position relative to the base of support through the middle part of stance, then moved cranially in the last third of stance towards the fore hoof, which was always the last hoof to leave the ground. The COM moved forward continuously; its longitudinal velocity decreased with the net braking force in early stance and increased with the net propulsive force in late stance. The COM was caudal to the COP in early stance, coincident at 35.8 ± 4.4% stance and was maximally ahead of the COP at 67.6 ± 4.8% stance. Changes in the spatial relationship between COP and COM affect the moment arms of the forelimb and hind limb vertical GRFs and their effect in generating a pitching torque around the COM.
Subject(s)
Gait/physiology , Horses/physiology , Motor Activity/physiology , Weight-Bearing/physiology , Animals , Biomechanical Phenomena , Female , MaleABSTRACT
Biomechanical analysis requires the determination of specific foot contact events. This is typically achieved using force platform information; however, when force platforms are unavailable, alternative methods are necessary. A method was developed for the determination of gait events using an accelerometer mounted to the distal tibia, measuring axial accelerations. The aim of the investigation was to determine the efficacy of this method. Sixteen participants ran at 4.0 m/s ± 5%. Synchronized tibial accelerations and vertical ground reaction forces were sampled at 1000 Hz as participants struck a force platform with their dominant foot. Events determined using the accelerometer, were compared with the corresponding events determined using the force platform. Mean errors of 1.68 and 5.46 ms for average and absolute errors were observed for heel strike and of -3.59 and 5.00 ms for toe-off. Mean and absolute errors of 5.18 and 11.47 ms were also found for the duration of the stance phase. Strong correlations (r = .96) were also observed between duration of stance obtained using the two different methods. The error values compare favorably to other alternative methods of predicting gait events. This suggests that shank-mounted accelerometers can be used to accurately and reliably detect gait events.
Subject(s)
Acceleration , Foot/physiology , Gait/physiology , Locomotion/physiology , Monitoring, Ambulatory/instrumentation , Adult , Equipment Design , Equipment Failure Analysis , Female , Humans , Male , Reproducibility of Results , Sensitivity and SpecificityABSTRACT
OBJECTIVE: To develop and evaluate a marker cluster set for measuring sagittal and extrasagittal movement of joints in the distal portion of the forelimb in ponies. ANIMALS: 4 ponies. PROCEDURES: 5 infrared cameras were positioned on a concrete walkway in a frontal-sagittal arc and calibrated. Four segments were defined: hoof, middle phalanx, proximal phalanx, and metacarpus. Rigid clusters with 4 retroreflective markers were placed on each segment. A static trial was recorded with additional anatomic markers on the medial and lateral joint lines. Those anatomic markers were removed, and kinematic data were recorded at 240 Hz during walking. An ensemble mean was computed from the 4 ponies from 5 replicates of the walks. Joint kinematic variables were calculated by use of the calibrated anatomical system technique. The design and error dispersion of each marker were evaluated. RESULTS: Marker clusters were quasiplanar, but variation in orientation error was reduced because the mean radii were > 10 times the largest error dispersion values. Measurements of sagittal rotations of the distal interphalangeal, proximal interphalangeal, and metacarpophalangeal joints were similar to measurements obtained with bone-fixed triads, but larger discrepancies between the 2 methods were found for extrasagittal rotations. CONCLUSIONS AND CLINICAL RELEVANCE: Development of noninvasive methods for quantifying data pertaining to 3-dimensional motion in horses is important for advancement of clinical analysis. The technique used in the study enabled identification of flexion-extension motions with an acceptable degree of accuracy. Appropriate correction algorithms and improvements to the technique may enable future quantification of extrasagittal motions.