Low-latency wavelength-switched clock-synchronized intra-data center interconnects enabled by hollow core fiber.

Fast (nanoseconds) optical wavelength switching is emerging as a viable solution to scaling the size and capacity of intra-data center interconnection. A key enabling technology for such systems is low-jitter optical clock synchronization, which enables sub-nanosecond clock and data recovery for optically switched frames using low-cost methods such as clock phase caching. We propose and demonstrate real-time low-latency wavelength-switched clock-synchronized intra-data center interconnection at 51.2 GBd using a fast tunable laser (with ns scale switching time) and ultra-stable-latency hollow core fiber (HCF) for optically-switched data center networks. For wavelength-switched systems, we achieve a physical layer latency below 46 ns, consisting of 28 ns transceiver latency and a 18 ns inter-packet gap. Finally, we show that by exploiting the low chromatic dispersion and thermally-stable latency features of HCF, active clock phase tracking can be entirely eliminated.

Maximization or leveling: characterization of the trade-offs for the transmission throughput in ultrawideband optical transmission.

In ultrawideband transmission, the overall noise comes from the amplification, fiber properties at different wavelengths, and stimulated Raman scattering, and its impact on channels across transmission bands is different. This requires a range of methods to mitigate the noise impact. Performing channel-wise power pre-emphasis and constellation shaping, one can compensate for the noise tilt and attain maximum throughput. In this work, we study the trade-off between the goals of maximizing the total throughput and leveling the transmission quality for different channels. We use an analytical model for multi-variable optimization and identify the penalty from constraining the mutual information variation.

2048-QAM transmission at 15 GBd over 100 km using geometric constellation shaping.

We experimentally investigated a pilot-aided digital signal processing (DSP) chain in combination with high-order geometric constellation shaping to increase the achievable information rates (AIRs) in standard intradyne coherent transmission systems. We show that the AIR of our system at 15 GBd was maximised using geometrically-shaped (GS) 2048 quadrature amplitude modulation (QAM), reaching 18.0 b/4D-symbol in back-to-back transmission and 16.9 b/4D-symbol after transmission through 100 km of a single-mode fibre after subtracting the pilot overhead (OH). This represents the highest-order GS format demonstrated to date, supporting the highest AIR of any standard intradyne system using conventional optics and 8-bit electronics. Detailed characterisation of the DSP, transceiver performance, and transmission modelling has also been carried out to provide insight into sources of impairments and directions for further improvement.

AI-optimised tuneable sources for bandwidth-scalable, sub-nanosecond wavelength switching.

Wavelength routed optical switching promises low power and latency networking for data centres, but requires a wideband wavelength tuneable source (WTS) capable of sub-nanosecond switching at every node. We propose a hybrid WTS that uses time-interleaved tuneable lasers, each gated by a semiconductor optical amplifier, where the performance of each device is optimised using artificial intelligence. Through simulation and experiment we demonstrate record wavelength switch times below 900 ps across 6.05 THz (122×50 GHz) of continuously tuneable optical bandwidth. A method for further bandwidth scaling is evaluated and compared to alternative designs.

Performance of momentum-based frequency-domain MIMO equalizer in the presence of feedback delay.

A frequency-domain multiple-input multiple-output (FD-MIMO) equalizer employing a momentum-based gradient descent update algorithm is proposed for polarization multiplexing coherent receivers. Its performance in operation with dynamically varying optical channels is investigated and the impact of filter update delays, arising from the latency of the fast Fourier transforms (FFTs) and other digital signal processing (DSP) operations in the feedback loop, is assessed. We show that the proposed momentum-based gradient descent algorithm used to control the equalizer response has significantly greater tolerance to feedback delay than the conventional gradient descent algorithm. We considered a 92 Gbaud dual-polarization 64 QAM receiver, with DSP operating at two samples per symbol, and with the equalizer operating on blocks of 512 and 1024 samples (i.e., 512/1024-point FFT). We found that at an optical signal-to-noise power ratio (OSNR) of 35 dB, the momentum-based gradient descent algorithm can successfully track state-of-polarization (SOP) rotation at frequencies of up to 50 kHz and with filter update delays of up to 14 blocks (39 ns). In comparison, using the conventional gradient descent algorithm in an otherwise identical receiver, the equalizer performance starts to deteriorate at SOP rotation frequencies above 20 kHz.

End-to-end optimized transmission over dispersive intensity-modulated channels using bidirectional recurrent neural networks.

