Coprecipitation of Mercury from Natural Iodine-Containing Seawater for Accurate Isotope Measurement.

Oceans play a key role in the global mercury (Hg) cycle, but studies on Hg isotopes in seawater are rare due to the extremely low Hg concentration and the lack of a good preconcentration method. Here, we introduce a new coprecipitation method for separating and preconcentrating Hg from seawater for accurate isotope measurement. The coprecipitation was achieved by sequential addition of 0.5 mL of 0.5 M CuSO4, 1 mL of 0.5 M Na2S, and 1 mL of 0.5 M CuSO4 reagents, which allowed for quantitatively precipitating Hg from up to 10 L of seawater. The protocol was validated by testing synthetic solutions with varying Hg and iodide (I-) concentrations and by comparing the reaction times of various reagents added. The method resulted in a quantitative recovery of 98 ± 12% (n = 32, two standard deviations, 2 SD) and a relatively low procedure blank (103 pg of Hg, n = 8). The precipitates were filtrated and analyzed for Hg isotopes. Repeated measurements of synthetic seawaters spiked with certificated standard materials (NIST 3133 and 3177) using the entire method gave identical Hg isotope ratios with near-quantitative Hg recovery, indicating no isotope fractionation during preconcentration. A total of six nearshore seawater samples from the Yellow Sea and the Bohai Sea (China) were analyzed using the coprecipitation method. The data showed a large fractionation of Hg isotopes and revealed the possible impact of both atmospheric and anthropogenic inputs to the coastal seawater Hg budget, implying the potential application of this method in studying marine Hg systematics and global Hg cycling.

Improved analysis of micro- and nanomole-scale sulfur multi-isotope compositions by gas source isotope ratio mass spectrometry.

RATIONALE: Multiple sulfur isotope compositions are usually measured on relatively large samples (in the range of micromoles); however, sometimes only small amounts are available and thus it is necessary to analyze small (sub-micromole) samples. We report an improved method to measure multiple sulfur isotope compositions: δ(33) S, δ(34) S and δ(36) S values on the SF6 molecule (m/z 127, 128, 129, 131) for quantities down to 0.1 micromole, and δ(33) S and δ(34) S values for quantities down to 20 nanomoles. METHODS: Multiple sulfur isotope analyses including fluorination and purification of two international Ag2 S standards, IAEA-S1 and IAEA-S3, were carried out at various low concentrations on a dual-inlet isotope ratio mass spectrometer using a microvolume and modified resistor capacities. RESULTS: The analyses yielded a narrow range of δ(34) S values vs CDT (the international standard), with an overall standard deviation of ±0.2 ‰, which was within the range of certified values. This demonstrates the feasibility of determining both Δ(33) S and Δ(36) S values on the sub-micromole scale, and Δ(33) S values on the nanomole scale with similar accuracy to conventional dual-inlet analyses. CONCLUSIONS: The analysis of the three S-isotope ratios on the SF6 molecule using the so-called conventional fluorination method and dual-inlet ion ratio mass spectrometry is reliable for sample sizes down to ~20 nanomoles. Despite being close to the theoretical limits for maintaining the viscous flow regime of gas in the capillary, errors were not limited by counting statistics, but probably relate to sample gas purification. Copyright © 2016 John Wiley & Sons, Ltd.