Using underutilized residues of coffee to obtain valuable dietary and antioxidant bioactive compounds.

BACKGROUND: Coffee cultivation and agroindustry generate residues that are rich in several metabolites. These compounds, such as phenolic compounds and alkaloids, are known for their antioxidant activity and are usually consumed as nutraceuticals. The purpose of this study was to evaluate the occurrence of chemical and antioxidant components of low-pruned coffee stems under different fertilizer regimes. Extractives and lignin composition, histochemical, chromatographic, and antioxidant analyses were performed. RESULTS: Multiple compounds were found to accumulate in the stems of coffee trees. Furthermore, the presence of phenolic compounds such as chlorogenic acid, vanillin, resveratrol, and the alkaloids caffeine and trigonelline varied depending on the type of fertilization. In all samples examined, optimal performance was observed at the highest tested concentration (500 µg mL-1 ). All samples analyzed presented a great performance at the highest concentration tested (500 µg mL-1 ), with the dose 70% and the dose 100%, which is the recommended for the culture, showing the highest values for most of the concentrations and the best half-maximal inhibitory concentration (IC50 ) when compared with the other samples tested. CONCLUSION: As shown in the results, the reuse of stem residues as antioxidant material, with the potential to be profitable, and has the added benefit of providing a sustainable destination for material that until now has been underutilized. © 2023 Society of Chemical Industry.

Yield loss during bleaching of pulp of Pinus radiata previously delignified with oxygen.

The pulp bleaching process removes or transforms the chromophore groups in the pulp, so that the final product reaches a desired brightness. However, this chemical treatment inevitably results in yield loss. Therefore, the objective of this work was to quantify the yield loss caused during the bleaching of kraft pulp of Pinus radiata delignified with oxygen. The material was submitted to three distinct ECF sequences (D0(EPO)D1D2, D0(EPO)D1P, and Z/EDP). At the end of each bleaching stage, the pulp brightness and the loss of gravimetric yield of the process were determined, and the generated filtrates were collected. From these filtrates, the pollutant load of the effluent was determined by measuring the content of total dissolved solids, the chemical oxygen demand, the concentration of total organic carbon carbon, and the adsorbable organic halogens. Among the whole sequences, the Z/EDP sequence had the lowest gravimetric yield, the highest pollutant load in the collected filtrate, and lowest potential for adsorbable organic halogens generation. There was good correlation between the loss of yield from the bleaching process and the organic load of the generated effluent; and among the techniques studied, the quantification of total organic carbon was the most appropriate method for the indirect quantification of the yield loss during the bleaching process of the studied material.