A new multiphasic buffer system for sodium dodecyl sulfate-polyacrylamide gel electrophoresis of proteins and peptides with molecular masses 100,000-1000, and their detection with picomolar sensitivity.

A novel multiphasic buffer system for high resolution sodium dodecyl sulfate-polyacrylamide gel electrophoresis of dansylated and nondansylated proteins/peptides in the relative molecular mass (Mr) range of 100,000-1000 is described. The system, based on Jovin's theory of multiphasic zone electrophoresis, allows complete stacking and destacking of proteins/peptides within the above Mr range. The buffer system uses Bicine and sulfate as trailing and leading ion, respectively, and Bistris and Tris as counter ions in the stacking and separating phase, respectively. Through selection of two different counter ions--the characteristic feature of the present ionic system--the stacking limits of a multiphasic buffer system can be further widened, thus making it applicable to gel electrophoresis of a larger spectrum of rapidly migrating species, such as sodium dodecyl sulfate-proteins/peptides and nucleic acids, than has been possible previously. Highly sensitive detection methods for proteins as well as for polypeptides down to approximately Mr 1000 are described. Dansylated proteins/peptides were detected by their fluorescence either directly within the gel or following electroblotting into anion-exchange or polyvinylidene difluoride membranes. The latter procedure resulted in detection sensitivities of approximately 1 ng. Nondansylated proteins/peptides were either detected within the gel by colloidal Coomassie staining or by electroblotting into polyvinylidene difluoride membranes, followed by colloidal gold staining. Prior to both staining procedures the proteins/peptides were pretreated with glutardialdehyde in the presence of borate at near neutral pH values to generate protein/peptide polymers of poor solubility. For a given pH the efficiency of the latter procedure was significantly influenced by the nature of the buffer ion used in the fixation buffer. In contrast to conventional fixation procedures even small polypeptides (Mr 1000) were immobilized and approximately 15 ng and 0.75 ng could be detected after colloidal Coomassie and colloidal gold staining, respectively.

Essential problems in quantification of proteins following colloidal staining with coomassie brilliant blue dyes in polyacrylamide gels, and their solution.

Quantitative determination of stained proteins following polyacrylamide gel electrophoresis (PAGE) is of increasing interest especially since computer-aided densitometers have become available as well as recipes for sensitive and background-free staining with Coomassie Brilliant Blue dyes. However, avoidance of separation artifacts is not the only essential prerequisite for quantitative evaluation. The local particle density of a protein in a given gel is of critical importance since it determines its stainability. Depending on local protein concentration, the dye binding to the same amount of a given protein differs considerably. Since the stainability of proteins using colloidal staining procedures, as with Coomassie Brilliant Blue dyes, is time-dependent and, in addition, also dependent on the pore size of a given polyacrylamide gel used for PAGE, calibration curves for quantitative determinations have to be prepared in polyacrylamide gels of the same composition as used for PAGE. Staining conditions also have to be identical for calibration gels and gels under analysis. If, however, a set of calibration curves is prepared for different staining times, it is possible to calculate a generalized calibration curve, allowing for quantitative evaluation with flexible staining time. Furthermore, and in consequence of the implications due to particle density, quantitative determination via densitometry is only possible by determining the protein amount of each single measuring point (pixel) via its absorbance on the basis of a calibration curve. Since the particle density is inherent in a calibration curve, the final summation of the protein amount per pixel will give values close to reality.

Two-dimensional electrophoresis of synovial tissue, synovial fluid and serum in patients with rheumatoid arthritis and related diseases.

Using the technique of two-dimensional (2D) electrophoresis with consecutive silver staining, we investigated samples of serum, synovial fluid and synovial tissue obtained from 19 patients suffering from rheumatoid arthritis (RA) or non-RA arthritis. From these experiments we have drawn the following conclusions. 2D electrophoresis of serum, synovial fluid and synovial tissue extracts taken from patients suffering from joint diseases is a reproducible method. Repeated runs of the same sample reveal an essentially constant protein spot pattern. The time period between surgery and tissue preparation did not influence the number of protein spots when less than 15 h was involved. The protein spot number is always lower in synovial fluid than in either synovial tissue or serum in RA and non-RA patients. The mean value for the number of spots is 68 for the inflamed tissue irrespective of the cause of arthritis (RA and non-RA group taken together) and 47 for the control group. This difference is significant. We were able to definitely identify 7 spots in the tissue extract. We did not find RA-specific protein spots in either serum, synovial fluid or tissue extracts from the synovial membrane. The only significant difference between RA patients and either non-RA or control group patients concerning the protein spot pattern is the increased size of the immunoglobulin spot (mainly IgG) in RA. In addition, we discuss possible reasons for failure of the 2D electrophoresis technique to detect disease-specific protein patterns.

Application of a new electrophoresis technique (2D cryostat section electrophoresis) to synovial tissue of RA patients and comparison with immunohistochemical staining methods.

We describe a new two dimensional electrophoresis technique which is based on the combination of cryostat section technology and IEF- and SDS-gel electrophoresis. The optimal conditions for two dimensional cryostat section electrophoresis are investigated. The application of this technique to synovial membranes of patients suffering from rheumatoid arthritis and osteoarthritis is described.

Electrophoretic Assay for Ribulose 1,5-Bisphosphate Carboxylase/Oxygenase in Guard Cells and Other Leaf Cells of Vicia faba L.

The ribulose 1,5-bisphosphate carboxylase/oxygenase (Rubisco) contents of guard cells and other cells of Vicia faba L. leaflet were determined. To prevent proteolysis, proteins of frozen protoplast preparations or of cells excised from freeze-dried leaf were extracted directly in a sodium-dodecyl-sulfate-containing solution, which was heated immediately after sample addition. Protein profiles of the different cell types were obtained by electrophoresis of the extracts and subsequent densitometry of the stained protein bands. About one-third of the protein of palisade parenchyma and of spongy parenchyma was Rubisco large subunit. Using chlorophyll (Chl):protein ratios previously obtained, we calculate mesophyll contained ca. 22 millimoles Rubisco per mole Chl. In contrast, guard-cell protoplast preparations were calculated to contain from 0.7 to 2.2 millimoles Rubisco per mole Chl. The upper end of this range is an overestimate resulting from contamination by mesophyll and to the method of peak integration. Extracts of excised guard cells were calculated to contain 0.05 to 0.17 millimole Rubisco per mole Chl. We conclude that Rubisco is absent, or virtually so, in guard cells of V. faba.

Improved staining of proteins in polyacrylamide gels including isoelectric focusing gels with clear background at nanogram sensitivity using Coomassie Brilliant Blue G-250 and R-250.

An improved procedure for staining of proteins following separation in polyacrylamide gels is described which utilizes the colloidal properties of Coomassie Brilliant Blue G-250 and R-250. The new method is based on addition of 20% v/v methanol and higher concentrations of ammonium sulfate to the staining solution previously described. The method combines the advantage of much shorter staining time with high sensitivity, a clear background not requiring destaining, stepwise staining, and stable fixation after staining. The method has been applied to staining of polyacrylamide gels after sodium dodecyl sulfate-electrophoresis and isoelectric focusing in carrier ampholyte-generated pH gradients.