Effects of Creatine Supplementation after 20 Minutes of Recovery in a Bench Press Exercise Protocol in Moderately Physically Trained Men.

BACKGROUND: The aims of this study were to analyse the effect of creatine supplementation on the performance improvement in a bench pressing (BP) strength test of muscle failure and to evaluate muscle fatigue and metabolic stress 20 min after the exercise. METHODS: Fifty young and healthy individuals were randomly assigned to a creatine group (n = 25) or a placebo group (n = 25). Three exercise sessions were carried out, with one week of rest between them. In the first week, a progressive load BP test was performed until the individuals reached the one repetition maximum (1RM) in order to for us obtain the load-to-velocity ratio of each participant. In the second week, the participants conducted a three-set BP exercise protocol against 70% 1RM, where they performed the maximum number of repetitions (MNR) until muscle failure occurred, with two minutes of rest between the sets. After one week, and following a supplementation period of 7 days, where half of the participants consumed 0.3 g·kg-1·day-1 of creatine monohydrate (CR) and the other half consumed 0.3 g·kg-1·day-1 of placebo (PLA, maltodextrin), the protocol from the second week was repeated. After each set, and up to 20 min after finishing the exercise, the blood lactate concentrations and mean propulsive velocity (MPV) at 1 m·s-1 were measured. RESULTS: The CR group performed a significantly higher number of repetitions in Set 1 (CR = 14.8 repetitions, PLA = 13.6 repetitions, p = 0.006) and Set 2 (CR = 8 repetitions, PLA = 6.7 repetitions, p = 0.006) after supplementation, whereas no significant differences were seen in Set 3 (CR = 5.3 repetitions, PLA = 4.7 repetitions, p = 0.176). However, there was a significant increase in blood lactate at minute 10 (p = 0.003), minute 15 (p = 0.020), and minute 20 (p = 0.015) after the exercise in the post-supplementation period. Similarly, a significant increase was observed in the MPV at 1 m·s-1 in the CR group with respect to the PLA group at 10, 15, and 20 min after the exercise. CONCLUSIONS: Although the creatine supplementation improved the performance in the strength test of muscle failure, the metabolic stress and muscle fatigue values were greater during the 20 min of recovery.

Neuromuscular Fatigue and Metabolic Stress during the 15 Minutes of Rest after Carrying Out a Bench Press Exercise Protocol.

Background: Velocity loss (VL) at 1 m·s−1 can help to determine neuromuscular fatigue after performing an exercise protocol. The aim of this study was to analyse muscle fatigue and metabolic stress during the 15 min that follow the execution of a bench press (BP) exercise protocol. Methods: Forty-four healthy male students of sports science performed two exercise sessions separated by one week of rest. In the first week, the participants carried out a test with progressive loads in the (BP) exercise until reaching the one-repetition maximum (1RM) in order to obtain the load−velocity relationship of each participant. In the second week, each participant conducted three BP exercise sets at an intensity of 70% of 1RM, determining this load through the mean propulsive velocity (MPV) obtained from the individual load−velocity relationship, with the participants performing the maximum number of repetitions (MNR) to muscle failure. Two minutes of rest were allocated between sets. MPV at 1 m·s−1 and blood lactate concentrations were recorded before executing the exercise and at minute 0, 5, 10 and 15 after performing the exercise protocol. Results: A two-factor repeated measures ANOVA was performed. MPV at 1 m·s−1 in minute 0 post-exercise was −33.3% (p < 0.05), whereas in minute 10 and 15 post-exercise, it was ≈−9% (p > 0.05). Regarding the blood lactate levels, significant differences were observed in all measurements before and after the exercise protocol (p < 0.001), obtaining ≈7 mmol·L−1 at minute 10 post-exercise and 4.3 mmol·L−1 after 15 min of recovery. Conclusions: MPV with medium or moderate loads shows a certain recovery from minute 10 of rest. However, the blood lactate levels are still high (>5 mmol·L−1). Therefore, although there seem to be certain conditions to reach a similar maximum MPV peak, the residual fatigue at the neuromuscular level and the non-recovery of metabolic homeostasis would hinder the reproduction of these protocols, both at the level of applied stimulus and from a methodological perspective, since a long recovery time would be required between sets and exercises.

Physiological Responses at 15 Minutes of Recovery after a Session of Functional Fitness Training in Well-Trained Athletes.

BACKGROUND: the aim of this study was to analyse muscle fatigue and metabolic stress at 15 min of recovery after performing two independent sessions of functional fitness training (FFT): a session of strength functional fitness training (FFTstrength) and a session of endurance functional fitness training (FFTendurance). METHODS: eighteen well-trained men conducted two protocols, separated by one week of rest: FFTstrength (3 sets of 21, 15 and 9 repetitions of Thruster with bar + Pull ups) and FFTendurance (3 sets × (30 kcal rowing + 15 kcal assault air bike)). Neuromuscular fatigue and metabolic stress were measured right before, right after and at 10 and 15 min after completing the FFT workout, as well as the mean heart rate (HRmean) and the rating of perceived exertion (RPE) at the end of the FFT. RESULTS: FFTendurance recovered the velocity loss values after 15 min of recovery. On the other hand, FFTstrength only recovered velocity in the 1 m·s-1 Tests in squat (SQ), since the velocity levels were 7% lower in the 1 m·s-1 Tests in military press exercise (MP) after 15 min. CONCLUSIONS: These data indicate that there are specific recovery patterns not only as a function of the exercise and the body regions involved, but also regarding the recovery of neuromuscular and metabolic factors, since both FFT workouts obtained high blood lactate concentrations.

Muscle Recovery after a Single Bout of Functional Fitness Training.

BACKGROUND: Functional fitness training (FFT) is a new exercise modality that targets functional multi-joint actions via both muscle-strengthening exercises and aerobic training intervals. The aim of the study was to examine muscle recovery over a 20 min period after an FFT workout in trained adults. MATERIALS AND METHODS: Participants were 28 healthy trained subjects. In a single session, a countermovement jump (CMJ) was performed to determine several mechanical variables (jump height, maximum velocity, power) before (preFFT) and 4, 10, and 20 min after the FFT workout (postFFT). In parallel, capillary blood lactate concentrations were measured pre- and 3 min postFFT. Heart rate was also measured before and after the workout, and perceived exertion was measured postFFT. RESULTS: Significant differences between the time points preFFT and 4 min and 10 min postFFT, respectively, were produced in jump height (p = 0.022, p = 0.034), maximum velocity (p = 0.016, p = 0.005), average power relative (p = 0.018, p = 0.049), and average power total (p = 0.025, p = 0.049). No differences were observed in any of the variables recorded preFFT and 20 min postFFT. CONCLUSIONS: While mechanical variables indicating muscle fatigue were reduced 4 and 10 min postFFT, pre-exercise jump ability only really started to recover 20 min after FFT although not reaching pre-exercise levels. This means that ideally intervals of around 20 min of rest should be implemented between training bouts.