ABSTRACT
Polypropylene-based aerogels with high surface area have been developed for the first time. By chemical crosslinking of polypropylene with oligomeric capped-end amino compounds, followed by dissolution, thermally induced phase separation, and the supercritical CO2 drying process or freeze-drying method, the aerogels exhibit high specific surface areas up to 200 m2/g. Moreover, the silica-cage multi-amino compound was utilized in a similar vein for forming hybrid polypropylene aerogels. According to the SEM, the developed polypropylene-based aerogels exhibit highly porous morphology with micro-nanoscale structural features that can be controlled by processing conditions. Our simple and inexpensive synthetic strategy results in a low-cost, chemically resistant, and highly porous material that can be tailored according to end-use applications.
ABSTRACT
The inherent disadvantages of traditional nonflexible aerogels, such as high fragility and moisture sensitivity, severely restrict their applications. To address these issues, different techniques have been used to incorporate the flexibility in aerogel materials; hence, the term "flexible aerogels" was introduced. In the case of introducing flexibility, the organic part is induced with the inorganic part (flexible hybrid aerogels). Additionally, some more modern research is also available in the fabrication of hybrid flexible aerogels (based on organic-organic), the combination of two organic polymers. Moreover, a new type (single-component flexible aerogels) are quite a new category composed of only single materials; this category is very limited, charming to make the flexible aerogels pure from single polymers. The present review is composed of modern techniques and studies available to fabricate hybrid and single-component flexible aerogels. Their synthesis, factors affecting their parameters, and limitations associated with them are explained deeply. Moreover, a comparative analysis of drying methods and their effectiveness in the development of structures are described in detail. The further sections explain their properties and characterization methods. Eventually, their applications in a variety of multifunctional fields are covered. This article will support to introduce the roadmap pointing to a future direction in the production of the single-component flexible aerogel materials and their applications.
ABSTRACT
The inherent disadvantages of traditional non-flexible aerogels, such as high fragility and moisture sensitivity, severely restrict their applications. To address these issues and make the aerogels efficient, especially for advanced medical applications, different techniques have been used to incorporate flexibility in aerogel materials. In recent years, a great boom in flexible aerogels has been observed, which has enabled them to be used in high-tech biomedical applications. The current study comprises a comprehensive review of the preparation techniques of pure polymeric-based hybrid and single-component aerogels and their use in biomedical applications. The biomedical applications of these hybrid aerogels will also be reviewed and discussed, where the flexible polymeric components in the aerogels provide the main contribution. The combination of highly controlled porosity, large internal surfaces, flexibility, and the ability to conform into 3D interconnected structures support versatile properties, which are required for numerous potential medical applications such as tissue engineering; drug delivery reservoir systems; biomedical implants like heart stents, pacemakers, and artificial heart valves; disease diagnosis; and the development of antibacterial materials. The present review also explores the different mechanical, chemical, and physical properties in numerical values, which are most wanted for the fabrication of different materials used in the biomedical fields.
ABSTRACT
The term "nanosilica" refers to materials containing ultrafine particles. They have gained a rapid increase in popularity in a variety of applications and in numerous aspects of human life. Due to their unique physicochemical properties, SiO2 nanoparticles have attracted significant attention in the field of biomedicine. This study aimed to elucidate the mechanism underlying the cellular response to stress which is induced by the exposure of cells to both biogenic and pyrogenic silica nanoparticles and which may lead to their death. Both TEM and fluorescence microscopy investigations confirmed molecular changes in cells after treatment with silica nanoparticles. The cytotoxic activity of the compounds and intracellular RNS were determined in relation to HMEC-1 cells using the fluorimetric method. Apoptosis was quantified by microscopic assessment and by flow cytometry. Furthermore, the impact of nanosilica on cell migration and cell cycle arrest were determined. The obtained results compared the biological effects of mesoporous silica nanoparticles extracted from Urtica dioica L. and pyrogenic material and indicated that both types of NPs have an impact on RNS production causing apoptosis, necrosis, and autophagy. Although mesoporous silica nanoparticles did not cause cell cycle arrest, at the concentration of 50 µg/mL and higher they could disturb redox balance and stimulate cell migration.
Subject(s)
Nanoparticles , Silicon Dioxide , Apoptosis , Endothelial Cells , Humans , Nanoparticles/chemistry , Necrosis , Silicon Dioxide/chemistryABSTRACT
The term aerogel is used for unique solid-state structures composed of three-dimensional (3D) interconnected networks filled with a huge amount of air. These air-filled pores enhance the physicochemical properties and the structural characteristics in macroscale as well as integrate typical characteristics of aerogels, e.g., low density, high porosity and some specific properties of their constituents. These characteristics equip aerogels for highly sensitive and highly selective sensing and energy materials, e.g., biosensors, gas sensors, pressure and strain sensors, supercapacitors, catalysts and ion batteries, etc. In recent years, considerable research efforts are devoted towards the applications of aerogels and promising results have been achieved and reported. In this thematic issue, ground-breaking and recent advances in the field of biomedical, energy and sensing are presented and discussed in detail. In addition, some other perspectives and recent challenges for the synthesis of high performance and low-cost aerogels and their applications are also summarized.
