ABSTRACT
Ligand-stabilized platinum nanoparticles (Pt NPs) can be used to build well-defined three-dimensional (3-D) nanostructured electrodes for better control of the catalyst architecture in proton exchange membrane fuel cells (PEMFCs). Platinum NPs of 1.7 +/- 0.5 nm diameter stabilized by the water-soluble phosphine ligand, tris(4-phosphonatophenyl)phosphine (TPPTP, P(4-C6H4PO3H2)3), were prepared by ethylene glycol reduction of chloroplatinic acid and subsequent treatment of the isolated nanoparticles with TPPTP. The isolated TPPTP-stabilized Pt NPs were characterized by multinuclear magnetic resonance spectroscopy (31P and 195Pt NMR), high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), and extended X-ray absorption fine structure (EXAFS). The negatively charged TPPTP-Pt NPs were electrostatically deposited onto a glassy carbon electrode (GCE) modified with protonated 4-aminophenyl functional groups (APh). Multilayers were assembled via electrostatic layer-by-layer deposition with cationic poly(allylamine HCl) (PAH). These multilayer films are active for the key hydrogen fuel cell reactions, hydrogen oxidation (anode) and oxygen reduction (cathode). Using a rotating disk electrode configuration, fully mass-transport limited kinetics for hydrogen oxidation was obtained after 3 layers of TPPTP-Pt NPs with a total Pt loading of 4.2 microg/cm2. Complete reduction of oxygen by four electrons was achieved with 4 layers of TPPTP-Pt NPs and a total Pt loading of 5.6 microg/cm2. A maximum current density for oxygen reduction was reached with these films after 5 layers resulting in a mass-specific activity, i(m), of 0.11 A/mg(Pt) at 0.9 V. These films feature a high electrocatalytic activity and can be used to create systematic changes in the catalyst chemistry and architecture to provide insight for building better electrocatalysts.
ABSTRACT
Phosphonate and phosphonic acid functionalized phosphine complexes of platinum(II) were prepared via direct reaction of the ligands with K2PtCl4 in water. Either cis or trans geometries were found depending on the nature of the ligand. The crystal structure of P(3-C6H4PO3H2)3.2H2O (6b) (triclinic, P1, a = 8.3501(6) A, b = 10.1907(6) A, c = 14.6529(14) A, alpha = 94.177(6) degrees, beta = 105.885(6) degrees, gamma = 108.784(5) degrees, Z = 2) shows a layered arrangement of the phosphonic acid. The phosphonodiamide complex cis-[PtCl2(P[4-C6H4PO[N(CH3]2]]3)2].3H2O (10) was synthesized in 89% yield and hydrolyzed to the phosphonic acid complex using dilute HCl. Aqueous phase and silica gel supported catalytic phosphonylation of phenyl triflate using palladium phosphine complexes was achieved. A molybdenum complex, Mo(CO)5[P3-C6H4PO3H2)3] (11), was synthesized in situ and grafted to an alumina surface. XPS, RBS, and AFM studies confirm the formation of a monolayer of 11 on the alumina surface.
ABSTRACT
To investigate the electrical characteristics of organometallic complexes as molecular conductors, organometallic pi-conjugated molecules of the type trans-[PtL2(CCC6H4SAc-4)2], where L = PCy3, PBu3, PPh3, P(OEt)3, P(OPh)3, were synthesized and characterized by NMR, IR, UV, and X-ray spectroscopies. For the three complexes (L = PCy3, PPh3, and P(OEt)3) that could be measured using a cross-wire junction technique, the current-voltage (I-V) characteristics of a molecular monolayer of these complexes showed no ligand effect, despite spectroscopic evidence that electronic interaction between the phosphine ligands and the pi-system does occur. It was concluded that the tunneling efficiency across the molecule is the determining factor for conduction in this metal-molecule-metal system. It was also shown that the incorporation of a transition metal in pi-conjugated molecular wires does not adversely affect charge transport compared to all-carbon pi-conjugated molecular wires.
ABSTRACT
Current-voltage (I-V) characteristics for metal-molecule-metal junctions formed from three classes of molecules measured with a simple crossed-wire molecular electronics test-bed are reported. Junction conductance as a function of molecular structure is consistent with I-V characteristics calculated from extended Hückel theory coupled with a Green's function approach, and can be understood on the basis of bond-length alternation.
ABSTRACT
We demonstrate aqueous hydrogel-based microcontact printing of amine ligands into solvent-templated nanocavities of chloromethylphenyl-based siloxane or thin polymer films. Migration of pyridine ligands within films following printing, which can compromise pattern fidelity, is eliminated by heat treatment of the substrate. Gentle heating (e.g., 50 degrees C, 5 min) leads to the efficient alkylation of mobile pyridine adsorbate by the C-Cl bonds of the film, covalently tethering the adsorbate to the surface as a pyridinium salt. Subsequent binding of a Pd-based colloid to surface pyridinium (and remaining strongly bound and immobile pyridine ligand) sites permits selective electroless metal deposition and fabrication of patterned metal films.
ABSTRACT
Water-soluble phosphonate-functionalized triaryl phosphine ligands Na(2)[Ph(2)P(4-C(6)H(4)PO(3))].1.5H(2)O (4a), Na(2)[Ph(2)P(3-C(6)H(4)PO(3))].2H(2)O (4b), and Na(2)[Ph(2)P(2-C(6)H(4)PO(3))].2H(2)O (4c), were prepared in 54-56% yields by the transesterification and hydrolysis of the appropriate phosphonic acid diethyl ester precursors. The solubilities of 4a-c in water are compared and the spectroscopic properties studied in detail. The crystal structure of Na(2)[Ph(2)P(4-C(6)H(4)PO(3))(H(2)O)(3)(CH(3)OH)].CH(3)OH (monoclinic, P2(1)/n, a = 6.4457(8) Å, b = 8.1226(8) Å, c = 46.351(3) Å, beta = 92.902(8) degrees, Z = 4) shows a dimeric association via two bridging water molecules and four sodium ions. Reaction of 4a with PtCl(2)(PPh(3))(2) in a biphasic H(2)O/CH(2)Cl(2) mixture gives cis- and trans-Na(4)[PtCl(2){Ph(2)P(4-C(6)H(4)PO(3))}(2)]. 3H(2)O. Palladium dichloride and 4a in H(2)O/benzene catalyzes the carbonylation of benzyl chloride to give phenylacetic acid (91%).