ABSTRACT
Titanium trisulfide (TiS3) nanoribbons, when coated with titanium dioxide (TiO2), can be used for water splitting in the KOH electrolyte. TiO2 shells can be prepared through thermal annealing to regulate the response of TiS3/TiO2 heterostructures by controlling the oxidation time and growth atmosphere. The thickness and structure of the TiO2 layers significantly influence the photoelectrocatalytic properties of the TiS3/TiO2 photoanodes, with amorphous layers showing better performance than crystalline ones. The oxide layers should be thin enough to transfer photogenerated charge through the electrode-electrolyte interface while protecting TiS3 from KOH corrosion. Finally, the performance of TiS3/TiO2 heterostructures has been improved by coating them with various electrocatalysts, NiSx being the most effective. This research presents new opportunities to create efficient semiconductor heterostructures to be used as photoanodes in corrosive alkaline aqueous solutions.
ABSTRACT
Tuning the electrocatalytic properties of MoS2 layers can be achieved through different paths, such as reducing their thickness, creating edges in the MoS2 flakes, and introducing S-vacancies. We combine these three approaches by growing MoS2 electrodes by using a special salt-assisted chemical vapor deposition (CVD) method. This procedure allows the growth of ultrathin MoS2 nanocrystals (1-3 layers thick and a few nanometers wide), as evidenced by atomic force microscopy and scanning tunneling microscopy. This morphology of the MoS2 layers at the nanoscale induces some specific features in the Raman and photoluminescence spectra compared to exfoliated or microcrystalline MoS2 layers. Moreover, the S-vacancy content in the layers can be tuned during CVD growth by using Ar/H2 mixtures as a carrier gas. Detailed optical microtransmittance and microreflectance spectroscopies, micro-Raman, and X-ray photoelectron spectroscopy measurements with sub-millimeter spatial resolution show that the obtained samples present an excellent homogeneity over areas in the cm2 range. The electrochemical and photoelectrochemical properties of these MoS2 layers were investigated using electrodes with relatively large areas (0.8 cm2). The prepared MoS2 cathodes show outstanding Faradaic efficiencies as well as long-term stability in acidic solutions. In addition, we demonstrate that there is an optimal number of S-vacancies to improve the electrochemical and photoelectrochemical performances of MoS2.
ABSTRACT
Highly aligned multi-wall carbon nanotubes were investigated with scanning electron microscopy (SEM), Raman spectroscopy and X-ray photoelectron spectroscopy (XPS) before and after bombardment performed using noble gas ions of different masses (argon, neon and helium), in an ultra-high-vacuum (UHV) environment. Ion irradiation leads to change in morphology, deformation of the carbon (C) honeycomb lattice and different structural defects in multi-wall carbon nanotubes. One of the major effects is the production of bond distortions, as determined by micro-Raman and micro-X-ray photoelectron spectroscopy. We observe an increase in sp3 distorted bonds at higher binding energy with respect to the expected sp2 associated signal of the carbon 1s core level, and increase in dangling bonds. Furthermore, the surface damage as determined by the X-ray photoelectron spectroscopy carbon 1s core level is equivalent upon bombarding with ions of different masses, while the impact and density of defects in the lattice of the MWCNTs as determined by micro-Raman are dependent on the bombarding ion mass; heavier for helium ions, lighter for argon ions. These results on the controlled increase in sp3 distorted bonds, as created on the multi-wall carbon nanotubes, open new functionalization prospects to improve and increase atomic hydrogen uptake on ion-bombarded multi-wall carbon nanotubes.
ABSTRACT
Atomic deuterium (D) adsorption on free-standing nanoporous graphene obtained by ultra-high vacuum D2 molecular cracking reveals a homogeneous distribution all over the nanoporous graphene sample, as deduced by ultra-high vacuum Raman spectroscopy combined with core-level photoemission spectroscopy. Raman microscopy unveils the presence of bonding distortion, from the signal associated to the planar sp2 configuration of graphene toward the sp3 tetrahedral structure of graphane. The establishment of D-C sp3 hybrid bonds is also clearly determined by high-resolution X-ray photoelectron spectroscopy and spatially correlated to the Auger spectroscopy signal. This work shows that the low-energy molecular cracking of D2 in an ultra-high vacuum is an efficient strategy for obtaining high-quality semiconducting graphane with homogeneous uptake of deuterium atoms, as confirmed by this combined optical and electronic spectro-microscopy study wholly carried out in ultra-high vacuum conditions.
