Anatomic characteristics of the right internal spermatic vein based on imaging analysis: a retrospective study in southwest China.

OBJECTIVE: The specific anatomic characteristics of the right internal spermatic vein (ISV) are pivotal factors in embolism failure. However, the inherent angles and configurations of the right ISV remain incompletely explored. This study aimed to address this gap by conducting a thorough investigation into the specific anatomic characteristics of the right ISV using imaging analysis in southwest China. METHODS: This retrospective study analyzed the imaging data of 1000 male patients who underwent multidetector spiral computed tomography (MCT). Anatomic characteristics of the right ISV, including position, type, distance, and angle, were also evaluated. RESULTS: The most common anatomic type (87.8%) of the right ISV was direct drainage into the inferior vena cava, with 90% of the angles below 25.7°. There were 22 cases (2.2%) with parallel right spermatic veins. In the axial plane, the right ISV (86.4%) was located in the third and fourth quadrants. The diameter at the entrance of the right ISV ranged from 2.7-3.8 mm. When the right ISV drained into the inferior vena cava, 83% of cases were located within 40 mm distance below the ostium of the right renal vein, while during draining into the right renal vein, the average distance from the main vein was 6.3 mm. CONCLUSION: This study concluded that MCT can be used to evaluate the anatomical characteristics of the right ISV. The optimal interventional approach was through the jugular vein route to locate the ISV opening and improve the success rate of the embolization.

Endovascular repair of bilateral isolated common iliac artery aneurysms with unsuitable anatomy utilizing an aortic bifurcated unibody endograft and modified sandwich technique to preserve pelvic blood flow: a case series.

Bilateral isolated common iliac artery aneurysms (CIAAs) are rare, and endovascular repair of CIAAs has emerged as an alternative to traditional open surgical repair. The primary goal of therapy is to exclude the aneurysm sac while maintaining perfusion of at least one internal iliac artery (IIA) to prevent pelvic ischemia. Although the iliac branch device (IBD) has improved the feasibility of preserving the IIA, its applicability is limited to a specific subset of aneurysm anatomy. We present a case series of three patients with bilateral isolated CIAAs in whom preoperative CT scans revealed an absence of a landing zone, the diameter of proximal CIA diameter was less than 13.0 mm, and normal diameter of the nonaneurysmal infrarenal aorta, making it challenging to use an IBD alone or a standard bifurcated aortic endograft to provide a proximal landing zone for iliac artery stenting. To overcome the small diameter of the infrarenal aorta, we implanted an aortic bifurcated unibody endograft. Then, we utilized a balloon-expandable covered stent-graft with overdilation as a modified sandwich technique to create an "eye of the tiger" configuration to prevent gutter leakage. The final angiography performed during the procedure revealed successful exclusion of the aneurysms, with blood flow to the right IIA and no type III endoleak. During the postoperative follow-up period, no patients exhibited symptoms associated with pelvic ischemia. There were no endoleaks or sac expansions on the two-year follow-up CT scans, and all external and internal iliac graft limbs were patent. This study demonstrated that a combination of an aortic bifurcated unibody endograft and a modified sandwich technique can effectively treat bilateral isolated CIAAs with certain anatomical constraints.

FLAIR Vascular Hyperintensity: An Important MRI Marker in Patients with Transient Ischemic Attack.

Purpose: We aimed to investigate the prevalence of fluid-attenuated inversion recovery (FLAIR) vascular hyperintensities (FVHs) and the clinical-radiological correlation in transient ischemic attack (TIA) patients. Materials and Methods: We performed a retrospective analysis of TIA patients who had undergone magnetic resonance imaging (MRI) within 24 h of symptom onset. Two independent neuroradiologists investigated the presence of FVHs, large-artery severe stenosis or occlusion (LASO) in magnetic resonance angiograms, and the nature of factors associated with FVH. Results: A total of 207 patients were enrolled in this study. FVHs were detected in 42 (20.3%) patients, in whom atrial fibrillation (AF) was confirmed in 25 (59.5%) cases and LASO was confirmed in 30 (71.4%) cases. The corresponding figures were 33 (20.0%) and 10 (6.1%), respectively, for the 165 FVH-negative patients. Logistic regression analysis showed that time from symptom onset to MRI (odds ratio [OR] = 0.82, 95% CI 0.76-0.97, p = 0.042), previous stroke (OR = 2.95, 95% CI 1.58-6.74, p = 0.002), AF (OR = 5.83, 95% CI 2.24-9.46, p < 0.001), and LASO (OR = 4.28, 95% CI 2.96-10.28, p < 0.001) were independently associated with FVH. Overall, the sensitivity and specificity of FVH for predicting LASO were 0.75 and 0.93, respectively, and the positive predictive value, negative predictive value, and accuracy were 0.71, 0.94, and 0.89, respectively. The area under the receiver operating characteristic curve was 0.839. FVH-positive TIA patients with LASO had less AF (14 [46.7%] versus 11 [91.7%], p = 0.019) and longer times from symptom onset to MRI (6.8 ± 2.8 h versus 4.8 ± 1.3 h, p = 0.004) than those without LASO. Conclusion: The presence of FVH could be an important marker in TIA patients. Many factors, including LASO, AF, and time from symptom onset to MRI, are associated with the detection of FVH.

Self-Stabilized Precipitation Polymerization and Its Application.

An effective, value-added use of the large amounts of olefinic compounds produced in the processing of petroleum, aside from ethylene and propylene, has been a long outstanding challenge. Here, we developed a novel heterogeneous polymerization method, beyond emulsion/dispersion/suspension, termed self-stabilized precipitation (2SP) polymerization, which involves the nucleation and growth of nanoparticles (NPs) of a well-defined size without the use of any stabilizers and multifunctional monomers (crosslinker). This technique leads to two revolutionary advances: (1) the generation of functional copolymer particles from single olefinic monomer or complex olefinic mixtures (including C4/C5/C9 fractions) in large quantities, which open a new way to transform huge amount of unused olefinic compounds in C4/C5/C9 fractions into valuable copolymers, and (2) the resultant polymeric NPs possess a self-limiting size and narrow size distribution, therefore being one of the most simple, efficient, and green strategies to produce uniform, size-tunable, and functional polymeric nanoparticles. More importantly, the separation of the NPs from the reaction medium is simple and the supernatant liquid can be reused; hence this new synthetic strategy has great potential for industrial production.