We propose an autoencoding sequence-based transceiver for communication over dispersive channels with intensity modulation and direct detection (IM/DD), designed as a bidirectional deep recurrent neural network (BRNN). The receiver uses a sliding window technique to allow for efficient data stream estimation. We find that this sliding window BRNN (SBRNN), based on end-to-end deep learning of the communication system, achieves a significant bit-error-rate reduction at all examined distances in comparison to previous block-based autoencoders implemented as feed-forward neural networks (FFNNs), leading to an increase of the transmission distance. We also compare the end-to-end SBRNN with a state-of-the-art IM/DD solution based on two level pulse amplitude modulation with an FFNN receiver, simultaneously processing multiple received symbols and approximating nonlinear Volterra equalization. Our results show that the SBRNN outperforms such systems at both 42 and 84 Gb/s, while training fewer parameters. Our novel SBRNN design aims at tailoring the end-to-end deep learning-based systems for communication over nonlinear channels with memory, such as the optical IM/DD fiber channel.

Experimental characterization of nonlinear interference noise as a process of intersymbol interference.

We demonstrate a method for experimentally characterizing the second order statistics of nonlinear interference noise (NLIN) as an intersymbol interference (ISI) process. The method enables measurement of the properties of high-order ISI coefficients, which have been largely overlooked in the past. The ability of measuring these statistics is imperative for designing effective NLIN mitigation schemes. The variance, temporal correlation times, and cross correlations of the various ISI coefficients are evaluated in several system implementations.

Digital nonlinearity compensation in high-capacity optical communication systems considering signal spectral broadening effect.

Nyquist-spaced transmission and digital signal processing have proved effective in maximising the spectral efficiency and reach of optical communication systems. In these systems, Kerr nonlinearity determines the performance limits, and leads to spectral broadening of the signals propagating in the fibre. Although digital nonlinearity compensation was validated to be promising for mitigating Kerr nonlinearities, the impact of spectral broadening on nonlinearity compensation has never been quantified. In this paper, the performance of multi-channel digital back-propagation (MC-DBP) for compensating fibre nonlinearities in Nyquist-spaced optical communication systems is investigated, when the effect of signal spectral broadening is considered. It is found that accounting for the spectral broadening effect is crucial for achieving the best performance of DBP in both single-channel and multi-channel communication systems, independent of modulation formats used. For multi-channel systems, the degradation of DBP performance due to neglecting the spectral broadening effect in the compensation is more significant for outer channels. Our work also quantified the minimum bandwidths of optical receivers and signal processing devices to ensure the optimal compensation of deterministic nonlinear distortions.

Investigation of bandwidth loading in optical fibre transmission using amplified spontaneous emission noise.

The use of spectrally shaped amplified spontaneous emission noise (SS-ASE) as a method for emulating interfering channels in optical fibre transmission systems has been studied. It is shown that the use of SS-ASE leads to a slightly pessimistic performance relative to the use of conventionally modulated interfering channels in the nonlinear regime. The additional nonlinear interference noise (on the channel under test), due to the Gaussian nature of SS-ASE, has been calculated using a combination of the Gaussian noise (GN) and enhanced GN (EGN) models for the entire C-band (4.5 THz) and experimentally shown to provide a lower bound for transmission performance.

Span length and information rate optimisation in optical transmission systems using single-channel digital backpropagation.

The optimisation of span length when designing optical communication systems is important from both performance and cost perspectives. In this paper, the optimisation of inter-amplifier spacing and the potential increase of span length at fixed information rates in optical communication systems with practically feasible nonlinearity compensation schemes have been investigated. It is found that in DP-16QAM, DP-64QAM and DP-256QAM systems with practical transceiver noise limitations, single-channel digital backpropagation can allow a 50% reduction in the number of amplifiers without sacrificing information rates compared to systems with optimal span lengths and linear compensation.

Modeling of nonlinearity-compensated optical communication systems considering second-order signal-noise interactions.

An analytical model considering modulation-dependent nonlinear effects and second-order interactions between signal and optical amplifier noise is presented for Nyquist-spaced wavelength-division-multiplexing optical communication systems. System performance of dual-polarization modulation formats, such as DP-QPSK, DP-16QAM, and DP-64QAM, is investigated using both the analytical model and numerical simulations. A good agreement between analytical and numerical results shows that, in the case of full-field nonlinearity compensation, accounting for second-order interactions becomes essential to predict system performance of both single- and multi-channel systems at optimum launched powers and beyond. This effect is validated via numerical simulations for signal bandwidths up to ∼1 THz.

Achievable rate degradation of ultra-wideband coherent fiber communication systems due to stimulated Raman scattering.

As the bandwidths of optical communication systems are increased to maximize channel capacity, the impact of stimulated Raman scattering (SRS) on the achievable information rates (AIR) in ultra-wideband coherent WDM systems becomes significant, and is investigated in this work, for the first time. By modifying the GN-model to account for SRS, it is possible to derive a closed-form expression that predicts the optical signal-to-noise ratio of all channels at the receiver for bandwidths of up to 15 THz, which is in excellent agreement with numerical calculations. It is shown that, with fixed modulation and coding rate, SRS leads to a drop of approximately 40% in achievable information rates for bandwidths higher than 15 THz. However, if adaptive modulation and coding rates are applied across the entire spectrum, this AIR reduction can be limited to only 10%.

