ABSTRACT
Thanks to their small sensing volume, nanosensors based on localized surface plasmon resonances (LSPR) allow the detection of minute amounts of analytes, down to the single-molecule limit. However, the detected analytes are often large molecules, such as proteins. The detection of small molecules remains largely unexplored. Here, we use a hybrid photonic-plasmonic nanosensor to detect a small target molecule (pyridine). The sensor's design is based on a dielectric photonic microstructure acting as an antenna, which efficiently funnels light toward a plasmonic transducer and enhances the detection efficiency. This sensor exhibits a limit of detection as small as 10-14 mol L-1. Using a calibration procedure based on electrodynamical numerical simulations, we compute the number of detected molecules. This yields a limit of detection in mass of 4 zeptograms (1 zg = 10-21 g), a record value for plasmonic molecular sensors. Our system can hence be seen as an optical molecular weighing scale, enabling room temperature detection of mass at the zeptogram scale.
Subject(s)
Limit of Detection , Nanotechnology/instrumentation , Photons , Pyridines/analysis , Surface Plasmon Resonance/instrumentationABSTRACT
Metallic nanoparticles are considered as active supports in the development of specific chemical or biological biosensors. Well-organized nanoparticles can be prepared either through expensive (e.g., electron beam lithography) or inexpensive (e.g., thermal synthesis) approaches where different shapes of nanoparticles are easily obtained over large solid surfaces. Herein, the authors propose a low-cost thermal synthesis of active plasmonic nanostructures on thin gold layers modified glass supports after 1 h holding on a hot plate (~350 °C). The resulted annealed nanoparticles proved a good reproducibility of localized surface plasmon resonance (LSPR) and surface enhanced Raman spectroscopy (SERS) optical responses and where used for the detection of low concentrations of two model (bio)chemical molecules, namely the human cytochrome b5 (Cyt-b5) and trans-1,2-bis(4-pyridyl)ethylene (BPE).
Subject(s)
Nanostructures , Gold , Reproducibility of Results , Spectrum Analysis, Raman , Surface Plasmon ResonanceABSTRACT
We report here an original single-step process for the synthesis and self-organization of gold colloids by simply incorporating gold salts into a solution prepared using polystyrene (PS)-polymethylmethacrylate copolymer and thiolated PS with propylene glycol methyl ether acetate as a solvent. The spin-coating and annealing of this solution then allows the formation of PS domains. Depending on the polymer concentration of the as-prepared solution, there can be either one or several gold nanoparticles (Au NPs) per PS domain. For high concentrations of Au NPs in PS domains, the coupling between plasmonic NPs leads to the observation of a second peak in the optical extinction spectrum. Such a collective effect could be relevant for the development of optical strain sensors in the near future.
Subject(s)
Gold Colloid/chemical synthesis , Metal Nanoparticles , Methacrylates/chemistry , Polystyrenes/chemistry , Metal Nanoparticles/ultrastructureABSTRACT
A commercial TEM grid was used as a mask for the creation of extremely well-organized gold micro-/nano-structures on a glass substrate via a high temperature annealing process at 500 °C. The structured substrate was (bio)functionalized and used for the high throughput LSPR immunosensing of different concentrations of a model protein named bovine serum albumin.
Subject(s)
Gold/chemistry , High-Throughput Screening Assays/methods , Metal Nanoparticles/chemistry , Serum Albumin, Bovine/analysis , Animals , Cattle , Cost-Benefit Analysis , Gold/economics , High-Throughput Screening Assays/economics , Metal Nanoparticles/economics , Nanostructures/chemistry , Nanostructures/economicsABSTRACT
We show both numerically and experimentally that intense, narrow, and low-divergence beams of light are produced at the apex of dielectric pyramid-shaped microtips. These beams exhibit a Bessel transverse profile but are narrower than the usual Bessel beam, allowing for a significant enhancement of the light intensity inside the beam. They are generated by axicon-like structures with submicrometric height imprinted in glass by combining optical lithography and chemical etching. The resulting beams are experimentally imaged using fluorescence microscopy, in remarkable agreement with numerical computations.
ABSTRACT
We report here a real-time study of interactions induced phase separation between ß-lactoglobulin (BLG) and Acacia gum (AG) by analyzing the localized surface plasmon resonance of silver nanoparticles. We showed that the binding of BLG to AG is accompanied by refractive index changes, in relation with optical properties and structural changes of the complexes formed.
Subject(s)
Biopolymers/chemistry , Gum Arabic/chemistry , Gum Arabic/isolation & purification , Hydrogen-Ion Concentration , Lactoglobulins/chemistry , Lactoglobulins/isolation & purification , Metal Nanoparticles/chemistry , Silver/chemistry , Surface Plasmon ResonanceABSTRACT
The paper shows the different methods to attach a molecule to detect streptavidin to a dielectric particle made of a rare-earth oxide core and a polysiloxane shell containing fluorescein. First, the detection of streptavidin binding on a biotinylated gold substrate can be achieved in three ways: the shift of the surface plasmon resonance of the substrate and the double luminescence (organic and inorganic) of the core/shell particle. Second, these detections are efficient even after elimination upon thermal annealing of all the undesired molecules that skew the assays. Finally, the particle that ballasts the protein enhances its binding kinetics and increases the localized surface plasmon resonance shift that detects the binding.