Calcium-phosphorus interactions at a nano-structured silicate surface.

Nano-structured calcium silicate (NCS), a highly porous material synthesized by controlled precipitation from geothermal fluids or sodium silicate solution, was developed as filler for use in paper manufacture. NCS has been shown to chemisorb orthophosphate from an aqueous solution probably obeying a Freundlich isotherm with high selectivity compared to other common environmental anions. Microanalysis of the products of chemisorption indicated there was significant change from the porous and nano-structured morphology of pristine NCS to fibrous and crystalline morphologies and non-porous detritus. X-ray diffraction analysis of the crystalline products showed it to be brushite, CaHPO42H2O, while the largely X-ray amorphous component was a mixture of calcium phosphates. A two-step mechanism was proposed for the chemisorption of phosphate from an aqueous solution by NCS. The first step, which was highly dependent on pH, was thought to be desorption of hydroxide ions from the NCS surface. This was kinetically favoured at lower initial pH, where the predominant form of phosphate present was H2PO(-)4, and led to decreased phosphorus uptake with increasing pH. The second step was thought to be a continuing chemisorption process after stabilization of the pH-value. The formation of brushite as the primary chemisorption product was found to be consistent with the proposed mechanism.

Arylthiazylamides: syntheses, structures, and bonding properties.

Air-sensitive, thermally unstable tris(dimethylamino)sulfonium (TAS) salts (3) of the title anions [ArNSN]- have been prepared from corresponding sulfurdiimides Ar-N=S=N-SiMe3 (2) by Si-N bond cleavage with [(Me2N)3S]-[Me3SiF2]- (TASF). They are characterized by low-temperature X-ray crystallography as Z isomers. Because of the very short terminal S-N distance (144.2 (3h)-147.9 (3i)pm) and the relatively long internal S-N distance (158.3 (3i)-160.3 (3c) pm) the [ArNSN]- ions should be regarded as thiazylamides 1b, rare species containing a S triple bond N triple bond. A bonding model is developed and the experimental results are compared with those of restricted Hartree-Fock (RHF), density functional theory (DFT), and Møller-Plesset second-order (MP2) calculations.

Structure of the SO(2)F(-) anion, a problem case.

Recently, room-temperature crystal structures of SO(2)F(-) in its K(+) and Rb(+) salts were published in Z. Anorg. Allg. Chem. 1999, 625, 385 and claimed to represent the first reliable geometries for SO(2)F(-). However, their almost identical S-O and S-F bond lengths and O-S-O and O-S-F bond angles are in sharp contrast to the results from theoretical calculations. To clarify this discrepancy, the new [(CH(3))(2)N](3)SO(+) and the known [N(CH(3))(4)(+)], [(CH(3))(2)N](3)S(+), and K(+) salts of SO(2)F(-) were prepared and their crystal structures studied at low temperatures. Furthermore, the results from previous RHF and MP2 calculations were confirmed at the RHF, B3LYP, and CCSD(T) levels of theory using different basis sets. It is shown that all the SO(2)F(-) salts studied so far exhibit varying degrees of oxygen/fluorine and, in some cases, oxygen-site disorders, with [(CH(3))(2)N](3)SO(+)SO(2)F(-) at 113 K showing the least disorder with r(S-F) - r(S-O) = 17 pm and angle(O-S-O) - angle(F-S-O) = 6 degrees. Refinement of the disorder occupancy factors and extrapolation of the observed bond distances for zero disorder resulted in a geometry very close to that predicted by theory. The correctness of the theoretical predictions for SO(2)F(-) is further supported by the good agreement between the calculated and the experimentally observed vibrational frequencies and their comparison with those of isoelectronic ClO(2)F. A normal coordinate analysis of SO(2)F(-) confirms the weakness of the S-F bond with a stretching force constant of only 1.63 mdyn/A and shows that there is no highly characteristic S-F stretching mode. The S-F stretch strongly couples with the SO(2) deformation modes and is concentrated in the two lowest a' frequencies.

TAS+(Z)-Me3CNSN- and TAS+(E)-Me3SiNSN-: does the anion-cation interaction influence the configuration?

TAS+ salts (TAS = (Me2N)3S) of the sulfur diimide anions Me3XNSN- (X = C (1a), Si (1b)) were prepared by Si-N bond cleavage from the corresponding sulfur diimides Me3XNSNSiMe3 and TAS-fluoride ((Me2N)3S+Me3SiF2-) and characterized by X-ray crystallography and multinuclear NMR spectroscopy. According to the experimentally determined bond lengths and theoretical calculations, the Me3XNSN- anions are best described as thiazylamides Me3X-N-S identical to N rather than sulfur diimides Me3X-N=S=N. In agreement with the calculated and experimentally determined structures of the isoelectronic thionylimides RNSO, 1a adopts the Z-configuration, which is electronically favored due to anomeric effects. The electronically disfavored E-configuration of 1b in the solid state can be explained by weak anion-cation interaction.