Predictive Value of the Changes in Neutrophil-Lymphocyte Ratio for Outcomes After Off-Pump Coronary Surgery.

Purpose: The neutrophil-to-lymphocyte ratio (NLR) is an extensively analyzed prognostic inflammatory index in cardiac patients. The degree of change in NLR values before and after surgery (delta-NLR) can represent the inflammatory response induced by surgery and serve as a meaningful prognostic biomarker in surgical patients; however, this has not been well investigated. We aimed to investigate the predictive value of the perioperative NLR and delta-NLR for outcomes of off-pump coronary artery bypass (OPCAB) surgery by evaluating "days alive and out of hospital (DAOH)", a novel patient-centered outcome. Patients and Methods: In this single-center retrospective study, perioperative data, including NLR data, from 1322 patients were analyzed. The primary endpoint was DOAH at 90 days postoperatively (DAOH 90), and the secondary endpoint was long-term mortality. Linear regression analysis and Cox regression analysis were performed to identify independent risk factors for the endpoints. In addition, Kaplan-Meier survival curves were plotted to assess long-term mortality. Results: The median NLR values significantly increased from 2.2 (1.6-3.1) at baseline to 7.4 (5.4-10.3) postoperatively, with median delta-NLR values of 5.0 (3.2-7.6). Preoperative NLR and delta-NLR were independent risk factors for short DAOH 90 in the linear regression analysis. In Cox regression analysis, delta-NLR, but not preoperative NLR, was an independent risk factor for long-term mortality. When patients were divided into two groups according to delta-NLR, the high delta-NLR group had a shorter DAOH 90 than the low delta-NLR group. Kaplan-Meier curves showed higher long-term mortality in the high delta-NLR group than in the low delta-NLR group. Conclusion: In OPCAB patients, preoperative NLR and delta-NLR were significantly associated with DAOH 90, and delta-NLR was an independent risk factor for long-term mortality, indicating their role in risk assessment, which is essential for perioperative management.

Comparison of the effects of inhalational and total intravenous anesthesia on quality of recovery in patients undergoing endoscopic transsphenoidal pituitary surgery: a randomized controlled trial.

Background: Endoscopic transsphenoidal pituitary surgery has shown promising results. However, fast and high-quality recovery after this procedure remains a challenge for neuroanesthesiologists. This study aimed to compare the quality of recovery after transsphenoidal pituitary surgery between patients who received inhalational anesthesia with sevoflurane and patients who received propofol-based total intravenous anesthesia (TIVA). Methods: Eighty-two patients undergoing transsphenoidal pituitary surgery were randomized to receive either sevoflurane inhalation with manual infusion of remifentanil (sevoflurane group) or effect-site target-controlled infusion of propofol and remifentanil (TIVA group). The primary outcome was the 40-item Quality of Recovery (QoR-40) score on postoperative day 1. The QoR-40 questionnaire was completed by patients the day before surgery and on postoperative days 1 and 2. Emergence agitation and recovery characteristics were also assessed. Results: There were no significant differences between the groups in the global QoR-40 scores on both postoperative days 1 and 2 (difference -8.7, 95% CI -18.0 to 0.7, and P = 0.204; -3.6, 95% CI -13.0 to 5.8, and P > 0.999, respectively). The time to verbal response and time to extubation were significantly shorter in the sevoflurane group than in the TIVA group (P < 0.001 and P < 0.001, respectively). However, the incidence of emergence agitation was lower in the TIVA group than in the sevoflurane group (P < 0.001). Conclusions: Both inhalational anesthesia with sevoflurane and propofol-based TIVA were appropriate anesthetic techniques for patients undergoing endoscopic transsphenoidal pituitary surgery in terms of the quality of recovery up to 2 days postoperatively. Rapid emergence was observed in the sevoflurane group, while smooth emergence was observed in the TIVA group.

Pharmacodynamic analysis of intravenous bolus remimazolam for loss of consciousness in patients undergoing general anaesthesia: a randomised, prospective, double-blind study.