ABSTRACT
Conversion of free-standing graphene into pure graphaneâwhere each C atom is sp3 bound to a hydrogen atomâhas not been achieved so far, in spite of numerous experimental attempts. Here, we obtain an unprecedented level of hydrogenation (≈90% of sp3 bonds) by exposing fully free-standing nanoporous samplesâconstituted by a single to a few veils of smoothly rippled grapheneâto atomic hydrogen in ultrahigh vacuum. Such a controlled hydrogenation of high-quality and high-specific-area samples converts the original conductive graphene into a wide gap semiconductor, with the valence band maximum (VBM) â¼ 3.5 eV below the Fermi level, as monitored by photoemission spectromicroscopy and confirmed by theoretical predictions. In fact, the calculated band structure unequivocally identifies the achievement of a stable, double-sided fully hydrogenated configuration, with gap opening and no trace of π states, in excellent agreement with the experimental results.
ABSTRACT
Heterostructures formed by ultrathin borocarbonitride (BCN) layers grown on TiO2 nanoribbons were investigated as photoanodes for photoelectrochemical water splitting. TiO2 nanoribbons were obtained by thermal oxidation of TiS3 samples. Then, BCN layers were successfully grown by plasma enhanced chemical vapour deposition. The structure and the chemical composition of the starting TiS3, the TiO2 nanoribbons and the TiO2-BCN heterostructures were investigated by Raman spectroscopy, X-ray diffraction and X-ray photoelectron spectroscopy. Diffuse reflectance measurements showed a change in the gap from 0.94 eV (TiS3) to 3.3 eV (TiO2) after the thermal annealing of the starting material. Morphological characterizations, such as scanning electron microscopy and optical microscopy, show that the morphology of the samples was not affected by the change in the structure and composition. The obtained TiO2-BCN heterostructures were measured in a photoelectrochemical cell, showing an enhanced density of current under dark conditions and higher photocurrents when compared with TiO2. Finally, using electrochemical impedance spectroscopy, the flat band potential was determined to be equal in both TiO2 and TiO2-BCN samples, whereas the product of the dielectric constant and the density of donors was higher for TiO2-BCN.
ABSTRACT
A suitable way to modify the electronic properties of graphene-while maintaining the exceptional properties associated with its two-dimensional (2D) nature-is its functionalisation. In particular, the incorporation of hydrogen isotopes in graphene is expected to modify its electronic properties leading to an energy gap opening, thereby rendering graphene promising for a widespread of applications. Hence, deuterium (D) adsorption on free-standing graphene was obtained by high-energy electron ionisation of D2 and ion irradiation of a nanoporous graphene (NPG) sample. This method allows one to reach nearly 50 at.% D upload in graphene, higher than that obtained by other deposition methods so far, towards low-defect and free-standing D-graphane. That evidence was deduced by X-ray photoelectron spectroscopy of the C 1s core level, showing clear evidence of the D-C sp3 bond, and Raman spectroscopy, pointing to remarkably clean and low-defect production of graphane. Moreover, ultraviolet photoelectron spectroscopy showed the opening of an energy gap in the valence band. Therefore, high-energy electron ionisation and ion irradiation is an outstanding method for obtaining low defect D-NPG with a high D upload, which is very promising for the fabrication of semiconducting graphane on large scale.
ABSTRACT
Over the last 50 years, the incidence of human thyroid cancer disease has seen a significative increment. This comes along with an even higher increment of surgery, since, according to the international guidelines, patients are sometimes addressed to surgery also when the fine needle aspiration gives undetermined cytological diagnosis. As a matter of fact, only 30% of the thyroid glands removed for diagnostic purpose have a post surgical histological report of malignancy: this implies that about 70% of the patients have suffered an unnecessary thyroid removal. Here we show that Raman spectroscopy investigation of thyroid tissues provides reliable cancer diagnosis. Healthy tissues are consistently distinguished from cancerous ones with an accuracy of [Formula: see text] 90%, and the three cancer typology with highest incidence are clearly identified. More importantly, Raman investigation has evidenced alterations suggesting an early stage of transition of adenoma tissues into cancerous ones. These results suggest that Raman spectroscopy may overcome the limits of current diagnostic tools.
Subject(s)
Thyroid Neoplasms/diagnosis , Adenoma/diagnosis , Adenoma/pathology , Biopsy, Fine-Needle/methods , Diagnosis, Differential , Female , Humans , Male , Middle Aged , Spectrum Analysis, Raman/methods , Thyroid Gland/pathology , Thyroid Neoplasms/pathology , Thyroid Nodule/diagnosis , Thyroid Nodule/pathologyABSTRACT
PURPOSE: Recently, it has been demonstrated that Raman spectroscopy is able to differentiate between healthy parathyroid tissues and parathyroid adenoma based on the basis of a specific molecular fingerprint. However, to our knowledge, no previous studies have been performed to evaluate the metabolic profile of parathyroid adenoma. Therefore, we designed a proof of concept study aimed to investigate the glucose/fatty acid metabolisms, in addition to the mitochondrial changes, in solitary parathyroid adenoma and in healthy parathyroid glands. METHODS: Nine females with primary hyperparathyroidism due to a solitary parathyroid adenoma and formal surgical indication for parathyroidectomy have been enrolled. At the time of surgery, the removed specimens were immediately submitted unfixed and a tissue slice of about 0.5 cm in diameter was obtained from the nodular lesion. The expression of selected metabolic enzymes and proteins has been evaluated by western blot analysis, using human parathyroid whole tissue lysates as control. RESULTS: Data obtained highlighted an increase, compared with the healthy group, of: (i) the glucose uptake by the GLUT-1 receptor and its phosphorylation by hexokinase II (HXKII); (ii) the expression of 3-phosphoglycerate dehydrogenase (3-PGDH) and glucose-6-phosphate dehydrogenase (G6PD); (iii) lipids biosynthesis; and (iv) cytochrome c expression. CONCLUSIONS: Our findings highlight for the first time the parathyroid adenoma metabolic hallmarks that could represent potential molecular targets usable for the development of new pharmacological treatments, allowing to reduce surgical parathyroidectomy.
