ABSTRACT
A 253 J with 26â ns at 0.2â Hz laser performance was demonstrated using a LD pumped cryogenically cooled Yb:YAG ceramics laser amplifier. A high energy storage of 344 J was achieved with a stored energy density of 0.58 J/cm3 using a 1 kJ output multidirectional-pumping system. High energy-extraction efficiency of 56.5% was achieved with high energy fluence of 4.63 J /cm2. To the best of our knowledge, this is the highest output energy obtained with a repetitive nanosecond pulse by LD pumped solid-state laser. This paper presented a design of 1 kJ amplifier based on experimentally proven numerical data.
ABSTRACT
We describe a portable Raman lidar system that can remotely detect oil leakages in water. The system has been developed based on a frequency-doubled, Q-switched Nd:YAG laser, operated at 532 nm with a receiver telescope equipped with some filters and photomultipliers. Stand-off detection of oil is achieved in a 6-m-long water tank, which allowed us to considerably increase the survey capability of subsea infrastructures, including both the range observation and target identification.
ABSTRACT
We report, to the best of our knowledge, the highest power conductive-cooled active-mirror amplifier (CcAMA) using Yb:YAG with a pulse energy of 10 J. By using four liquid-nitrogen circulating cooled laser heads, we achieved a repetition rate, pulse energy, and average power of 33.3 Hz, 9.3 J, and 310 W, respectively. The problem of wavefront distortion, which is difficult to solve with a large-aperture active-mirror laser, is suppressed by using reinforcing materials with the same thermal expansion coefficient. We have confirmed that the wavefront distortion is small (0.15λ P-V per head) at 100 Hz operation, which paves the way for 100 Hz operation with the CcAMA concept.
ABSTRACT
The rapid development of the optical-cycle-level ultra-fast laser technologies may break through the bottleneck of the traditional ultra-intense laser [i.e., Petawatt (PW, 1015 W) laser currently] and enable the generation of even higher peak-power/intensity lasers. Herein, we simulate an ultra-broadband concept for the realization of an Exawatt-class (EW, 1018 W) high peak-power laser, where the wide-angle non-collinear optical parametric chirped-pulse amplification (WNOPCPA) is combined with the thin-plate post-compression. A frequency-chirped carrier-envelope-phase stable super-continuum laser is amplified to high-energy in WNOPCPA by pumping with two pump-beamlets and injected into the thin-plate post-compression to generate a sub-optical-cycle high-energy laser pulse. The numerical simulation shows this hybrid concept significantly enhances the gain bandwidth in the high-energy amplifier and the spectral broadening in the post-compression. By using this concept, a study of a prototype design of a 0.5 EW system is presented, and several key challenges are also examined.
ABSTRACT
Three-dimensional (3-D) light solitons in space-time, referred to as light bullets, have many novel properties and wide applications. Here we theoretically show how the combination of diffraction-free beam and ultrashort pulse spatiotemporal-coupling enables the creation of a straight-line propagation light bullet with freely tunable velocity and acceleration. This light bullet could propagate with a constant superluminal or subluminal velocity, and it could also counter-propagate with a very fast superluminal velocity (e.g., - 35.6c). Apart from uniform motion, an acceleration or deceleration straight-line propagation light bullet with a tunable instantaneous acceleration could also be produced. The high controllability of the velocity and the acceleration of a straight-line propagation light bullet would enable very specific applications, such as velocity and/or acceleration matched micromanipulation, microscopy, particle acceleration, radiation generation, and so on.
ABSTRACT
An actively Q-switched mid-infrared Fe:ZnSe laser pumped by a continuous wave fluoride fiber laser has been developed. Stable operation with a pulse duration of 20 ns and a repetition rate of 40 kHz at 4 µm was achieved. The maximum peak power was 1.1 kW. The high-repetition rate, high-peak power nanosecond pulsed laser, which has been created for the first time, to the best of our knowledge, in an actively Q-switched Fe:ZnSe laser, should prove a suitable light source for laser processing and molecular sensing.
ABSTRACT
Fast isochoric laser heating is a scheme to heat matter with a relativistic intensity (>10^{18} W/cm^{2}) laser pulse for producing an ultrahigh-energy-density (UHED) state. We have demonstrated an efficient fast isochoric heating of a compressed dense plasma core with a multipicosecond kilojoule-class petawatt laser and an assistance of externally applied kilotesla magnetic fields for guiding fast electrons to the dense plasma. A UHED state of 2.2 PPa is achieved experimentally with 4.6 kJ of total laser energy that is one order of magnitude lower than the energy used in the conventional implosion scheme. A two-dimensional particle-in-cell simulation confirmed that diffusive heating from a laser-plasma interaction zone to the dense plasma plays an essential role to the efficient creation of the UHED state.