ABSTRACT
Silicon dioxide, in the form of nanoparticles, possesses unique physicochemical properties (size, shape, and a large surface to volume ratio). Therefore, it is one of the most promising materials used in biomedicine. In this paper, we compare the biological effects of both mesoporous silica nanoparticles extracted from Urtica dioica L. and pyrogenic material. Both SEM and TEM investigations confirmed the size range of tested nanoparticles was between 6 and 20 nanometers and their amorphous structure. The cytotoxic activity of the compounds and intracellular ROS were determined in relation to cells HMEC-1 and erythrocytes. The cytotoxic effects of SiO2 NPs were determined after exposure to different concentrations and three periods of incubation. The same effects for endothelial cells were tested under the same range of concentrations but after 2 and 24 h of exposure to erythrocytes. The cell viability was measured using spectrophotometric and fluorimetric assays, and the impact of the nanoparticles on the level of intracellular ROS. The obtained results indicated that bioSiO2 NPs, present higher toxicity than pyrogenic NPs and have a higher influence on ROS production. Mesoporous silica nanoparticles show good hemocompatibility but after a 24 h incubation of erythrocytes with silica, the increase in hemolysis process, the decrease in osmotic resistance of red blood cells, and shape of erythrocytes changed were observed.
Subject(s)
Endothelial Cells/drug effects , Erythrocytes/drug effects , Hemolysis/drug effects , Nanoparticles/administration & dosage , Oxidative Stress/drug effects , Silicon Dioxide/administration & dosage , Cell Survival , Humans , Nanoparticles/chemistry , Porosity , Reactive Oxygen Species/metabolism , Silicon Dioxide/chemistry , Surface PropertiesABSTRACT
In this study, selective green synthesis of gold nanoparticles (nAu) with the use of Tarragon extract (Artemisia dracunculus) was investigated. Characterization of the synthetized nAu was carried out using several techniques including: UV-Vis, SEM, zeta potential analysis, DLS, and ATR-FTIR. Based on measurements of Tarragon extract by HPLC-MS, significant chemical substances participating as reducing and stabilizing agents were identified. FTIR confirmed typical functional groups that could be found in these acids on the nAu surface, such as O-H, C=O and C-O. The effects of various parameters (concentration of Tarragon extract, Au precursor, and initial pH of the synthesis) on the shape and size of the nanoparticles have been investigated. UV-Vis and SEM confirmed the formation of nAu at various concentrations of the extract and Au precursor and showed correlation between the added extract concentration and shift in maximal absorbance towards higher frequencies, indicating the formation of smaller nanoplates. Zeta potential determined at various pH levels revealed that its value decreased with pH, but for all experiments in the pH range of 2.8 to 5.0, the value is below - 30 mV, an absolute value high enough for long-term nAu stability. In order to evaluate nAu catalytic activity, the reduction of 4-nitrophenol to 4-aminophenol by sodium borohydride was used as a model system. The reaction takes place 1.5 times faster on Au-triangles than on Au-spherical NPs.
Subject(s)
Artemisia/chemistry , Gold/chemistry , Green Chemistry Technology/methods , Metal Nanoparticles/chemistry , Aminophenols/chemistry , Borohydrides/chemistry , Catalysis , Chromatography, High Pressure Liquid , Hydrogen-Ion Concentration , Microscopy, Electron, Scanning , Nitrophenols/chemistry , Particle Size , Plant Extracts/analysis , Plant Extracts/chemistry , Spectrophotometry, Ultraviolet , Spectroscopy, Fourier Transform Infrared , Tandem Mass SpectrometryABSTRACT
Detonation nanodiamonds (DND) are a widely studied group of carbon nanomaterials. They have the ability to adsorb a variety of biomolecules and drugs onto their surfaces, and additionally their surfaces may be subjected to chemical functionalization by covalent bonds. We present a procedure for the purification and surface oxidation of diamond nanoparticles, which were then tested by spectroscopic analysis such as ATR-FTIR, Raman spectroscopy, and thermogravimetric analysis. We also examined the zeta potential of the tested material. Analysis of the cytotoxic effect of nanodiamonds against normal lymphocytes derived from human peripheral blood, the non-small cell lung cancer cell line (A549) and the human colorectal adenocarcinoma cell line (HT29) was performed using MTT colorimetric assay. Evaluation of cell viability was performed after 1-h and 24-h treatment with the tested nanoparticles applied at concentrations ranging from 1 µg/ml to 100 µg/ml. We found that the survival of the examined cells was strongly associated with the presence of serum proteins in the growth medium. The incubation of cells with nanodiamonds in the presence of serum did not exert a significant effect on cell survival, while the cell treatment in a serum-free medium resulted in a decrease in cell survival compared to the negative control. The role of purification and functionalization of nanodiamonds on their cytotoxicity was also demonstrated.
Subject(s)
Cell Survival/drug effects , Lymphocytes/drug effects , Nanodiamonds/toxicity , A549 Cells , Cell Proliferation/drug effects , Cells, Cultured , Female , HT29 Cells , Humans , Lymphocytes/cytology , Lymphocytes/metabolism , Male , Microscopy, Electron, Scanning , Nanodiamonds/ultrastructure , Spectroscopy, Fourier Transform Infrared , Spectrum Analysis, RamanABSTRACT
Blindness and visual disability are a very significant problem all over the world. Inflammation, metabolic disorders, tumours, hereditary optic neuropathies may all lead to visual impairment. The main cause of visual impairment and disability in children and young adults is optic nerve atrophy. THE AIM of the paper is the presentation of clinical features and treatment of nerve atrophy in children. Patients with optic nerve disorders should receive effective refraction and amblyopia treatment.