Digital back-propagation for nonlinearity mitigation in distributed Raman amplified links.

The performance of digital back-propagation (DBP) for distributed Raman amplified optical communication systems is evaluated through analytical models and numerical simulations, and is compared with conventional lumped amplifier solutions, such as EDFA. The complexity of the DBP algorithm including the characteristic signal power profile of distributed Raman amplifiers is assessed. The use of full-field DBP in distributed Raman amplified systems leads to 1.3 dB additional gain with respect to systems employing lumped amplification, at the cost of only a 25% increase in complexity.

Modulation format dependence of digital nonlinearity compensation performance in optical fibre communication systems.

The relationship between modulation format and the performance of multi-channel digital back-propagation (MC-DBP) in ideal Nyquist-spaced optical communication systems is investigated. It is found that the nonlinear distortions behave independent of modulation format in the case of full-field DBP, in contrast to the cases of electronic dispersion compensation and partial-bandwidth DBP. It is shown that the minimum number of steps per span required for MC-DBP depends on the chosen modulation format. For any given target information rate, there exists a possible trade-off between modulation format and back-propagated bandwidth, which could be used to reduce the computational complexity requirement of MC-DBP.

On the bandwidth dependent performance of split transmitter-receiver optical fiber nonlinearity compensation.

The Gaussian noise model is used to estimate the performance of three digital nonlinearity compensation (NLC) algorithms in C-band, long-haul, optical fiber transmission, when the span length and NLC bandwidth are independently varied. The algorithms are receiver-side digital backpropagation (DBP), transmitter-side DBP (digital precompensation), and Split NLC (an equal division of DBP between transmitter and receiver). For transmission over 100×100 km spans, the model predicts a 0.2 dB increase in SNR when applying Split NLC (versus DBP) to a single 32 GBd channel (from 0.4 dB to 0.6 dB), monotonically increasing with NLC bandwidth up to 1.6 dB for full-field NLC. The underlying assumptions of this model and the practical considerations for implementation of Split NLC are discussed. This work demonstrates, theoretically, that, regardless of the transmission scenario, it is always beneficial to divide NLC between transmitter and receiver, and identifies the transmission regimes where Split NLC is particularly advantageous.

On the limits of digital back-propagation in the presence of transceiver noise.

This paper investigates the impact of transceiver noise on the performance of digital back-propagation (DBP). A generalized expression to estimate the signal-to-noise ratio (SNR) obtained using DBP in the presence of transceiver noise is described. This new expression correctly accounts for the nonlinear beating between the transceiver noise and the signal in the optical fiber transmission link. The transceiver noise-signal nonlinear beating has been identified as the main reason for the discrepancy between predicted and practical performance of DBP; which has not been previously suggested. This nonlinear beating has been included in the GN model, allowing DBP gains in practical systems to be predicted analytically. Experiments and split-step simulations with and without polarization-mode dispersion (PMD) in the transmission link have been performed. The results show that the impact of transceiver noise greatly outweighs that of PMD, and the analytical expressions are confirmed by the numerical simulations.

Achievable information rates estimates in optically amplified transmission systems using nonlinearity compensation and probabilistic shaping.

Achievable information rates (AIRs) of wideband optical communication systems using a ∼40 nm (∼5 THz) erbium-doped fiber amplifier and ∼100 nm (∼12.5 THz) distributed Raman amplification are estimated based on a first-order perturbation analysis. The AIRs of each individual channel have been evaluated for DP-64QAM, DP-256QAM, and DP-1024QAM modulation formats. The impact of full-field nonlinear compensation (FF-NLC) and probabilistically shaped constellations using a Maxwell-Boltzmann distribution were studied and compared to electronic dispersion compensation. It has been found that a probabilistically shaped DP-1024QAM constellation, combined with FF-NLC, yields achievable information rates of ∼75 Tbit/s for the EDFA scheme and ∼223 Tbit/s for the Raman amplification scheme over a 2000 km standard single-mode fiber transmission.

Digital backpropagation accounting for polarization-mode dispersion.

Digital backpropagation (DBP) is a promising digital-domain technique to mitigate Kerr-induced nonlinear interference. While it successfully removes deterministic signal-signal interactions, the performance of ideal DBP is limited by stochastic effects, such as polarization-mode dispersion (PMD). In this paper, we consider an ideal full-field DBP implementation and modify it to additionally account for PMD; reversing the PMD effects in the backward propagation by passing the reverse propagated signal also through PMD sections, which concatenated equal the inverse of the PMD in the forward propagation. These PMD sections are calculated analytically at the receiver based on the total accumulated PMD of the link estimated from channel equalizers. Numerical simulations show that, accounting for nonlinear polarization-related interactions in the modified DBP algorithm, additional signal-to-noise ratio gains of 1.1 dB are obtained for transmission over 1000 km.