ABSTRACT
In an ultra-intense femtosecond chirped-pulse amplification laser, the imperfect diffraction wave-fronts of the second and the third gratings of the compressor, where spatio-spectral coupling exists, could introduce a complex spatiotemporal coupling distortion (STCD) and degrade the pulsed beam in both near- and far-fields. Here, we propose a method of double-compressors for pre-compensation. By inserting a scaled down compressor (small compressor) with a deformable retro-reflection mirror into the beam-line, the frequency-dependent wave-front distortion, i.e., the complex STCD, could be removed. We simulate the results in two different ultra-intense femtosecond lasers with 80 and 400 nm bandwidths for comparison, and near ideal focused peak intensities could be obtained in both cases. Meanwhile, the influences of several miss-matching effects, which might appear in engineering, are also analyzed and discussed for applications.
ABSTRACT
A method of 2-dimensional (2-D) space-scanned (in the x-y plane) spatiotemporal double-slit interference is used to reconstruct the 2-D pulse-front (in the x-y-t domain) of a femtosecond pulsed beam. While comparing with recent other methods, the method possesses two advantages: no reference pulse/beam is required anymore, and an arbitrarily distorted pulse-front, not just pulse-front tilt and pulse-front curvature, could be detected. Meanwhile, the influence of different factors of unknown pulsed beams and optical elements on the measurement reliability is also analyzed for engineering applications.
ABSTRACT
The prospect for developing a passively Q-switched Yb:YAG/Cr:YAG monolithic microchip laser that operates at cryogenic temperature is theoretically analyzed. It is concluded that such a system has the potential to deliver laser pulses with improved energy and increased peak power in comparison with composite Yb:YAG/Cr:YAG or Nd:YAG/Cr:YAG devices that are operated at room temperature. Consequently, a cryogenically cooled Yb:YAG/Cr:YAG system is built and the emission performances are investigated. Laser pulses with 3.2 mJ energy, 6.1 MW peak power and high beam quality of M2 = 1.8 are achieved. By increasing the pump beam diameter, laser pulses with higher energy 32 mJ are obtained at 25 MW peak power with M2 = 5.4. To our knowledge, these are the best results obtained from passively Q-switched composite Yb:YAG/Cr:YAG monolithic microchip lasers.
ABSTRACT
Comparing with the non-collinear optical parametric amplification (NOPA), the gain bandwidth could be significantly enhanced by the wide-angle NOPA (WNOPA), i.e., with a divergent signal (WNOPA-S) or pump (WNOPA-P). In a uniaxial crystal, the spectral symmetry/asymmetry of WNOPA is introduced. In WNOPA-S, the ultra-broadband gain spectrum can be obtained in two phase-matching directions at both sides of the pump, however, the output is heavily angularly dispersed. In WNOPA-P, although the gain bandwidth enhancement is only achieved in one phase-matching direction, i.e., on the opposite side of the crystal axis, it is free of angular dispersion. The stabilities of the gain spectrum in NOPA and in WNOPA-P are experimentally compared and theoretically analyzed. Compared with NOPA, WNOPA-P supports an even broader and more stable gain spectrum, and compared with WNOPA-S, WNOPA-P is angular-dispersion-free. The conversation efficiency of WNOPA-P is the same as NOPA. We suppose WNOPA-P is ideally suitable for the amplification of stable ultra-broadband few-cycle pulse lasers.
ABSTRACT
Fast isochoric heating of a pre-compressed plasma core with a high-intensity short-pulse laser is an attractive and alternative approach to create ultra-high-energy-density states like those found in inertial confinement fusion (ICF) ignition sparks. Laser-produced relativistic electron beam (REB) deposits a part of kinetic energy in the core, and then the heated region becomes the hot spark to trigger the ignition. However, due to the inherent large angular spread of the produced REB, only a small portion of the REB collides with the core. Here, we demonstrate a factor-of-two enhancement of laser-to-core energy coupling with the magnetized fast isochoric heating. The method employs a magnetic field of hundreds of Tesla that is applied to the transport region from the REB generation zone to the core which results in guiding the REB along the magnetic field lines to the core. This scheme may provide more efficient energy coupling compared to the conventional ICF scheme.
