ABSTRACT
AIM: To investigate the necessity of placing inferior vena cava filter in systemic thrombolytic therapy for patients with acute deep vein thrombosis. METHODS: Retrospectively summarized the clinical data of patients who received urokinase for deep vein thrombosis in the Third Xiangya Hospital of Central South University from September 2006 to April 2020, and discussed the necessity of placing inferior vena cava filter. RESULTS: A total of 549 patients were enrolled, including 294 patients in the filter group (154 males, 140 females) and 255 patients in the non-filter group (126 males, 129 females). Among 268 cases of proximal DVT in the filter group, thirty-five cases were complicated with pulmonary embolism before thrombolysis; and there were 218 cases of proximal DVT in the non-filter group and 16 cases of pulmonary embolism before thrombolysis, with statistical difference between the two groups (P=0.038 and 0.023, respectively). The total amount of urokinase in the filter group was (1 636.3±910.0) thousand units, and that in the non-filter group was (1 490.2±777.2) thousand units, with statistical difference between the two groups (P=0.045). However, there were no statistical differences in the days of use of urokinase and the proportion of patients with adequate anticoagulation. In this study, among 255 patients in non-filter group underwent thrombolysis, only 1 patient developed pulmonary embolism after thrombolysis (P=0.282). CONCLUSION: Inferior vena cava filter is not always necessary for patients with acute deep vein thrombosis during systemic thrombolytic therapy.
ABSTRACT
In the present study, liquiritigenin-phospholipid complex (LPC) was developed and evaluated to increase the oral bioavailability of liquiritigenin. A single-factor test methodology was applied to optimize the formulation and process for preparing LPC. The effects of solvent, drug concentration, reaction time, temperature and drug-to-phospholipid ratio on encapsulation efficiency were investigated. LPCs were characterized by UV-visible spectroscopy, differential scanning calorimetry (DSC), fourier transform infrared spectroscopy (FTIR), and powder X-ray diffractometry (PXRD). The apparent solubility and n-octanol/water partition coefficient were tested. The pharmacokinetic characteristics and bioavailability of the LPC were investigated after oral administration in rats in comparison with liquiritigenin alone. An LPC was successfully prepared. The optimum level of various parameters for liquiritigenin-phospholipid complex was obtained at the drug concentration of 8 mg·mL
Subject(s)
Animals , Rats , Administration, Oral , Biological Availability , Flavanones/pharmacokinetics , Phospholipids/pharmacokinetics , SolventsABSTRACT
Objective To observe echocardiographic characteristics of bicuspid aortic valve (BAV) with Sievers classification.Methods Clinical and echocardiography data of 121 patients with BAV were retrospectively analyzed.According to Sievers classification,the patients were divided into type 0 (no raphe),type 1 (one raphe) or type 2 (two raphes).BAV of type 1 was further divided into three subtypes,including 1(L-R) subtype (the raphe positioned between the left and the right coronary sinuses),1(R-N) subtype (the raphe positioned between the right coronary sinus and non-coronary sinus) and 1 (N-L) subtype (the raphe positioned between the left coronary sinus and non-coronary sinus).The diameters of aorta in BAV patients with Sievers classification obtained with echocardiography were compared.Results There were 3 patients (3/121,2.48%) of type 0 and 118 patients (118/121,97.52%) of type 1 BAV.In patients of type 1 BAV,there were 80 cases (80/121,66.12%) of subtype 1 (L-R),33 (33/121,27.27%) of subtype 1 (R-N) and 5 (5/121,4.13%) of subtype 1 (N-L).There was no type 2 patient among these 121 cases.The diameters of the annulus and sinus of Valsalva in subtype 1 (R-N) BAV patients were less than those in subtype 1 (L-R) BAV (P=0.01,0.02).There was no significant difference of the diameters of the annulus,sinus of Valsalva,sinotubular junction nor the proximal ascending aorta among different subtypes of BAV (all P>0.05).Conclusion Subtype 1(L-R) is more common in BAV patients,which often associated with larger diameters of annulus and sinuses of Valsalva than subtype 1 (R-N) on echocardiography.
