Skeletal and Dentoalveolar Changes in Growing Patients Treated with Rapid Maxillary Expansion Measured in 3D Cone-Beam Computed Tomography.

The skeletal and dental effects of rapid maxillary expansion (RME) have been extensively studied, but high-quality research is still needed to determine the three-dimensional (3D) effects of RME. The aim of this study was to compare skeletal and dentoalveolar parameters through cone-beam computed tomography (CBCT) pre- (T1) and post-treatment (T2) with respect to RME. Twenty growing patients (mean age 10.7 years) were treated with a Hyrax-type expander. A 3D CBCT was performed at T1 and T2, measuring nasal width, maxillary width, palatal height, maxillary arch perimeter, angulation of the upper first molar, and intermolar width. The mean palatal suture opening was 2.85 ± 0.62 mm (p < 0.0001). Nasal width increased 1.28 ± 0.64 mm and maxillary width 2.79 ± 1.48 mm (p < 0.0001). In contrast, palatal height was reduced 0.65 ± 0.64 mm (p < 0.0001). Regarding arch perimeter, the radicular perimeter increased 2.89 ± 1.80 mm, while the coronal perimeter increased 3.42 ± 2.09 mm (p < 0.0001). Molar angulation increased 5.62 ± 3.20° for the right molar and 4.74 ± 2.22° for the left molar (p < 0.0001). Intermolar width increased 5.21 ± 1.55 mm (p < 0.0001). Treatment with Hyrax produced a significant opening in the mean palatal suture. Also, a significant increase in nasal width, maxillary width, arch perimeter, molar angulation, and intermolar width, and a decrease in palatal height, were observed.

A New Digital Method to Quantify the Effects Produced by Carriere Motion Appliance.

The aim of this study was to analyze a novel digital technique to quantify the distal tooth displacement and derotation angle produced by the Carriere Motion Appliance (CMA). Twenty-one patients with a class II molar and canine relationship underwent orthodontic treatment with CMA. All patients were exposed before (STL1) and after the CMA placement (STL2), submitted to a digital impression, and afterwards, data were uploaded to specific cephalometric software to allow automatic mesh network alignment of the STL digital files. Subsequently, the distal tooth displacement of the upper canines and first upper molars, as well as the derotation angle of the first upper molars were analyzed using the Pearson correlation coefficient (ρ). Repeatability and reproducibility were analyzed using Gage R&R statistical analysis. An increase in canine displacement was correlated with an increase in contralateral canine displacement (ρ = 0.759; p < 0.000). An increase in canine displacement was correlated with an increase in molar displacement (ρ = 0.715; p < 0.001). An increase in upper first molar displacement was correlated with an increase in the contralateral upper first molar displacement (ρ = 0.609; p < 0.003) and the canine displacement (ρ = 0.728; p < 0.001). The distal tooth displacement showed a repeatability of 0.62% and reproducibility of 7.49%, and the derotation angle showed a repeatability of 0.30% and reproducibility of 0.12%. The novel digital measurement technique is a reproducible, repeatable, and accurate method for quantifying the distal tooth displacement of the upper canine and first upper molar, as well as the derotation angle of the first upper molars after using CMA.