ABSTRACT
The passively Q-switched operation of a cryogenically cooled Yb:YAG/Cr:YAG microchip laser was demonstrated with end pumping by a photonic crystal surface emitting laser (PCSEL). This laser generated 70 µJ/1.7 ns/3.2 kHz pulses with near diffraction limited beam quality (M2=1.1) at 1029.4 nm. There were no coupling optics between the microchip laser crystal and PCSEL, which made the system simple and compact.
ABSTRACT
Spatiotemporal coupling (STC) of femtosecond pulsed beams could significantly reduce the focal-spot intensity of ultra-intense lasers. We theoretically present a very simple method for single-shot real-time detecting pulse-front tilt, curvature, or tilt and curvature (PFT, PFC or PFT&PFC) by using multiple-slit spatiotemporal interferometry (MSTI). An unknown input pulsed beam is spatially cut by a high-density multiple-slit and changed into a series of spatially separated sub-pulses. By only measuring the spatial distribution of the interference pattern in the far-field, PFT, PFC, or PFT&PFC can be detected. Comparing with recent methods, no reference pulses or beams, no temporal or spatial scanning, and no temporal or spectral measurement is required. The single-shot and spatial-only measurement will greatly simplify the real-time detection of PFT and PFC.
ABSTRACT
We have developed a quasi-continuous wave diode end-pumped cryogenically cooled Yb:YAG/Cr:YAG passively Q-switched microchip laser. A maximum energy of 12.1 mJ with 3.7 MW of peak power was obtained. To the best of our knowledge, this is the highest energy and peak power obtained by an Yb:YAG/Cr:YAG microchip laser so far.
ABSTRACT
We have demonstrated the continuous-wave operation of a highly efficient 2.8 µm Er-doped Lu2O3 ceramic laser at room temperature. An Er:Lu2O3 ceramic with a doping concentration of 11 at.% afforded a slope efficiency of 29% and an output power of 2.3 W with pumping at 10 W. To our knowledge, these are the highest slope efficiency and output power obtained to date for an Er:Lu2O3 ceramic laser at 2.8 µm. In addition, we prepared ceramics with various doping concentrations and determined their emission cross sections by fluorescence lifetime measurements and emission spectroscopy.
ABSTRACT
We have demonstrated a highly efficient 2.8 µm Er-doped Lu2O3 ceramic laser and investigated the lasing dynamics by time-resolved spectroscopy. During room-temperature continuous wave operation, a slope efficiency of 22% was achieved with a high-quality transparent ceramic. To our knowledge, this is the highest slope efficiency obtained by an Er:Lu2O3 ceramic laser. In addition, an output peak power of 1.2 W was obtained during quasi-continuous wave operation. Time-resolved spectroscopy showed that the emission wavelengths exhibited a red shift from 2715 to 2845 nm, which indicated that continuous wave operation may be possible at 2740 and 2845 nm.
ABSTRACT
A simple and compact spectral-broadening system is presented that is based on a single-stage statically pressurized Ar filled hollow core fiber. By optimizing the inner diameter of the hollow core fiber, a bandwidth of 300 nm is obtained. This is the broadest bandwidth known to date with millijoule level energy near the 1-µm wavelength by a single stage gas filled hollow core fiber.
ABSTRACT
We developed a cryogenically cooled Yb:YAG continuous wave oscillator directly pumped with a photonic crystal surface-emitting laser (PCSEL). A high slope efficiency of 65.7% was obtained at an output power of 208 mW. The beam quality was close to the diffraction limit, with M2<1.2 in both directions. To the best of our knowledge, this is the first PCSEL pumped solid state laser to be developed.
ABSTRACT
A series of experiments were carried out to evaluate the energy-coupling efficiency from heating laser to a fuel core in the fast-ignition scheme of laser-driven inertial confinement fusion. Although the efficiency is determined by a wide variety of complex physics, from intense laser plasma interactions to the properties of high-energy density plasmas and the transport of relativistic electron beams (REB), here we simplify the physics by breaking down the efficiency into three measurable parameters: (i) energy conversion ratio from laser to REB, (ii) probability of collision between the REB and the fusion fuel core, and (iii) fraction of energy deposited in the fuel core from the REB. These three parameters were measured with the newly developed experimental platform designed for mimicking the plasma conditions of a realistic integrated fast-ignition experiment. The experimental results indicate that the high-energy tail of REB must be suppressed to heat the fuel core efficiently.