ABSTRACT
Aqueous solutions are crucial to most domains in biology and chemistry, including in energy fields such as catalysis and batteries. Water-in-salt electrolytes (WISEs), which extend the stability of aqueous electrolytes in rechargeable batteries, are one example. While the hype for WISEs is huge, commercial WISE-based rechargeable batteries are still far from reality, and there remain several fundamental knowledge gaps such as those related to their long-term reactivity and stability. Here, we propose a comprehensive approach to accelerating the study of WISE reactivity by using radiolysis to exacerbate the degradation mechanisms of concentrated LiTFSI-based aqueous solutions. We find that the nature of the degradation species depends strongly on the molality of the electrolye, with degradation routes driven by the water or the anion at low or high molalities, respectively. The main aging products are consistent with those observed by electrochemical cycling, yet radiolysis also reveals minor degradation species, providing a unique glimpse of the long-term (un)stability of these electrolytes.
ABSTRACT
The growing demand for molecules of interest from microalgal biomass, such as phycobiliproteins, has led to an accumulation of unused by-products. For example, phycocyanin, obtained by the extraction of Spirulina, generated cakes rich in non-polar molecules of interest, such as free fatty acids (FFAs). These FFAs were generally considered as markers of lipidome degradation, but represented a relevant alternative to topical antibiotics, based on a biomimetic approach. In order to develop a sustainable Spirulina biorefinery scheme, different pretreatments and alternative solvents were screened to identify the best combination for the valorization of FFAs. Thus, five pre-treatments were studied including a phycocyanin extraction by-product. The following three biobased solvents were selected: ethyl acetate (EtOAc), dimethyl carbonate (DMC) and a fatty acid-based natural deep eutectic solvent (NaDES). The pigment and fatty acid profiles were established by spectroscopic and chromatographic approaches. NaDES demonstrated superior extraction capacity and selectivity compared to other biobased solvents, regardless of pretreatment. In contrast, EtOAc and DMC showed a greater diversity of FFAs, with a predominance of polyunsaturated fatty acids (PUFAs). The by-product has also been highlighted as a relevant raw material facilitating the recovery of FFAs. These results pave the way for a green biorefinery of the lipid fraction and phycobiliproteins of microalgae.
Subject(s)
Microalgae , Spirulina , Solvents/chemistry , Phycocyanin , Fatty Acids, Nonesterified , Deep Eutectic Solvents , Phycobiliproteins , Fatty Acids , Anti-Bacterial AgentsABSTRACT
Binary mixtures of cyclic (TMS) or acyclic sulfones (MIS, EIS and EMS) with EMC or DMC have been used in electrolytes containing LiPF6 (1 M) in both Li4Ti5O12/Li half-cells and Li4+xTi5O12/Li4Ti5O12 symmetric cells and compared with standard EC/EMC or EC/DMC mixtures. In half-cells, sulfone-based electrolytes cannot be satisfactorily cycled owing to the formation of a resistive layer at the lithium interface, which is not stable and generates species (RSO2(-) and RSO3(-)) able to migrate toward the titanate electrode interface. Potentiostatic and galvanostatic tests of Li4Ti5O12/Li half-cells show that charge transfer resistance increases drastically when sulfones are used in the electrolyte composition. Moreover, cyclability and coulombic efficiency are low. Conversely, when symmetric Li4+xTi5O12/Li4Ti5O12 cells are used, it is demonstrated that MIS-(methyl isopropyl sulfone) and TMS-(tetra methyl sulfone) based electrolytes exhibit reasonable electrochemical performances as compared to the EC/DMC or EC/EMC standard mixtures. Surface analysis by XPS of both the Li4+xTi5O12 (partially oxidized) and Li7Ti5O12 (reduced) electrodes taken from symmetric cells reveals that sulfones do not participate in the formation of surface layers. Alkylcarbonates (EMC or DMC), used as co-solvents in sulfone-based binary electrolytes, ensure the formation of surface layers at the titanate interfaces. Therefore, EMC reduction at the two Li4+xTi5O12/electrolyte interfaces in symmetric cells leads to the formation of carbonates, ethers and mineral compounds such as ROCO2Li and Li2CO3. Finally, huge amounts of LiF are detected at the titanate electrode surface, resulting in an increase in the resistivity of symmetric cells and capacity losses.
ABSTRACT
Cycling after storage of LiNi0.4Mn1.6O4/Li4Ti5O12 cells evidences lower total capacity losses for EMS-, TMS- and MIS-based electrolytes as compared to EC-based at 20 °C. The shuttle-type mechanism induced by the electrolyte oxidation is mainly present in the accumulators at this temperature, as compared to those due to the Mn(2+) and Ni(2+) dissolution. At 30 and 40 °C, EC is responsible for the polymer film formation on the LiNi0.4Mn1.6O4 surface, which limits the transition metal ion dissolution. This results in lower reversible capacity losses compared to sulfones, but are still important: 45% at 30 °C and 70-75% at 40 °C. XPS spectra reveal that EMS does not contribute to the surface film formation on the LiNi0.4Mn1.6O4 spinel, regardless of the cycling conditions and temperature. Only the EMC decomposition at high potential in sulfone/EMC electrolytes is responsible for an organic layer formation, which is composed of low passivating oligomers that comprise the C-O and C=O functional groups. Sulfones are promising compounds to be used in high voltage Li-ion batteries thanks to their non-reactivity towards the LiNi0.4Mn1.6O4 cathode. However, this does not allow the deposition of surface films that would have enabled stopping the Mn(2+) and Ni(2+) dissolution in the electrolyte. This is responsible for degraded performances of LiNi0.4Mn1.6O4/Li4Ti5O12 cells as compared to EC-based electrolytes over ambient temperatures, especially at 30 °C.