ABSTRACT
Toxoplasma gondii (T. gondii) is widely spread around the world, which can cause serious harm to immunosuppressed patients. Currently, the commercial test kits are poor at assessing T. gondii infection and vaccine effectiveness, making an urgent need to exploit effective enzyme-linked immunosorbent assay with great performance to compensate for this deficiency. Here, the TgIMP1 recombinant protein was expressed in E. coli BL(21) cells. The TgIMP1 was purified with affinity chromatography and the reactivity was retained with anti-TgIMP1 antibodies. The TgIMP1 was then used to develop an indirect ELISA (IMP1-iELISA) and the reaction conditions of IMP1-iELISA were optimized. As a result, the cut-off value was determined to be 0.2833 by analyzing the OD450nm values of forty T. gondii-negative sera. The coefficient of variation of 6 T. gondii-positive sera within and between runs were both less than 10%. The IMP1-iELISA was non-cross-reactive with the sera of cytomegalovirus, herpes virus, rubella virus, Cryptosporidium spp., Theileria spp., Neospora spp. and Plasmodium spp.. Furthermore, the sensitivity and specificity of IMP1-iELISA were 98.9% and 96.7%, respectively, based on testing 150 serum samples. The results suggest that this IMP1-iELISA is specific, sensitive, repeatable and can be applied to the detection of T. gondii infections in the medical and health industries.
ABSTRACT
In recent years, we have witnessed numerous indoor fires caused by the flammable properties of cotton. Flame-retardant cotton deserves our attention. A novel boric acid and diethylenetriaminepenta (methylene-phosphonic acid) (DTPMPA) ammonium salt-based chelating coordination flame retardant (BDA) was successfully prepared for cotton fabrics, and a related retardant mechanism with ion transfer was investigated. BDA can form a stable chemical and coordination bond on the surface of cotton fibers by a simple three-curing finishing process. The limiting oxygen index (LOI) value of BDA-90 increased to 36.1%, and the LOI value of cotton fabric became 30.3% after 50 laundering cycles (LCs) and exhibited excellent durable flame retardancy. Fourier-transform infrared (FTIR) spectroscopy, X-ray photoelectron spectroscopy (XPS), and scanning electron microscopy (SEM) methods were used to observe the bonding mode and morphology of BDA on cotton fibers. A synergistic flame-retardant mechanism of condensed and gas phases was concluded from thermogravimetry (TG), cone calorimeter tests, and TG-FTIR. The test results of whiteness and tensile strength showed that the physical properties of BDA-treated cotton fabric were well maintained.
ABSTRACT
Geopolymer is a porous inorganic material with a three-dimensional mesh structure, good mechanical properties, a simple preparation process (no sintering) and a low economic cost, and it is environmentally friendly. Geopolymer concrete has been widely used in the construction field, and many other studies have revealed that geopolymer will become one of the most promising inorganic materials with unique structure and properties. This paper provides a review of the development and current status of geopolymers and briefly explains the effects of material proportioning, experimental factors and activators on geopolymer performance. Because of the advantages of high specific surface area and high porosity, geopolymers could be used as adsorbent materials. This paper summarizes the research progresses of the adsorption of metal cations, anions, dyes, and gases by geopolymers, which emphasizes the geopolymer membranes in adsorption, and discusses the challenges and opportunities for the development of more efficient, sustainable and practical adsorption protocols.
ABSTRACT
Liquid ammonia (LA) dyeing is a zero-effluent and sustainable dyeing technology investigated for textiles. In the present work, three bi-functional reactive dyes, Reactive Red 195 (R195), Reactive Yellow 145 (Y145), and Reactive Blue 194 (B194), were used to dye ramie fiber in liquid ammonia, and the dye exhaustion (%) and fixation (%) were compared with ramie fibers dyed with the same dyes in an aqueous dyeing method. Dyeing with a single reactive dye, a binary dye mixture, and a ternary dye mixture in liquid ammonia showed that all the dyes are highly compatible as they showed similar uptake. The total dye exhaustion percentage of dyeing with the ternary dye mixture was 22.6%. After dyeing, a cationic fixing agent (CFA)/decamethylcyclopentasiloxane (D5) micro-emulsion was applied and the dye fixation rate was 96.7% accompanied by high colorfastness to washing (Grade 4-5) and produced uniform shades. Finally, a color triangle of dyed ramie fibers was prepared to exhibit many colorful shades. This work demonstrates the viability of dyeing of textile fibers in liquid ammonia.
ABSTRACT
The dyeing process commonly deteriorates the luster of pre-mercerized cotton fabric, so post-mercerization processes are regularly applied to compensate for this. Herein, the influence of combining pre-mercerization with CS (caustic solution) or LA (liquid ammonia) and post-mercerization with CS or LA on the morphological structure, dyeing performance, tensile strength, and stiffness of woven cotton fabric was investigated. The crystallinity index values greatly decreased from 73.12 to 51.25, 58.73, 38.42, and 40.90% after the combined mercerization processes of LA-LA, CS-CS, LA-CS, and CS-LA, respectively. Additionally, the CS-LA- and LA-CS-treated samples exhibited a mixture of cellulose II and cellulose III allomorphs. The combined mercerization processing of cotton fabric resulted in slightly worse thermal stability. The LA and CS pre-mercerization processes increased the dye exhaustion, although the former decreased the dye fixation rate while the latter increased it by 4% for both dyes. The color strength of the dyed cotton fabric increased after both post-mercerization processes. Moreover, the fabric stiffness and mechanical properties showed an increasing trend due to the combined mercerization efforts.