ABSTRACT
BACKGROUND: With the development of 3D printing technology, organ and tissue construction can be achieved by constructing a three-dimensional scaffold that is conducive to cell growth. OBJECTIVE: To solve the scaffold over-accumulation during 3D printing.METHODS: Fluent, a finite element analysis software developed by ANSYS Company in the United States, was used to analyze the extrusion process of print heads and to obtain suitable viscosity and extrusion pressure of materials for the 3D printing of cellulose gel composites. We then compared simulation results with experimental results. RESULTS AND CONCLUSION: The error between simulation results and experimental results was less than 5%. The simulated values at a kinetic viscosity of 45 and a pressure of 0.10-0.12 MPa solved the phenomenon of over-accumulation of cellulose gel composites during the 3D printing process, ensuring enough space for the 3D printed scaffold.
ABSTRACT
Objective To evaluate the feasibility of real-time threedimensional transesophageal echocardiography (RT3D TEE) in Carpentier's classification of patients with mitral regurgitation (MR).Methods Totally 124 patients with MR were divided into type Ⅰ—Ⅲ type according to Carpentier's classification,and the cases and methods of operation were followed up.Results In all of the 124 patients,9 cases were Carpentier's type Ⅰ,including 8 cases of atrial fibrillation,1 case of mitral valve cleft;102 patients were type Ⅱ,including pure mitral valve prolapse in 16 cases,mitral valve prolapse with chordae rupture in 80 cases,infective endocarditis in 6 cases;13 cases were type Ⅲ,including Ⅲa type rheumatic heart disease in 8 cases,Ⅲ b type of left ventricular systolic dysfunction in 5 cases.Totally 101 cases underwent MR surgery,including mitral valve plasty in 83 cases and valve replacement in 18 cases.Conclusion RT3D TEE is feasible and accurate in defining different types of MR,and it is useful to make management decisions and select the appropriate surgical strategy.
ABSTRACT
<p><b>OBJECTIVE</b>To investigate the feasibility of using new tracheal prosthesis made of biomaterials to replace extensive circumferential tracheal defects in mongrel dogs.</p><p><b>METHODS</b>Three types of tracheal prostheses were developed, whose basic skeleton of tubular mesh was knitted with polypropylene monofilament and poly (lactic-co-glycolic acid) fiber. The inner side of type-I tubular mesh was first coated with polyurethane solution and then with collagen. The exterior of type-I was then immobilized with collagen-hydroxyapatite composites. In contrast, the internal and external walls of type-II were coated with polyurethane solution, which produced a prosthesis similar to a nonporous one, while type-III was coated only with collagen solution. Surgical resection and replacement of a segment of the cervical trachea was performed in 16 adult mongrel dogs. The efficacy of the implanted prosthesis periodically evaluated postoperatively.</p><p><b>RESULTS</b>In group A, only one died from prosthetic dehiscence, another from anastomotic leakage, and the others had uneventful postoperative courses. The implanted prosthesis was completely incorporated with the recipient trachea, where different length of reepithelialization occurred on the luminal surface of the reconstructed trachea. Macroscopic examination showed scattered and different sizes of neo-ossification surrounding the implanted prosthesis. The prosthesis was roentgenopaque when exposed to routine X rays. In contrast, a relatively high number of complications occurred postoperatively in group B and C.</p><p><b>CONCLUSION</b>Type-I tracheal prosthesis may be used effectively for long-segment circumferential tracheal replacement, and appears very promising for clinical application, with further improvements in promoting the epithelialization.</p>
Subject(s)
Animals , Dogs , Female , Male , Biocompatible Materials , Collagen , Polyglycolic Acid , Polypropylenes , Polyurethanes , Prostheses and Implants , Prosthesis Design , Prosthesis Implantation , Trachea , General SurgeryABSTRACT
