Evaluation of methotrexate-loaded surfactants, ceramides and cholesterol-based lamellar phases as a topical treatment for psoriasis.

OBJECTIVE: Psoriasis is a chronic inflammatory skin disorder. Oral or subcutaneous methotrexate (MTX) is a first-line antipsoriatic treatment, whose adverse effects can be observed even at low doses. To minimize systemic side effects, antipsoriatic drugs should be administered topically, since they could permeate the stratum corneum. As liquid crystals with lamellar phase (LP) can be helpful in promoting skin permeation, this work evaluated two MTX-loaded LPs (C1CH and C1CHCE), based on stearic acid, cholesterol and ceramides, like topical treatments for mice with imiquimod-induced psoriasis. METHODS: C1CH and C1CHCE were topically administered to mice with imiquimod-induced psoriasis. Dexamethasone cream was used as positive treatment control. Skin histology and inflammation biomarkers were assessed. KEY FINDINGS: C1CH and C1CHCE exhibited marked immunomodulatory effects and induced extensive microstructural skin remodelling on the epidermis and dermis. These formulations increased keratinization score, epidermis thickness, inflammatory infiltrate, hair follicle hypertrophy and vascular congestion in the dermis. C1CH and C1CHCE also attenuated IL-10 upregulation and upregulated IL-1, IFN-γ, TNF-α and prostaglandin E2 levels, as well as myeloperoxidase, N-acetyl-ß-d-glucosaminidase and cyclooxygenase 2 activity compared with untreated psoriatic animals. CONCLUSION: Although liquid crystals have been reported as good options for carrying topical drugs, they need to be carefully assessed on a case-by-case basis.

Influence of the ionic strength on the physicochemical properties of methotrexate-loaded chitosan polyelectrolyte complexes

Abstract Polyelectrolyte complexes (PECs) as drug delivery systems are widely explored since they are easily obtained by coacervation and biopolymers can be associated. However, particle distribution is a challenging critical parameter that has been infrequently focused. This work evaluated the effect of NaCl concentration on the physicochemical properties of PECs based on chitosan and hypromellose loaded with methotrexate. The particle size, zeta potential and polydispersity index (PdI) were determined by DLS, besides of drug entrapment efficiency (EE) and in vitro drug release profile determination. Particle size decreased while NaCl concentration rised, achieving a narrower size distribution of (345±79 nm) and PdI (0.285±0.067) with 200 mmol/L NaCl. The higher the NaCl concentration, the lower the zeta potential at acid pH. The EE was kept similar ((28.2±4.5) %) from 0 to 300 mmol/L NaCl, while 400 mmol/L NaCl impaired the drug entrapment. The addition of (200 and 300) mmol/L NaCl did not affect the drug release profile, but it was faster with (100 or 400) mmol/L. In conclusion, the addition of 200 mmol/L NaCl reduced particle size and PdI with no changes in the EE and drug release. Therefore, the ionic strength plays an important role on PECs development.

Preclinical Evaluation of Polymeric Nanocomposite Containing Pregabalin for Sustained Release as Potential Therapy for Neuropathic Pain.

This study offers a novel oral pregabalin (PG)-loaded drug delivery system based on chitosan and hypromellose phthalate-based polymeric nanocomposite in order to treat neuropathic pain (PG-PN). PG-PN has a particle size of 432 ± 20 nm, a polydispersity index of 0.238 ± 0.001, a zeta potential of +19.0 ± 0.9 mV, a pH of 5.7 ± 0.06, and a spherical shape. Thermal and infrared spectroscopy confirmed nanocomposite generation. PG-PN pharmacokinetics was studied after a single oral dose in male Wistar rats. PG-PN showed greater distribution and clearance than free PG. The antinociceptive effect of PG-PN in neuropathic pain rats was tested by using the chronic constriction injury model. The parameter investigated was the mechanical nociceptive threshold measured by the von Frey filaments test; PG-PN showed a longer antinociceptive effect than free PG. The rota-rod and barbiturate sleep induction procedures were used to determine adverse effects; the criteria included motor deficit and sedative effects. PG-PN and free PG had plenty of motors. PG-PN exhibited a less sedative effect than free PG. By prolonging the antinociceptive effect and decreasing the unfavorable effects, polymeric nanocomposites with pregabalin have shown promise in treating neuropathic pain.

Preclinical study of methotrexate-based hydrogels versus surfactant based liquid crystal systems on psoriasis treatment.

Psoriasis is an autoimmune, inflammatory and chronic skin disease in which cell growth and proliferation are increased, causing erythema, lesions and skin's peeling. Oral methotrexate (MTX) is the first-choice drug when phototherapy or retinoid treatment are not effective. Topical administration can be advantageous to better orientate the drug's delivery; however, the stratum corneum performs as a barrier for hydrofilic drugs penetration. This study sought to evaluate two different types of vehicles for MTX on the psoriasis treatment - hydrogel and liquid crystal systems (LCs). Lamellar and hexagonal liquid crystalline phases were selected from a ternary phase diagram based on polysorbate 80, isopropyl miristate and water. The hydrogel was based on alkylated carbomer (ACH). Rheological analysis showed ACH was more elastic than lamellar and hexagonal phases. ACH interacted better with pig skin than LCs in bioadhesion assay. Preclinical study revealed the ACH decreased inflammation in mice with induced psoriasis, being as effective as dexamethasone to regulate epidermis thickness, COX-2 and myeloperoxidase activity and TNF-α level, while LCs demonstrated inflammatory effect. Therefore, MTX-loaded hydrogel based platforms are indicated for local treatment of psoriasis and present great potential for further studies.

Preclinical evaluation of methotrexate-loaded polyelectrolyte complexes and thermosensitive hydrogels as treatment for rheumatoid arthritis.

This work proposes new methotrexate (MTX) loaded drug delivery systems (DDS) to treat rheumatoid arthritis via the intra-articular route: a poloxamer based thermosensitive hydrogel (MTX-HG), oligochitosan and hypromellose phthalate-based polyelectrolyte complexes (MTX-PEC) and their association (MTX-PEC-HG). MTX-PEC showed 470 ± 166 nm particle size, 0.298 ± 0.108 polydispersity index, +26 ± 2 mV and 74.3 ± 5.8% MTX efficiency entrapment and particle formation was confirmed by infrared spectroscopy and thermal analysis. MTX-HG and MTX-PEC-HG gelled at 36.7°C. MTX drug release profile was prolonged for MTX-HG and MTX-PEC-HG, and faster for MTX-PEC and free MTX. The in vivo effect of the MTX-DDSs systems was evaluated in induced arthritis rats as single intra-articular dose. The assessed parameters were the mechanical nociceptive threshold, the plasmatic IL-1ß level and histological analysis of the tibiofemoral joint. MTX-HG and MTX-PEC-HG performance were similar to free MTX and worse than oral MTX, used as positive control. All DDSs showed some irritative effect, for which further studies are required. MTX-PEC was the best treatment on recovering cartilage damage and decreasing allodynia. Thus, MTX-PEC demonstrated potential to treat rheumatoid arthritis, with the possibility of decreasing the systemic exposure to the drug.