ABSTRACT
Tricomb spectroscopy unveils a new dimension to standard linear and nonlinear spectroscopic analysis, offering the possibility to reveal the almost real-time evolution of complex systems with unprecedented accuracy. Current triple comb configurations are based on the use of mode-locked lasers, which impose constraints on the comb parameters, and require complex electronic synchronization, thus limiting potential applications. In this paper, we present the experimental demonstration of a new type of all-fiber, self-phase-locked, frequency-agile tri-comb light source. It is based on the nonlinear spectral broadening of three electro-optic modulator-based frequency combs in a three-core fiber. The exploitation of spatial multiplexing of light in optical fibers offers new possibilities to generate broadband-frequency combs that are highly coherent with each other. After characterizing the stability of the source and performing several dual-comb test measurements, we revealed the high mutual coherence between the three combs through the demonstration of a 2-D pump-probe four-wave mixing spectroscopy experiment.
ABSTRACT
Cerium-doped-silica glasses are widely used as ionizing radiation sensing materials. However, their response needs to be characterized as a function of measurement temperature for application in various environments, such as in vivo dosimetry, space and particle accelerators. In this paper, the temperature effect on the radioluminescence (RL) response of Cerium-doped glassy rods was investigated in the 193-353 K range under different X-ray dose rates. The doped silica rods were prepared using the sol-gel technique and spliced into an optical fiber to guide the RL signal to a detector. Then, the experimental RL levels and kinetics measurements during and after irradiation were compared with their simulation counterparts. This simulation is based on a standard system of coupled non-linear differential equations to describe the processes of electron-hole pairs generation, trapping-detrapping and recombination in order to shed light on the temperature effect on the RL signal dynamics and intensity.
ABSTRACT
We report a bending-insensitive multi-core fiber (MCF) for lensless endoscopy imaging with modified fiber geometry that enables optimal light coupling in and out of the individual cores. In a previously reported bending insensitive MCF (twisted MCF), the cores are twisted along the length of the MCF allowing for the development of flexible thin imaging endoscopes with potential applications in dynamic and freely moving experiments. However, for such twisted MCFs the cores are seen to have an optimum coupling angle which is proportional to their radial distance from the center of the MCF. This brings coupling complexity and potentially degrades the endoscope imaging capabilities. In this study, we demonstrate that by introducing a small section (1 cm) at two ends of the MCF, where all the cores are straight and parallel to the optical axis one can rectify the above coupling and output light issues of the twisted MCF, enabling the development of bend-insensitive lensless endoscopes.
ABSTRACT
In this work, we demonstrate and evaluate a new design of micro-structured core erbium-doped few-mode fiber to be used as optical amplifier in the context of mode-division multiplexing. This concept is proposed so as to better control the distribution of the Er3+ ions in the core area, thus permitting to adjust the overall differential modal gains between the different signal modes. The design presented here consists of 19 erbium-doped inclusions embedded in a pedestal geometry guiding 10 modes in the C-band. It has been optimized numerically so as to reach the equalized amplification of all the signal modes. The fiber has been realized and combined with custom-made dual-wavelength mode multiplexers based on multi-plane light conversion to shape the signal and pump beams. Amplification properties have finally been evaluated experimentally.
ABSTRACT
The radiation-induced emission (RIE) of Gd3+-doped sol-gel silica glass has been shown to have suitable properties for use in the dosimetry of beams of ionizing radiation in applications such as radiotherapy. Linear electron accelerators are commonly used as clinical radiotherapy beams, and in this paper, the RIE properties were investigated under electron irradiation. A monochromator setup was used to investigate the light properties in selected narrow wavelength regions, and a spectrometer setup was used to measure the optical emission spectra in various test configurations. The RIE output as a function of depth in acrylic was measured and compared with a reference dosimeter system for various electron energies, since the dose-depth measuring abilities of dosimeters in radiotherapy is of key interest. The intensity of the main radiation-induced luminescence (RIL) of the Gd3+-ions at 314 nm was found to well represent the dose as a function of depth, and was possible to separate from the Cherenkov light that was also induced in the measurement setup. After an initial suppression of the luminescence following the electron bunch, which is ascribed to a transient radiation-induced attenuation from self-trapped excitons (STEX), the 314 nm component was found to have a decay time of approximately 1.3 ms. An additional luminescence was also observed in the region 400 nm to 600 nm originating from the decay of the STEX centers, likely exhibiting an increasing luminescence with a dose history in the tested sample.
