Determination of the optimal location of samples on quartz tuning fork-based biosensors: a computational study.

In view of efficiency, simple operation, and affordable cost and disposability, quartz tuning fork systems form good candidates for mechanical-based biosensors in point of care applications. Based on the geometrical structure, the frequency response of the tuning fork- based sensors is dependent on the location of absorbed samples. In order to have the maximum efficiency and sensitivity, the optimized condition of sample loading on the fork structures should be considered. In this regard, here, we have determined the optimized sample location to be on the prongs of the quartz tuning fork by calculating the frequency response of the quartz tuning fork using the finite element method. From an application point of view, we have obtained an agreement between the calculational method and the experimental excitation technique of the structure. The results from our study show that by using an appropriate location for the sample, the quartz tuning fork could be exploited with high sensitivity.

Fully reconfigurable compact RF photonic filters using high-Q silicon microdisk resonators.

We present a fully reconfigurable fourth-order RF photonic filter on SOI platform with a tunable 3-dB bandwidth of 0.9-5 GHz, more than 38 dB optical out-of-band rejection, FSR up to 650 GHz, and compact size (total area 0.25 mm(2)). The center wavelength of the filter can be tuned over a wide range with a power consumption of 10 mW/nm. The filter architecture uses a unit-cell based approach to realize the desired filter specifications. The use of high-Q resonator-based components enables a dramatic reduction in size, weight and power (SWaP) of each unit cell, with the possibility of cascading a large number of these unit cells on a single chip. Thermal reconfiguration allows for low insertion loss and therefore results in the scalability of these filters. The demonstrated filter can be used in many different applications including RF photonic front-ends and high speed optical A/D conversion.

Systematic design and fabrication of high-Q single-mode pulley-coupled planar silicon nitride microdisk resonators at visible wavelengths.

High quality (Q approximately 6 x 10(5)) microdisk resonators are demonstrated in a Si(3)N(4) on SiO(2) platform at 652-660 nm with integrated in-plane wrap-around coupling waveguides to enable critical coupling to specific microdisk radial modes. Selective coupling to the first three radial modes with >20dB suppression of the other radial modes is achieved by controlling the wrap-around waveguide width. Advantages of such pulley-coupled microdisk resonators include single mode operation, ease of fabrication due to larger waveguide-resonator gaps, the possibility of resist reflow during the lithography phase to improve microdisk etched surface quality, and the ability to realize highly over-coupled microdisks suitable for low-loss delay lines and add-drop filters.

High quality planar silicon nitride microdisk resonators for integrated photonics in the visible wavelength range.

High quality factor (Q approximately 3.4 x 10(6)) microdisk resonators are demonstrated in a Si(3)N(4) on SiO(2) platform at 652-660 nm with integrated in-plane coupling waveguides. Critical coupling to several radial modes is demonstrated using a rib-like structure with a thin Si(3)N(4) layer at the air-substrate interface to improve the coupling.