ABSTRACT
PURPOSE: Greater white matter hyperintensities (WMH) in older adults have been associated with reduced bone mineral density (BMD) and increased fractures and falls. However, it is unclear whether there is a causal relationship between BMD reduction and WMH. In this study, Mendelian randomization (MR) was used to find the causality between WMH and estimated BMD (eBMD). METHODS: We performed a two-sample bidirectional MR analysis using statistical data obtained from publicly available genome-wide association studies (GWAS). The main method of MR analysis is the inverse-variance weighted (IVW) method. To identify and account for the impact of horizontal pleiotropy, we also employed MR-Egger regression, MR pleiotropy residual sum, and outlier (MR-PRESSO). RESULTS: MR analysis found a causal relationship between eBMD and WMH (IVW OR = 0.938, 95 % CI: 0.889-0.990, p = 0.020). Our causal estimates are unlikely to be distorted by horizontal pleiotropy according to heterogeneity test (both p > 0.05) and MR-Egger regression (p > 0.05). However, in the reverse MR analysis, there was no evidence that WMH was causally correlated with eBMD (IVW OR = 0.979, 95 % CI: 0.954-1.005, p = 0.109). CONCLUSION: Our results suggest that low eBMD increased the risk of WMH; conversely, no evidence that WMH causally affects eBMD was found.
Subject(s)
Bone Density , Genome-Wide Association Study , Mendelian Randomization Analysis , White Matter , Humans , Bone Density/genetics , White Matter/diagnostic imaging , White Matter/pathologyABSTRACT
Breast cancer poses the significance of early diagnosis and treatment. Here, we developed an innovative photoelectrochemical (PEC) immunosensor characterized by high-level dual photocurrent signals and exceptional sensitivity. The PEC sensor, denoted as MIL&Ag2S, was constructed by incorporating Ag2S into a metal-organic framework of MIL-101(Cr). This composite not only enhanced electron-hole separation and conductivity but also yielded robust and stable dual photocurrent signals. Through the implementation of signal switching, we achieved the combined detection of cancer antigen 15-3 (CA15-3) and carcinoembryonic antigen (CEA) with outstanding stability, reproducibility, and specificity. The results revealed a linear range for CEA detection spanning 0.01-32 ng/mL, with a remarkably low detection limit of 0.0023 ng/mL. Similarly, for CA15-3 detection, the linear range extended from 0.1 to 320 U/mL, with a low detection limit of 0.014 U/mL. The proposed strategy introduces new avenues for the development of highly efficient, cost-effective, and user-friendly PEC sensors. Furthermore, it holds promising prospects for early clinical diagnosis, contributing to potential breakthroughs in medical detection and ultimately improving patient outcomes.
Subject(s)
Biomarkers, Tumor , Breast Neoplasms , Carcinoembryonic Antigen , Electrochemical Techniques , Metal-Organic Frameworks , Mucin-1 , Silver Compounds , Metal-Organic Frameworks/chemistry , Humans , Breast Neoplasms/diagnosis , Carcinoembryonic Antigen/blood , Carcinoembryonic Antigen/analysis , Mucin-1/analysis , Mucin-1/blood , Biomarkers, Tumor/blood , Biomarkers, Tumor/analysis , Silver Compounds/chemistry , Immunoassay/methods , Biosensing Techniques , Female , Limit of Detection , Photochemical Processes , Antibodies, Immobilized/immunology , Antibodies, Immobilized/chemistryABSTRACT
Widely used organophosphorus pesticide triazophos (TAP) can easily cumulate in aquatic system due to its high stability chemically and photochemically and thus posing significant threat to aquatic creatures and humans' health. Urging demand for rapid determining TAP in water has risen. Photoelectrochemical (PEC) sensing turns out to be a good candidate for its simplicity in fabrication and swiftness in detection. Nevertheless, traditional PEC sensors often lack selectivity as their signal generation primarily relies on the oxidation of organic compounds in the electrolyte by photo-induced holes. To address this limitation, molecularly imprinted polymers (MIPs) can be in combined with PEC sensors to significantly enhance the selectivity. Here, we present a novel approach utilizing a PEC sensor enhanced by carbon-modified titanium dioxide molecularly imprinted polymers (MIP/C/TiO2 NTs). Carbon quantum dot (CQD) modification of titanium dioxide nanotube arrays (C/TiO2 NTs) was achieved through a one-step anodization process, effectively enhancing visible light absorption by narrowing the band gap of TiO2, and CQDs also function as sensitizer accelerating charge transfer for improved and stable photocurrent signals during detection. Our method further incorporates MIPs to heighten the selectivity of the PEC sensor. Electro-polymerization using cyclic voltammetry was employed to polymerize MIPs with pyrrole as the functional monomer and triazophos as the target molecule. The resultant MIP/C/TiO2 NT sensor exhibited remarkable sensitivity, with a detection limit of 0.03 nM (S/N = 3), alongside exceptional selectivity and stability for triazophos detection in water. This offers a promising avenue for efficient, cost-effective, and rapid monitoring of pesticide contaminants in aquatic environments, contributing to the broader goals of environmental preservation and public health.