BACKGROUND: Remimazolam is a new rapid offset benzodiazepine used for procedural sedation and general anaesthesia. This study evaluated the efficacy and safety of i.v. bolus remimazolam during induction of anaesthesia. METHODS: A total of 120 patients undergoing general anaesthesia were randomly allocated into six dose groups (n=20) of i.v. bolus remimazolam (0.02-0.27 mg kg-1). Loss of consciousness, respiratory depression, patient state index (PSI), and haemodynamic variables were evaluated during anaesthetic induction. Parametric time-to-event models were used to identify the 50% effective dose (ED50)/95% effective dose (ED95) associated with loss of consciousness and respiratory depression. Non-linear mixed-effect models analysed the PSI and haemodynamic changes after i.v. bolus remimazolam. RESULTS: Loss of consciousness and respiratory depression onset showed steep dose-responses with ED50/ED95 of 0.11/0.19 and 0.14/0.27 mg kg-1 and Hill coefficients of 5.3 and 4.6, respectively. Older age was significantly associated with lower ED50/ED95 for both endpoints. ED50/ED95 and the Hill coefficient of PSI decline were 0.12/0.68 mg kg-1 and 1.7, respectively. We propose optimal doses of 0.25-0.33, 0.19-0.25, and 0.14-0.19 mg kg-1 in patients aged <40, 60-80, and >80 yr, respectively, based on the ED95 estimates for the corresponding age groups. The maximum percentage reduction of MAP was 27.8% and the ED50/ED95 were 0.14/2.60 mg kg-1. The effect of remimazolam on heart rate was insignificant. CONCLUSIONS: The ED50/ED95s of i.v. bolus remimazolam were successfully estimated from the time to loss of consciousness and respiratory depression. No serious adverse events occurred within the range of tested doses. CLINICAL TRIAL REGISTRATION: NCT04901871.

Effect of a Porous Suture Containing Transforming Growth Factor Beta 1 on Healing After Rotator Cuff Repair in a Rat Model.

BACKGROUND: The healing failure rate after rotator cuff repair is considerably high. PURPOSE: To evaluate the effect of a porous suture containing transforming growth factor beta 1 (TGF-ß1) on the sustained release of TGF-ß1 and rotator cuff healing in a rat model. STUDY DESIGN: Controlled laboratory study. METHODS: A porous suture was developed, and its tensile strength was measured. TGF-ß1 was delivered using the porous suture, and a TGF-ß1 release test and human fibroblast proliferation assay were performed. For the animal experiment, 30 rats were randomly allocated into 3 groups (n = 10 each). A bilateral supraspinatus tendon tear was made in all the rats, and repair was performed. Group 1 received repair only; group 2, repair and a single injection of TGF-ß1; and group 3, repair using the porous suture containing TGF-ß1. Eight weeks after repair, biomechanical and histological analyses were performed. RESULTS: The porous suture was successfully developed with mechanical properties compatible with the conventional suture, and the sustained release of TGF-ß1 from the porous suture was confirmed. In addition, the cell proliferation assay confirmed the biological safety of the porous suture. In the animal experiment, group 3 biomechanically exhibited the largest cross-sectional area and the highest ultimate failure load and ultimate stress (all P < .05). Histological examination revealed that group 3 showed significantly better collagen fiber density and tendon-to-bone maturation than did groups 1 and 2 (all P < .05). CONCLUSION: The porous suture containing TGF-ß1 could sustainedly and safely release TGF-ß1, and its use during rotator cuff repair could improve rotator cuff healing, as assessed on the basis of the biomechanical and histological changes in the rat model in this study. Considering the effectiveness, safety, and convenience of the porous suture without extra effort in surgery, the findings of the present study will have a far-reaching effect on the treatment of rotator cuff tears. CLINICAL RELEVANCE: The porous suture containing TGF-ß1 might improve healing after rotator cuff repair.

Measurement of Knee Rotation Angles Using a Smartphone Application: An Experimental Study of Porcine Knees.

PURPOSE: This study evaluated the efficacy of a smartphone application in the measurement of rotation angles in porcine knees. MATERIALS AND METHODS: Two K-wires were fixated to the femoral condyle and anterior tibial crest of 10 porcine legs. The angle created between the K-wires with an external rotation force applied was measured on a photograph and defined as the true angle. The same force was applied to the legs placed on a splint with a smartphone attached to the plantar side. The angle presented on a smartphone application was determined as the measured angle. The differences between the true and measured angles in 30° and 90° knee flexion and differences in measured angles depending on the status of the popliteus tendon were compared. RESULTS: In the intact knees, the mean true angles in 30° and 90° flexion were 20.5°±1.4° and 19.1°±1.3°, respectively, and the mean measured angles in 30° and 90° flexion were 21.1°±0.9° and 18.6°±1.6°, respectively. When the popliteus tendon was cut, the mean true angles in 30° and 90° flexion were 31.4°±1.1° and 38.5°±2.5°, respectively, and the mean measured angles in 30° and 90° flexion were 31.8°±1.2° and 39.2°±2.8°, respectively. The differences between the true and measured angles were not significant. The measured angle increased by more than 10° after cutting of the popliteus tendon in both 30° and 90° flexion. CONCLUSIONS: Using a smartphone application could be a good method of measuring knee rotation.