<p><b>OBJECTIVE</b>To design and develop a novel esophageal prosthesis by selecting appropriate biomaterials, developing special manufacturing techniques, and investigating the feasibility of replacement of cervical esophagus in mongrel dogs.</p><p><b>METHODS</b>In accordance with the requirements of ideal esophageal substitutes, we designed a new type of esophageal prostheses. The inner stent were made with polyurethane of medical grade, and the outer surface of the prosthesis was coated with collagen-chitosan sponge. The silicone tube was used as a control. Thirteen adult mongrel dogs that were divided into two groups were used to establish the experimental models.</p><p><b>RESULTS</b>In the experimental group (n = 8), the esophageal prostheses were completely incorporated with the native esophagus and adherent to the surrounding host connective tissues. Epithelial linings of varying degrees were formed on the luminal surface, and complete epithelization was seen in 1 month postoperatively. The granulation at the sites of the anastomosis in this group was less significant than that of the control group. One dog has been surviving for 12 months up to now without any complications. In the control group (n = 5), esophageal epithelial was not observed on the luminal surface, constriction of the regenerated esophagus progressed and all the dogs died within 2 months after operation.</p><p><b>CONCLUSION</b>These observations suggest that this esophageal prosthesis made of composite biomaterials has high biocompatibility and potential for long-segment esophageal reconstruction, which is promising for the clinical repair of esophageal defects.</p>
Subject(s)
Animals , Dogs , Absorbable Implants , Artificial Organs , Biocompatible Materials , Chitosan , Collagen , Esophagus , Implants, Experimental , Models, Animal , Polyurethanes , Prosthesis Design , Methods , Prosthesis ImplantationABSTRACT
Objective: To replace esophageal defects with artificially composed biodegradable materials and non-biodegradable materials. Met hods: A two-layered tube consisting of a collagen-chitosan sponge and an inner polyurethane stent was used to replace 5 cm esophageal segmental defect s in 15 dogs. The inner polyurethane stent was removed endoscopically at weekly intervals from 2 or 4 weeks. Results: Partial regeneration of es ophageal epithelia was observed in 5 dogs at week 2, and progressing constricti on occurred and the dogs became unable to swallow within 1 month. In the 10 dog s that the polyurethane stent was removed at week 4, regenerated esophageal tiss ue successfully replaced the defects, and complete epithelization was observed 1 month after surgery. Complete regeneration of esophageal mucosa structures, inc luding mucosal smooth muscle and mucosal glands were observed 3 months after surgery, and partial regeneration of esophageal muscle tissue was also observed 6 months after surgery. Conclusion: Our artificial prosthesis i n reconstruction of the cervical esophagus segment in dogs is feasible. Through temporary polyurethane tube, collagen-chitosan sponge provides a three-dimensi onal structure suitable for the regeneration and sufficient degradation time for the complete regeneration of esophagus.
ABSTRACT
Objective: To replace esophageal defects with artificially composed biodegradable materials and non-biodegradable materials. Met hods: A two-layered tube consisting of a collagen-chitosan sponge and an inner polyurethane stent was used to replace 5 cm esophageal segmental defect s in 15 dogs. The inner polyurethane stent was removed endoscopically at weekly intervals from 2 or 4 weeks. Results: Partial regeneration of es ophageal epithelia was observed in 5 dogs at week 2, and progressing constricti on occurred and the dogs became unable to swallow within 1 month. In the 10 dog s that the polyurethane stent was removed at week 4, regenerated esophageal tiss ue successfully replaced the defects, and complete epithelization was observed 1 month after surgery. Complete regeneration of esophageal mucosa structures, inc luding mucosal smooth muscle and mucosal glands were observed 3 months after surgery, and partial regeneration of esophageal muscle tissue was also observed 6 months after surgery. Conclusion: Our artificial prosthesis i n reconstruction of the cervical esophagus segment in dogs is feasible. Through temporary polyurethane tube, collagen-chitosan sponge provides a three-dimensi onal structure suitable for the regeneration and sufficient degradation time for the complete regeneration of esophagus.