Subject(s)
Electrons , Particle Accelerators , Radiometry , Luminescence , GlassABSTRACT
We present an all-fiber optical parametric chirped-pulse amplification integrated system delivering a single-mode polarized beam. The system makes use of a specifically designed solid-core photonic hybrid fiber (i.e., combining modified total internal reflection and photonic bandgap mechanisms) that ensures sufficient birefringence to maintain the signal polarization. Moreover, the fiber combines a large mode area to handle energetic pump pulses (without generating damage or unwanted nonlinear effects) and weak dispersion to generate parametric gain bands broad enough to amplify ultrashort pulses. An efficient parametric process allows for obtaining a very high gain (>45â dB) with an output pulse energy reaching µJ range at 1053 nm by using a single 5-m hybrid fiber amplifier.
ABSTRACT
We report the development of a silica glass single-mode polarization-maintaining fiber with birefringence induced by artificial anisotropic glass in the circular core without any external stress zones or structured cladding. The fiber core is composed of silica and germanium-doped silica nanorods ordered in submicrometer interleaved layers. The fiber has a measured cut-off wavelength at 1113â nm, phase birefringence of 0.3×10-4, and an effective mode diameter of 10.5â µm at the wavelength of 1550â nm. The polarization extinction ratio in the fiber is 20â dB at 1550â nm. The fiber is compatible with the standard SMF-28 fiber and can be easily integrated using standard fusion splicing with losses of 0.1â dB.
ABSTRACT
Radiation-induced emission of doped sol-gel silica glass samples was investigated under a pulsed 20-MeV electron beam. The studied samples were drawn rods doped with cerium, copper, or gadolinium ions, which were connected to multimode pure-silica core fibers to transport the induced luminescence from the irradiation area to a signal readout system. The luminescence pulses in the samples induced by the electron bunches were studied as a function of deposited dose per electron bunch. All the investigated samples were found to have a linear response in terms of luminescence as a function of electron bunch sizes between 10-5 Gy/bunch and 1.5×10-2 Gy/bunch. The presented results show that these types of doped silica rods can be used for monitoring a pulsed electron beam, as well as to evaluate the dose deposited by the individual electron bunches. The electron accelerator used in the experiment was a medical type used for radiation therapy treatments, and these silica rod samples show high potential for dosimetry in radiotherapy contexts.
Subject(s)
Electrons , Silicon Dioxide , Luminescence , RadiometryABSTRACT
In this Letter, we report a high-efficiency, miniaturized, ultra-fast coherent beam, combined with 3D-printed micro-optics directly on the tip of a multicore fiber bundle. The highly compact device footprint (180 µm in diameter) facilitates its incorporation into a minimally invasive ultra-thin nonlinear endoscope to perform two-photon imaging.
Subject(s)
Endoscopes , Endoscopy , Endoscopy, Gastrointestinal , Optics and Photonics , Photons , Printing, Three-DimensionalABSTRACT
We present the experimental investigation of timing jitter and relative intensity noise of a Mamyshev ring oscillator operating in the fundamental mode-lock regime. We find that both timing jitter and intensity noise spectra are correlated to the output optical power with noise increase close to the loss of the mode-locking. In addition, we have investigated the dependence of the spectral filters wavelength separation on both timing jitter and intensity noise showing a severe degradation with filters overlapping.
ABSTRACT
The incorporation of Ce3+ ions in silicate glasses is a crucial issue for luminescence-based sensing applications. In this article, we report on silica glass preforms doped with cerium ions fabricated by modified chemical vapor deposition (MCVD) under different atmospheres in order to favor the Ce3+ oxidation state. Structural analysis and photophysical investigations are performed on the obtained glass rods. The preform fabricated under reducing atmosphere presents the highest photoluminescence (PL) quantum yield (QY). This preform drawn into a 125 µm-optical fiber, with a Ce-doped core diameter of about 40 µm, is characterized to confirm the presence of Ce3+ ions inside this optical fiber core. The fiber is then tested in an all-fibered X-ray dosimeter configuration. We demonstrate that this fiber allows the remote monitoring of the X-ray dose rate (flux) through a radioluminescence (RL) signal generated around 460 nm. The response dependence of RL versus dose rate exhibits a linear behavior over five decades, at least from 330 µGy(SiO2)/s up to 22.6 Gy(SiO2)/s. These results attest the potentialities of the MCVD-made Ce-doped material, obtained under reducing atmosphere, for real-time remote ionizing radiation dosimetry.