Radiological analysis of minimal safe distance and optimal screw angle to avoid facet violation in open-door laminoplasty using precontoured plate.

PURPOSE: This study aimed to present radiologic analysis of minimal safe distance (MSD) and optimal screw angle (OSA) that enables to fix screws in a lateral mass safely without facet joint violation in open-door laminoplasty using a plate. METHODS: A retrospective analysis was made of 22 patients (male: 17; female: 5), average age 62 years. Seventy-nine lateral mass screws were fixed among a total of 158 screws. MSD that doesn't allow 5-mm screws to violate a facet joint was measured for C3-C7 and a comparative analysis was performed. If the MSD is not secured, the OSA to be given to the cephalad direction is calculated to avoid violation of the facet joint. RESULTS: The screws violating inferior facet joints accounted for 34.1% of the screws fixed in inferior lateral mass. Joint surface to distal mini-screw distances were 3.18 ± 1.46 mm and 4.75 ± 1.71 mm in groups of facet joint violation and non-facet violation (FV), respectively ( p = 0.001). When 5-mm screws were inserted into a lateral mass, MSD was 4.39 ± 0.83 mm. The average MSD of C3, C4, and C5 was 4.05 ± 0.78 mm, 4.10 ± 0.70 mm, and 4.26 ± 0.74 mm, respectively. There was no significant differences among levels ( p > 0.05). The average MSD of C6 and C7 was 4.92 ± 0.81 mm and 4.80 ± 0.96 mm, respectively, showing significant differences from those of C3, C4, and C5 ( p < 0.05). If 6 mm of the MSD isn't secured, OSA showed in the cephalad direction of 11.5° for 5 mm and 22° for 4 mm approximately. CONCLUSION: We suggest that mini-screw on lateral mass can be fixed safely without FV, if they are fixed at MSD of 6 mm from a joint surface. Facet joint violation doesn't occur if an OSA is given in the cephalad direction in case of not enough MSD for mini-screws.

Angular deformity correction by guided growth in growing children: Eight-plate versus 3.5-mm reconstruction plate.

BACKGROUND: Guided growth using the eight-plate (8-plate) is the most commonly used method to correct angular deformities in children; however, implant failure has been reported. Recently, the 3.5-mm reconstruction plate (R-plate) has been used as an alternative option for guided growth; however, hardware prominence has been problematic. This study aimed to compare the coronal angular deformity correction results of guided growth between relatively thin 8-plates with cannulated screws and thick R-plates with solid screws. METHODS: Thirty-nine physes (24 distal femoral, 15 proximal tibial) in 20 patients underwent hemiepiphysiodesis using 8-plates, and 61 physes (40 distal femoral, 21 proximal tibial) in 35 patients underwent hemiepiphysiodesis using R-plates. Coronal angular corrections were measured and compared preoperatively, and after the completion of corrections. Amounts and rates of correction and complications were compared between the groups. RESULTS: Mean body mass index was 18.7 kg/m2 in the 8-plate group, and 22.7 kg/m2 in the R-plate group. Angular correction was achieved in all deformities at a mean of 13.7 months and 19.7 months in the 8-plate and the R-plate group, respectively. The mean corrected mechanical lateral distal femoral angle was 9.0° in the 8-plate group, and 9.9° in the R-plate group (P = 0.55). The mean corrected medial proximal tibial angle was 7.1° in the 8-plate group, and 9.0° in the R-plate group (P = 0.07). The mean rates of angular correction were also not significantly different in the distal femur (1.03°/month vs. 0.77°/month, P = 0.2) and the proximal tibia (0.66°/month vs. 0.63°/month, P = 0.77). There was one superficial infection in each group, and one case of implant failure in the R-plate group. Two rebound deformities were observed and needed repeat hemiepiphysiodesis. Permanent physeal arrest was not observed in this series.