ABSTRACT
First-order reversal curve diagrams, or FORC diagrams, have been studied to determine if the widths of their distributions along the interaction and coercivity axes can be related to the mean-field magnetization dependent interaction field (MDIF). Arrays of nanowires with diameters ranging from 18 up to 100 nm and packing fractions varying from 0.4 to 12% have been analyzed. The mean-field MDIF has been measured using the remanence curves and used as a measuring scale on the FORC diagrams. Based on these measurements, the full width of the interaction field distribution and the full width at half maximum (FWHM) of the FORC distribution profile along the interaction field direction are shown to be proportional to the MDIF, and the relation between them is found. Moreover, by interpreting the full width of the coercive field distribution in terms of the dipolar induced shearing, a simple relation is found between the width of this distribution and the MDIF. Furthermore, we show that the width of the FORC distribution along the coercive field axis is equal to the width of the switching field distribution obtained by the derivation of the DC remanence curve. This was further verified with the switching field distribution determined using in-field magnetic force microscopy (MFM) for very low density nanowires. The results are further supported by the good agreement found between the experiments and the values calculated using the mean-field model, which provides analytical expressions for both FORC distributions.
ABSTRACT
A large enhancement of the magnetic anisotropy of Ni nanowires (NWs) embedded in anodic aluminium oxide porous membranes is obtained as a result of an induced magnetoelastic (ME) anisotropy contribution. This unusual large anisotropy enhancement depends on the diameter of the NWs and exceeds the magnetostatic (MS) contribution. As a consequence, it leads to effective magnetic anisotropy energies as large as 1.4 × 10(6) erg cm(-3), which are of the same order of magnitude and comparable to the MS energies of harder magnetic materials like Co NWs. Specifically, from ferromagnetic resonance experiments, the magnetic anisotropy of the NWs has been observed to increase as its diameter is decreased, leading to values that are about four times larger than the corresponding value when only the MS anisotropy is present. Our results are consistent with the recently proposed growth mechanism of Ni NWs that proceeds via a poly-crystalline stage at the bottom followed by a single-crystalline stage with texture [110] parallel to the axis of the NWs. A strong correlation between reducing the diameter of the NWs with the decrease of the length of the poly-crystalline segment and the enhancement of the effective magnetic anisotropy has been shown. Magnetization curves obtained from alternating gradient magnetometry experiments show that the average ME anisotropy results from the competition between the magnetic anisotropies of both crystalline segments of the NWs. Understanding the influence of size and confinement effects on the magnetic properties of nanocomposites is of prime interest for the development of novel and agile devices.
ABSTRACT
The dipolar interaction field in arrays of nickel nanotubes has been investigated on the basis of expressions derived from the effective demagnetizing field of the assembly as well as magnetometry measurements. The model incorporates explicitly the wall thickness and aspect ratio, as well as the spatial order of the nanotubes. The model and experiment show that the interaction field in nanotubes is smaller than that in solid nanowires due to the packing fraction reduction in tubes related to their inner cavity. Finally, good agreement between the model and experiment is found for the variation of the interaction field as a function of the tube wall thickness.
ABSTRACT
A mean field model is presented for the configuration dependent effective demagnetizing and anisotropy fields in assemblies of exchange decoupled magnetic particles of arbitrary shape which are expressed in terms of the demagnetizing factors of the particles and the volumetric shape containing the assembly. Perpendicularly magnetized two-dimensional (2D) assemblies have been considered, for which it is shown that the demagnetizing field is lower than the continuous thin film. As an example of these 2D systems, arrays of bistable cylindrical nanowires have been characterized by remanence curves as well as ferromagnetic resonance, serving to show the correspondence of these measurements with the model and also to validate the mean field approach. Linear chains of cylinders and spheres have been analyzed, leading to simple expressions to describe the easy axis rotation induced by the interaction field in chains of low aspect ratio cylindrical particles, and the dipolar magnetic anisotropy observed in the linear chain of spheres. These examples serve to underline the dependence on the dipolar interaction field and effective demagnetizing factor of the contributions that arise from the shape of the outer volume.