ABSTRACT
The conventional dyeing process requires a substantial amount of auxiliaries and water, which leaches hazardous colored effluents to the environment. Herein, a newly developed sustainable spray dyeing system has been proposed for cotton fabric in the presence of reactive dyes, which has the potential to minimize the textile dyeing industries environmental impact in terms of water consumption and save significant energy. The results suggest that fresh dye solution can be mixed with an alkali solution before spray dyeing to avoid the reactive dye hydrolysis phenomenon. After that, drying at 60-100 °C, wet fixation treating for 1-6 min, and combined treatments (wet fixation + drying) were sequentially investigated and then dye fixation percentages were around 63-65%, 52-70%, and above 80%, respectively. Following this, fixation conditions were optimized using L16 orthogonal designs, including wet fixation time, temperature, dye concentration, and pH with four levels where the "larger-the-better" function was selected to maximize the dye fixation rate. Additionally, the color uniformity and wash and rubbing fastnesses were at an acceptable level when both treatments were applied. Finally, the dyes were hydrolyzed after wet fixation, and the hydrolysis percentages were enhanced after the drying process.
ABSTRACT
Sonodynamic therapy (SDT) by utilizing ultrasonic waves triggers the generation of reactive oxygen species (ROS) with the help of sonosensitizers to destruct deep-seated tumors has attracted great attention. However, the efficacy of SDT may not be robust enough due to the insufficient oxygen supply within solid tumors. Additionally, repeated injections and treatments, which are often required to achieve the optimal therapeutic responses, may cause additional side effects and patient incompliance. Herein, a thermo-triggered in situ hydrogel system is developed in which catalase (CAT) conjugated with sonosensitizer meso-tetra (4-carboxyphenyl) porphine (TCPP) is mixed into chitosan (CS) and beta-glycerol phosphate disodium (GP) to form the precursor solution. After injection of the precursor solution into tumors, the in situ sol-gel transformation will occur as triggered by the body temperature, resulting in the localized tumor retention of TCPP-CAT. The locally restrained TCPP-CAT not only produces ROS under ultrasonic treatment, but also sustainably reverses the oxygen-deficient status in solid tumors by triggering the O2 generation from the decomposition of endogenous H2 O2 , further promoting the efficacy of SDT. As a result, the repeated SDT after a single dose injection of such a hydrogel can offer robust treatment effects to effectively eradicate tumors.
Subject(s)
Chitosan , Neoplasms , Ultrasonic Therapy , Humans , Neoplasms/drug therapy , Reactive Oxygen Species , Ultrasonic WavesABSTRACT
Based on the urgent demand of non-flammable electrospun nanofiber separators and the strong adsorption to polysulfides through chemical doping in separators for Li-S cell, in this study, a phosphorus, nitrogen, and sulfur three-flame retardant (di-(2-(5,5-dimethyl-2-sulfido-1,3,2-dioxaphosphinan-2-yl)hydrazineyl)-P-ethylphosphinic) was synthesized and a high-performance flame-retarding poly-m-phenyleneisophthalamide (PMIA) membrane was successfully prepared through blend electrospinning with the flame retardant, it is regarded as a promising gel nanofiber membrane with advanced safety for the lithium-sulfur (Li-S) cell, and it was systematically explored and analyzed. It was presented that the modified PMIA electrospun membrane with the synthesized flame retardant possessed excellent flame retardation, outstanding thermal stability, and good mechanical strength. Meanwhile, the prepared membrane showed extraordinarily high uptake and preserving retention of the liquid electrolyte and enhanced ionic conductivity. More importantly, the assembled Li-S cells using the obtained membrane exhibited excellent cycling retention and outstanding rate capability because of its fast ion transportation and good interfacial compatibility. The assembled batteries with the novel membrane exhibited a high first-cycle discharge capacity of 1121.50 mA h g-1, superior discharge capacity retention of 713.41 mA h g-1, and high Coulombic efficiency of 98.46% after 600 cycles at the 0.5 C rate. In addition, the limiting oxygen index of the obtained nanofiber membrane with flame retardancy was as high as â¼30.0%, which could greatly enhance the safety of the electrospun nanofiber separator. The excellent electrochemical performances and safety for the battery assembled with the prepared gel PMIA nanofiber membrane were attributed to the significantly prevented "shuttle effect" of lithium polysulfides based on the physical capturing of lithium polysulfides through the obtained jelly-like gel state and chemical binding of polysulfide intermediates through the tridoped phosphorus, nitrogen, and sulfur elements in the PMIA and the flame retardant. All of these excellent properties will promote the great development of the Li-S battery with high performance and satisfactory safety.
ABSTRACT
Pd(OAc)2-catalyzed intramolecular dehydrogenative cross-coupling reaction between tertiary enamides, which were derived from the condensation of 2-arylethylamines and methyl o-acetylbenzoate, and arenes enabled synthesis of 7,8-dihydro-5 H-benzo[4,5]azepino[2,1- a]isoindol-5-one derivatives under mild conditions. The synthetic method was applied in the total synthesis of aporhoeadane alkaloids palmanine, lennoxamine, and chilenamine in only three or four steps.
ABSTRACT
A new strategy to construct 2,3-dihydro-1H-azepine and 1H-azepin-2(3H)-one heterocyclic rings is reported based on emerging tertiary enamide synthons. Under very mild conditions employing BBr3 as a Lewis acid catalyst and P2O5 as an additive, tertiary enamides that contain a formyl group underwent highly efficient and scalable intramolecular cyclic condensation to afford diverse 2,3-dihydro-1H-azepine and 1H-azepin-2(3H)-one derivatives in 71-96% yields. The reaction proceeded most probably through a nucleophilic addition of enamides to aldehyde, deprotonation, and dehydration cascade. Application of the method in the synthesis of dihydro-azepino[2,1-a]isoindol-5-ones, the core structure of naturally occurring lennoxamine, was also demonstrated.