Volcanic unrest as seen from the magmatic source: Reyðarártindur pluton, Iceland.

How the Earth's crust accommodates magma emplacement influences the signals that can be detected by monitoring volcano seismicity and surface deformation, which are routinely used to forecast volcanic eruptions. However, we lack direct observational links between deformation caused by magma emplacement and monitoring signals. Here we use field mapping and photogrammetry to quantify deformation caused by the emplacement of at least 2.5 km3 of silicic magma in the Reyðarártindur pluton, Southeast Iceland. Our results show that magma emplacement triggered minor and local roof uplift, and that magma reservoir growth was largely aseismic by piecemeal floor subsidence. The occurrence and arrangement of fractures and faults in the reservoir roof can be explained by magmatic overpressure, suggesting that magma influx was not fully accommodated by floor subsidence. The tensile and shear fracturing would have caused detectable seismicity. Overpressure eventually culminated in eruption, as evidenced by exposed conduits that are associated with pronounced local subsidence of the roof rocks, corresponding to the formation of an asymmetric graben at the volcano surface. Hence, the field observations highlight processes that may take place within silicic volcanoes, not accounted for in widely used models to interpret volcanic unrest.

Erupted frothy xenoliths may explain lack of country-rock fragments in plutons.

Magmatic stoping is discussed to be a main mechanism of magma emplacement. As a consequence of stoping, abundant country-rock fragments should occur within, and at the bottom of, magma reservoirs as "xenolith graveyards", or become assimilated. However, the common absence of sufficient amounts of both xenoliths and crustal contamination have led to intense controversy about the efficiency of stoping. Here, we present new evidence that may explain the absence of abundant country-rock fragments in plutons. We report on vesiculated crustal xenoliths in volcanic rocks that experienced devolatilisation during heating and partial melting when entrained in magma. We hypothesise that the consequential inflation and density decrease of the xenoliths allowed them to rise and become erupted instead of being preserved in the plutonic record. Our thermomechanical simulations of this process demonstrate that early-stage xenolith sinking can be followed by the rise of a heated, partially-molten xenolith towards the top of the reservoir. There, remnants may disintegrate and mix with resident magma or erupt. Shallow-crustal plutons emplaced into hydrous country rocks may therefore not necessarily contain evidence of the true amount of magmatic stoping during their emplacement. Further studies are needed to quantify the importance of frothy xenolith in removing stoped material.

Magma transport in sheet intrusions of the Alnö carbonatite complex, central Sweden.

Magma transport through the Earth's crust occurs dominantly via sheet intrusions, such as dykes and cone-sheets, and is fundamental to crustal evolution, volcanic eruptions and geochemical element cycling. However, reliable methods to reconstruct flow direction in solidified sheet intrusions have proved elusive. Anisotropy of magnetic susceptibility (AMS) in magmatic sheets is often interpreted as primary magma flow, but magnetic fabrics can be modified by post-emplacement processes, making interpretation of AMS data ambiguous. Here we present AMS data from cone-sheets in the Alnö carbonatite complex, central Sweden. We discuss six scenarios of syn- and post-emplacement processes that can modify AMS fabrics and offer a conceptual framework for systematic interpretation of magma movements in sheet intrusions. The AMS fabrics in the Alnö cone-sheets are dominantly oblate with magnetic foliations parallel to sheet orientations. These fabrics may result from primary lateral flow or from sheet closure at the terminal stage of magma transport. As the cone-sheets are discontinuous along their strike direction, sheet closure is the most probable process to explain the observed AMS fabrics. We argue that these fabrics may be common to cone-sheets and an integrated geology, petrology and AMS approach can be used to distinguish them from primary flow fabrics.

Nannofossils in 2011 El Hierro eruptive products reinstate plume model for Canary Islands.

The origin and life cycle of ocean islands have been debated since the early days of Geology. In the case of the Canary archipelago, its proximity to the Atlas orogen led to initial fracture-controlled models for island genesis, while later workers cited a Miocene-Quaternary east-west age-progression to support an underlying mantle-plume. The recent discovery of submarine Cretaceous volcanic rocks near the westernmost island of El Hierro now questions this systematic age-progression within the archipelago. If a mantle-plume is indeed responsible for the Canaries, the onshore volcanic age-progression should be complemented by progressively younger pre-island sedimentary strata towards the west, however, direct age constraints for the westernmost pre-island sediments are lacking. Here we report on new age data obtained from calcareous nannofossils in sedimentary xenoliths erupted during the 2011 El Hierro events, which date the sub-island sedimentary rocks to between late Cretaceous and Pliocene in age. This age-range includes substantially younger pre-volcanic sedimentary rocks than the Jurassic to Miocene strata known from the older eastern islands and now reinstate the mantle-plume hypothesis as the most plausible explanation for Canary volcanism. The recently discovered Cretaceous submarine volcanic rocks in the region are, in turn, part of an older, fracture-related tectonic episode.

Weibull-distributed dyke thickness reflects probabilistic character of host-rock strength.

Magmatic sheet intrusions (dykes) constitute the main form of magma transport in the Earth's crust. The size distribution of dykes is a crucial parameter that controls volcanic surface deformation and eruption rates and is required to realistically model volcano deformation for eruption forecasting. Here we present statistical analyses of 3,676 dyke thickness measurements from different tectonic settings and show that dyke thickness consistently follows the Weibull distribution. Known from materials science, power law-distributed flaws in brittle materials lead to Weibull-distributed failure stress. We therefore propose a dynamic model in which dyke thickness is determined by variable magma pressure that exploits differently sized host-rock weaknesses. The observed dyke thickness distributions are thus site-specific because rock strength, rather than magma viscosity and composition, exerts the dominant control on dyke emplacement. Fundamentally, the strength of geomaterials is scale-dependent and should be approximated by a probability distribution.

Ardnamurchan 3D cone-sheet architecture explained by a single elongate magma chamber.

The Palaeogene Ardnamurchan central igneous complex, NW Scotland, was a defining place for the development of the classic concepts of cone-sheet and ring-dyke emplacement and has thus fundamentally influenced our thinking on subvolcanic structures. We have used the available structural information on Ardnamurchan to project the underlying three-dimensional (3D) cone-sheet structure. Here we show that a single elongate magma chamber likely acted as the source of the cone-sheet swarm(s) instead of the traditionally accepted model of three successive centres. This proposal is supported by the ridge-like morphology of the Ardnamurchan volcano and is consistent with the depth and elongation of the gravity anomaly underlying the peninsula. Our model challenges the traditional model of cone-sheet emplacement at Ardnamurchan that involves successive but independent centres in favour of a more dynamical one that involves a single, but elongate and progressively evolving magma chamber system.