ABSTRACT
The recycling of spent graphite from waste lithium-ion batteries (LIBs) holds great importance in terms of environmental protection and conservation of natural resources. In this study, a simple two-step method involving heat treatment and solution washing was employed to recycle spent graphite. Subsequently, the recycled graphite was milled with red phosphorus to create a carbon/red phosphorus composite that served as an anode material for the new LIBs, aiming to address the low capacity issue. In a half-cell configuration, the carbon/red phosphorus composite exhibited remarkable cycling stability, maintaining a capacity of 721.7 mAh g-1 after 500 cycles at 0.2 A g-1, and demonstrated an excellent rate performance with a capacity of 276.2 mAh g-1 at 3 A g-1. The improved performance can be attributed to the structure of the composite, where the red phosphorus particles are covered by the carbon layer. This composite outperformed pure recycled graphite, highlighting its potential in enhancing the electrochemical properties of LIBs. Furthermore, when the carbon/red phosphorus composite was assembled into a full-cell configuration with LiCoO2 as the cathode material, it displayed a stable electrochemical performance, further validating its practical applicability. This work presents a promising and green strategy for recycling spent graphite and using it in the production of new batteries. The findings offer a high potential for commercialization, contributing to the advancement of sustainable and ecofriendly energy storage technologies.
ABSTRACT
A photoelectrochemical molecular imprinting sensor based on Au/TiO2 nanocomposite was constructed for the detection of dibutyl phthalate. Firstly, TiO2 nanorods were grown on fluorine-doped tin oxide substrate by hydrothermal method. Then, gold nanoparticles were electrodeposited on TiO2 to fabricate Au/TiO2. Finally, molecular imprinted polymer was electropolymerized on the Au/TiO2 surface to construct MIP/Au/TiO2 PEC sensor for DBP. The conjugation effect of MIP accelerates the electron transfer between TiO2 and MIP, which can greatly improve the photoelectric conversion efficiency and sensitivity of the sensor. In addition, MIP can also provide sites for highly selective recognition of dibutyl phthalate molecules. Under optimal experimental conditions, the prepared photoelectrochemical sensor was used for the quantitative determination of DBP and the results showed a wide linear range (50 to 500 nM), a low limit of detection (0.698 nM), and good selectivity. The sensor was used in a study of real water samples to show that it has promising applications in environmental analysis.
ABSTRACT
Exploring a new type of smart membrane with tunable separation performance is a promising area of research. In this study, new light-responsive metal-organic framework [Co(azpy)] sheets were prepared by a facile microwave method for the first time, and were then incorporated into a polymer matrix to fabricate smart mixed matrix membranes (MMMs) applied for flue gas desulfurization and decarburization. The smart MMMs exhibited significantly elevated SO2(CO2)/N2 selectivity by 184(166)% in comparison with an unfilled polymer membrane. The light-responsive characteristic of the smart MMMs was investigated, and the permeability and selectivity of the Co(azpy) sheets-loaded smart MMMs were able to respond to external light stimuli. In particular, the selectivity of the smart MMM at the Co(azpy) content of 20% for the SO2/N2 system could be switched between 341 and 211 in situ irradiated with Vis and UV light, while the SO2 permeability switched between 58 Barrer and 36 Barrer, respectively. This switching influence was mainly ascribed to the increased SO2 adsorption capacity in the visible light condition, as verified by adsorption test. The CO2 permeability and CO2/N2 selectivity of MMMs in the humidified state could achieve 248 Barrer and 103.2, surpassing the Robeson's upper bound reported in 2019.
ABSTRACT
A new Schiff-base 1 based on 4-N,N-dimethylaminoaniline salicylaldehyde is developed. It possesses unique solution-solid dual emission behaviour with emission color: an aggregation-induced bright turquoise emission in liquid and strong near-infrared emission in the solid state. Interestingly, on the one hand, compound 1 is promising a ratiometric fluorescent probe for Zn2+ ions detection in the aqueous solution with high sensitivity, selectivity, and relatively low detection limit. On the other hand, based on its inner stimuli-responsive nature, outstanding thermostability and photostability, 1 should be a very promising candidate for the write-once read-many optical data storage medium.