ABSTRACT
Optically activated glasses are essential to the development of new radiation detection systems. In this study, a bulk glassy rod co-doped with Cu and Ce ions, was prepared via the sol-gel technique and was drawn at about 2000 °C into a cylindrical capillary rod to evaluate its optical and radioluminescence properties. The sample showed optical absorption and photoluminescence (PL) bands attributed to Cu+ and Ce3+ ions. The presence of these two ions inside the host silica glass matrix was also confirmed using PL kinetics measurements. The X-ray dose rate was remotely monitored via the radioluminescence (RL) signal emitted by the Cu/Ce scintillating sensor. In order to transport the optical signal from the irradiation zone to the detection located in the instrumentation zone, an optical transport fiber was spliced to the sample under test. This RL signal exhibited a linear behavior regarding the dose rate in the range at least between 1.1 mGy(SiO2)/s and 34 Gy(SiO2)/s. In addition, a spectroscopic analysis of this RL signal at different dose rates revealed that the same energy levels attributed to Cu+ and Ce3+ ions are involved in both the RL mechanism and the PL phenomenon. Moreover, integrated intensities of the RL sub-bands related to both Cu+ and Ce3+ ions depend linearly on the dose rate at least in the investigated range from 102 mGy(SiO2)/s up to 4725 mGy(SiO2)/s. The presence of Ce3+ ions also reduces the formation of HC1 color centers after X-ray irradiation.
ABSTRACT
This Letter reports on a large mode area pixelated Bragg fiber in which some high refractive index rods were replaced by boron-doped rods that allows polarization maintaining behavior while keeping single-mode behavior. The realized all-solid fiber has a core diameter of 35 µm. The fundamental mode is circular with a 25 µm mode field diameter around 1 µm wavelength, and the polarization extinction ratio reaches 30 dB. Finally, this fiber is single-mode and bendable up to a 20 cm radius with fundamental mode losses lower than 0.3 dB/m.
ABSTRACT
In this Letter, we present the first, to the best of our knowledge, experimental demonstration of high-order harmonic mode-locking of an all-fiber Mamyshev oscillator. The laser is entirely realized using standard step-index fiber. It delivers time-stable pulse trains with average powers reaching more than 100 mW at the fundamental mode-locked repetition rate (7.7 MHz) and 1.3 W at the 14th harmonic (107.8 MHz).
ABSTRACT
In third generation sequencing, the production of quality data requires the selection of molecules longer than â¼20 kbp, but the size selection threshold of most purification technologies is smaller than this target. Here, we describe a technology operated in a capillary with a tunable selection threshold in the range of 3 to 40 kbp controlled by an electric field. We demonstrate that the selection cut-off is sharp, the purification yield is high, and the purification throughput is scalable. We also provide an analytical model that the actuation settings of the filter. The selection of high molecular weight genomic DNA from the melon Cucumis melo L., a diploid organism of â¼0.45 Gbp, is then reported. Linked-read sequencing data show that the N50 phase block size, which scores the correct representation of two chromosomes, is enhanced by a factor of 2 after size selection, establishing the relevance and versatility of our technology.
Subject(s)
DNA/chemistry , Cucumis melo/genetics , DNA/genetics , Molecular Weight , Particle Size , Sequence Analysis, DNAABSTRACT
The photonic nanojet (PNJ) generated by a shaped optical fiber tip is an attractive technology for laser micro-machining. The working distance has the same order of size as the fiber core diameter; therefore, multimode (MM) fibers are generally preferred. However, the PNJ is due to the fundamental mode and, therefore, the energy coupled on the high-order modes does not contribute to the process. We demonstrate the benefit of a large-mode-area (LMA) optical fiber in the generation of the PNJ. A homemade 40 µm mode field diameter LMA fiber is compared with a 100/140 MM-shaped fiber tip. Similar micro-peaks are obtained, and an energy gain is demonstrated. The coupled energy required was eight times less intense with the LMA fiber, which may open new possibilities for laser micro- and nano-processing.
ABSTRACT
We propose and fabricate a novel ring-core photonic crystal fiber made of a circular ring core surrounded by a cladding constituted of air holes organized in a first circular ring surrounded by hexagonal ones. The fiber efficiently supports four different groups of orbital angular momentum (OAM) modes. The effective indices of spin-orbit aligned and spin-orbit anti-aligned modes in the same OAM modes group are separated by at least 2.13×10-3 at 1550 nm. The realized fiber is expected to be a good platform for applications involving OAM modes.
ABSTRACT
We experimentally demonstrate the amplification of chirped pulses in a fiber optical parametric chirped pulse amplifier up to 1 µJ. This high energy level originates from combined Raman and parametric processes in a specially designed solid core photonic bandgap fiber. Output pulses are recompressed up to 560 fs. These performances make this all-fiber system compatible with first stages of bulk amplification chains.
ABSTRACT
A simple technique for far-field single-shot noninterferometric determination of the phase transmission matrix of a multicore fiber with over 100 cores is presented. This phase retrieval technique relies on the aperiodic arrangement of the cores.
ABSTRACT
We report two-photon lensless imaging through a novel Fermat's golden spiral multicore fiber. This unique layout optimizes the sidelobe levels, field of view, crosstalk, group delay, and mode density to achieve a sidelobe contrast of at least 10.9 dB. We demonstrate experimentally the ability to generate and scan a focal point with femtosecond pulses and perform two-photon imaging.