Subject(s)
Adenoma , Parathyroid Neoplasms , Adenoma/surgery , Female , Humans , Metabolome , Parathyroid Glands , Parathyroid Hormone , Parathyroid Neoplasms/surgery , ParathyroidectomyABSTRACT
Enzymes are essential to maintain organisms alive. Some of the reactions they catalyze are associated with a change in reagents chirality, hence their activity can be tracked by using optical means. However, illumination affects enzyme activity: the challenge is to operate at low-intensity regime avoiding loss in sensitivity. Here we apply quantum phase estimation to real-time measurement of invertase enzymatic activity. Control of the probe at the quantum level demonstrates the potential for reducing invasiveness with optimized sensitivity at once. This preliminary effort, bringing together methods of quantum physics and biology, constitutes an important step towards full development of quantum sensors for biological systems.
Subject(s)
Light , Quantum Theory , beta-Fructofuranosidase/metabolism , Lasers , Photons , Saccharomyces cerevisiae/enzymologyABSTRACT
The Clausius inequality has deep implications for reversibility and the arrow of time. Quantum theory is able to extend this result for closed systems by inspecting the trajectory of the density matrix on its manifold. Here we show that this approach can provide an upper and lower bound to the irreversible entropy production for open quantum systems as well. These provide insights on how the information on the initial state is forgotten through a thermalization process. Limits of the applicability of our bounds are discussed and demonstrated in a quantum photonic simulator.
ABSTRACT
The simplicity of a question, such as wondering whether or not correlations characterize a certain system, collides with the experimental difficulty of accessing such information. Here we present a low-demanding experimental approach that refers to the use of a metrology scheme to obtain a conservative estimate of the strength of frequency correlations. Our test bed is the widespread case of a photon pair produced per downconversion. The theoretical architecture used to put the correlation degree on a quantitative ground is also described.
ABSTRACT
The concept of ions being either water "structure makers" or water "breakers" seems to be inconsistent with the existence of a critical number of water molecules per ion dictating the properties of an aqueous solution, independent of the ion identity. To investigate this issue, Raman spectra of hydroxide aqueous solutions in the region of the OH stretching mode have been obtained under ambient conditions and at concentrations ranging from extreme dilution to the solubility limit. Spectra have been analyzed with a relatively model-free approach, in terms of a superposition of contributions due to the vibrations of the OH- ions, with two contributions due to the solvent. One of these latter contributions falls at wavenumbers very close to that of the OH- stretching band, sharing with it its concentration dependence of the full width at half maximum (FWHM). The other contribution due to the solvent is very broad, with increasing FWHM with increasing ion concentration. In the light of these observations, an interpretation of the Raman spectra, based on the possibility of distinguishing the self and distinct contributions, is proposed. The present analysis is supported by structural data on the same solutions and puts into evidence relevant structural and dynamical changes occurring when the number of water molecules available per solute is below â¼20, irrespective of the ion identity.
ABSTRACT
Not much, in the end. Here we put forward some considerations on how Hong-Ou-Mandel interferometry provides signatures of frequency entanglement in the two-photon state produced by parametric down-conversion. We find that some quantitative information can be inferred in the limit of long-pulse pumping, while the short-pulse limit remains elusive.
ABSTRACT
Standard thermometry employs the thermalization of a probe with the system of interest. This approach can be extended by incorporating the possibility of using the nonequilibrium states of the probe and the presence of coherence. Here, we illustrate how these concepts apply to the single-qubit thermometer introduced by Jevtic et al. [Phys. Rev. A 91, 012331 (2015)PLRAAN1050-294710.1103/PhysRevA.91.012331] by performing a simulation of the qubit-environment interaction in a linear-optical device. We discuss the role of the coherence and how this affects the usefulness of nonequilibrium conditions. The origin of the observed behavior is traced back to how the coherence affects the propensity to thermalization. We discuss this aspect by considering the availability function.