ABSTRACT
Cavitation bubbles can be seeded from a plasma following optical breakdown, by focusing an intense laser in water. The fast dynamics are associated with extreme states of gas and liquid, especially in the nascent state. This offers a unique setting to probe water and water vapor far-from equilibrium. However, current optical techniques cannot quantify these early states due to contrast and resolution limitations. X-ray holography with single X-ray free-electron laser pulses has now enabled a quasi-instantaneous high resolution structural probe with contrast proportional to the electron density of the object. In this work, we demonstrate cone-beam holographic flash imaging of laser-induced cavitation bubbles in water with nanofocused X-ray free-electron laser pulses. We quantify the spatial and temporal pressure distribution of the shockwave surrounding the expanding cavitation bubble at time delays shortly after seeding and compare the results to numerical simulations.
ABSTRACT
A main challenge in x-ray µCT with laboratory radiation derives from the broad spectral content, which in contrast to monochromatic synchrotron radiation gives rise to reconstruction artifacts and impedes quantitative reconstruction. Due to the low spectral brightness of these sources, monochromatization is unfavorable and parallel recording of a broad bandpath is practically indispensable. While conventional CT sums up all spectral components into a single detector value, spectral CT discriminates the data in several spectral bins. Here we show that a new generation of charge integrating and interpolating pixel detectors is ideally suited to implement spectral CT with a resolution in the range of 10 µm. We find that the information contained in several photon energy bins largely facilitates automated classification of materials, as demonstrated for of a mouse cochlea. Bones, soft tissues, background and metal implant materials are discriminated automatically. Importantly, this includes taking a better account of phase contrast effects, based on tailoring reconstruction parameters to specific energy bins.
ABSTRACT
This corrects the article DOI: 10.1103/PhysRevLett.115.203902.
ABSTRACT
In this work, we propose a novel computed tomography (CT) approach for three-dimensional (3D) object reconstruction, based on a generalized tomographic geometry with two-dimensional angular sampling (two angular degrees of freedom). The reconstruction is based on the 3D Radon transform and is compatible with anisotropic beam conditions. This allows isotropic 3D imaging with a source, which can be extended along one direction for increased flux, while high resolution is achieved by a small source size only in the orthogonal direction. This novel scheme for analytical CT is demonstrated by numerical simulations and proof-of-concept experiments. In this way high resolution and coherence along a single direction determines the reconstruction quality of the entire 3D data set, opening up, for example, new opportunities to achieve nanoscale resolution and/or phase contrast with low brilliance sources such as laboratory x-ray or neutron sources.
ABSTRACT
We study the propagation of hard x rays in single curved x-ray waveguide channels and observe waveguide effects down to surprisingly small radii of curvature R≃10 mm and a large contour length s≃5 mm, deflecting beams up to 30°. At these high angles, about 2 orders of magnitude above the critical angle of total reflection θ(c), most radiation modes are lost by "leaking" into the cladding, while certain "survivor" modes persist. This may open up a new form of integrated x-ray optics "on a chip," requiring curvatures mostly well below the extreme values studied here, e.g., to split and to delay x-ray pulses.
