ABSTRACT
Plastics are essential materials for modern societies, but their production contributes to significant environmental issues. Power-to-X processes could produce plastics from captured CO2 and hydrogen with renewable electricity, but these technologies may also face challenges from environmental perspective. This paper focuses on environmental sustainability assessment of CO2-based low-density polyethylene (LDPE) compared to bio-based LDPE. Life cycle assessment has been applied to study climate impacts and land use related biodiversity impacts of different plastic production scenarios. According to the climate impact results, the carbon footprint of the produced plastic can be negative if the energy used is from wind, solar, or bioenergy and the carbon captured within the plastic is considered. In terms of biodiversity, land-use related biodiversity impacts seem to be lower from CO2-based polyethylene compared to sugarcane-based polyethylene. Forest biomass use for heat production in CO2-based polyethylene poses a risk to significantly increase biodiversity impacts. Taken together, these results suggest that CO2-based LDPE produced with renewable electricity could reduce biodiversity impacts over 96 % while carbon footprint seems to be 6.5 % higher when compared to sugarcane-based polyethylene.
ABSTRACT
The worldwide spread of the SARS-CoV-2 virus has continued to accelerate, putting a considerable burden on public health, safety, and the global economy. Taking into consideration that the main route of virus transmission is via respiratory particles, the face mask represents a simple and efficient barrier between potentially infected and healthy individuals, thus reducing transmissibility per contact by reducing transmission of infected respiratory particles. However, long-term usage of a face mask leads to the accumulation of significant amounts of different pathogens and viruses onto the surface of the mask and can result in dangerous bacterial and viral co-infections. Zeolite imidazolate framework-8 (ZIF-8) has recently emerged as an efficient water-stable photocatalyst capable of generating reactive oxygen species under light irradiation destroying dangerous microbial pathogens. The present study investigates the potential of using ZIF-8 as a coating for face masks to prevent the adherence of microbial/viral entities. The results show that after 2 h of UV irradiation, a polypropylene mask coated with ZIF-8 nanostructures is capable of eliminating S. Aureus and bacteriophage MS2 with 99.99% and 95.4% efficiencies, respectively. Furthermore, low-pathogenic HCoV-OC43 coronavirus was eliminated by a ZIF-8-modified mask with 100% efficiency already after 1 h of UV irradiation. As bacteriophage MS2 and HCoV-OC43 coronavirus are commonly used surrogates of the SARS-CoV-2 virus, the revealed antiviral properties of ZIF-8 can represent an important step in designing efficient protective equipment for controlling and fighting the current COVID-19 pandemic.
ABSTRACT
Applicability of Raman spectroscopy for time-resolved gas composition monitoring during direct methanol synthesis via carbon dioxide hydrogenation was investigated. A series of methanol synthesis experiments with varied reactor conditions was conducted and the reactor outlet stream was analyzed with in-line gas Raman spectroscopy. Concentrations of H2, CO2 and CO were determined directly from the acquired spectral data. For evaluation of methanol and water content a data reconciliation algorithm was developed. The algorithm involves estimation of the occurring chemical reactions' extents by iterative minimization of the difference between concentration values acquired from the experimental data and concentration values computed based on the mass conservation principle. The obtained experimental concentrations were compared and validated against the results of the reactor mathematical modeling, which is based upon a well-established kinetic interpretation of the process. The findings indicate good repeatability and accuracy of the developed gas analysis system, which together with the advantageous temporal resolution of the method, make Raman spectroscopy a promising technique for fast response monitoring of the process.
ABSTRACT
Hydrogen-oxidizing bacteria (HOB) have been shown to be promising micro-organisms for the reduction of carbon dioxide to a wide range of value-added products in bioelectrochemical systems with in situ water electrolysis of the cultivation medium, also known as a hybrid biological-inorganic systems (HBI). However, scaling up of this process requires overcoming the inherent constraints of the low energy efficiency partly associated with the pH-neutral electrolyte with low conductivity. Most of the research in the field is concentrated on the bacterial cultivation, whereas the analysis and evaluation of the electrode material performance have received little attention in the literature so far. Therefore, in the present work, in situ electrolysis of a pH-neutral medium for HOB cultivation was performed with different combinations of electrode materials. Besides conventional electrode types, electrodes with coatings made of earth-abundant cobalt and a nickel-iron alloy, known for their catalytic activity for the kinetically sluggish oxygen evolution reaction (OER), were prepared and tested as potential substitutes for catalysts made of precious metals. The cultivation of HOB with in situ water electrolysis has been successfully tested in a small scale electrobioreactor in order to support the experimental results. A simplified water electrolysis model was developed and applied to evaluate the current-voltage characteristics of an bioelectrochemical system prototype. Application of the developed model allows quantitative evaluation and comparison of reversible, ohmic, and activation overvoltages of different electrode sets. The modeling results were found to agree well with the experimental data. The developed model and the data gathered can be applied to further investigation, simulation, and optimization of HBI systems.
