Achievement of Target Gain Larger than Unity in an Inertial Fusion Experiment.

On December 5, 2022, an indirect drive fusion implosion on the National Ignition Facility (NIF) achieved a target gain G_{target} of 1.5. This is the first laboratory demonstration of exceeding "scientific breakeven" (or G_{target}>1) where 2.05 MJ of 351 nm laser light produced 3.1 MJ of total fusion yield, a result which significantly exceeds the Lawson criterion for fusion ignition as reported in a previous NIF implosion [H. Abu-Shawareb et al. (Indirect Drive ICF Collaboration), Phys. Rev. Lett. 129, 075001 (2022)PRLTAO0031-900710.1103/PhysRevLett.129.075001]. This achievement is the culmination of more than five decades of research and gives proof that laboratory fusion, based on fundamental physics principles, is possible. This Letter reports on the target, laser, design, and experimental advancements that led to this result.

Lawson Criterion for Ignition Exceeded in an Inertial Fusion Experiment.

For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin "burn propagation" into surrounding cold fuel, enabling the possibility of high energy gain. While "scientific breakeven" (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this Letter reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion.

Publisher's Note: Experimental investigation of stimulated Raman and Brillouin scattering instabilities driven by two successive collinear picosecond laser pulses [Phys. Rev. E 93, 043209 (2016)].

This corrects the article DOI: 10.1103/PhysRevE.93.043209.

Experimental investigation of stimulated Raman and Brillouin scattering instabilities driven by two successive collinear picosecond laser pulses.

Backward stimulated Raman and Brillouin scattering (SRS and SBS) are experimentally investigated by using two successive 1-µm, 1.5-ps FWHM laser pulses. The collinear pulses, separated by 3 or 6 ps and of moderate laser intensities (∼2×10^{16}Wcm^{-2}), are fired into a preionized He plasma of density ∼2.5-6×10^{19}cm^{-3}. The electron plasma waves and ion acoustic waves, respectively driven by SRS and SBS, are analyzed through space- and time-resolved Thomson scattering. Depending on the laser and plasma parameters, we observe the effect of the first pulse on the time-resolved SRS and SBS signals of the second pulse. The measurements are found to qualitatively agree with the results of a large-scale particle-in-cell simulation.

Direct experimental evidence for current-transfer mode operation of nested tungsten wire arrays at 16-19 MA.

Nested tungsten wire arrays (20-mm on 12-mm diam.) are shown for the first time to operate in a current-transfer mode at 16-19 MA, even for azimuthal interwire gaps of 0.2 mm that are the smallest typically used for any array experiment. After current transfer, the inner wire array shows discrete wire ablation and implosion characteristics identical to that of a single array, such as axially nonuniform ablation, delayed acceleration, and trailing mass and current. The presence of trailing mass from the outer and the inner arrays may play a role in determining nested array performance.

Alternative mechanism for omega(0)/2 emission in laser-produced plasmas.

Several models have been proposed to explain the broad spectral features characteristic of omega(0)/2 emission observed in laser-produced plasmas. In this article, the electromagnetic decay instability is examined as an alternative explanation for this emission. It is shown that the electromagnetic decay instability is able to explain some of the spectral features observed from laser-produced plasmas. In addition, the electromagnetic decay instability is consistent with two other features observed in experiments: the efficient generation of electromagnetic energy and the discrepancy in the levels of emission between the omega(0)/2 emission and the 3omega(0)/2 emission.