Multiplex STR amplification sensitivity in a silicon microchip.

The demand for solutions to perform forensic DNA profiling outside of centralized laboratories is increasing. We here demonstrate highly sensitive STR amplification using a silicon micro-PCR (µPCR) chip. Exploiting industry-standard semiconductor manufacturing processes, a device was fabricated that features a small form factor thanks to an integrated heating element covering three parallel micro-reactors with a reaction volume of 0.5 µl each. Diluted reference DNA samples (1 ng-31 pg) were amplified on the µPCR chip using the forensically validated AmpFISTR Identifier Plus kit, followed by conventional capillary electrophoresis. Complete STR profiles were generated with input DNA quantities down to 62 pg. Occasional allelic dropouts were observed from 31 pg downward. On-chip STR profiles were compared with those of identical samples amplified using a conventional thermal cycler for direct comparison of amplification sensitivity in a forensic setting. The observed sensitivity was in line with kit specifications for both µPCR and conventional PCR. Finally, a rapid amplification protocol was developed. Complete STR profiles could be generated in less than 17 minutes from as little as 125 pg template DNA. Together, our results are an important step towards the development of commercial, mass-produced, relatively cheap, handheld devices for on-site testing in forensic DNA analysis.

Lens-free imaging of magnetic particles in DNA assays.

We present a novel opto-magnetic system for the fast and sensitive detection of nucleic acids. The system is based on a lens-free imaging approach resulting in a compact and cheap optical readout of surface hybridized DNA fragments. In our system magnetic particles are attracted towards the detection surface thereby completing the labeling step in less than 1 min. An optimized surface functionalization combined with magnetic manipulation was used to remove all nonspecifically bound magnetic particles from the detection surface. A lens-free image of the specifically bound magnetic particles on the detection surface was recorded by a CMOS imager. This recorded interference pattern was reconstructed in software, to represent the particle image at the focal distance, using little computational power. As a result we were able to detect DNA concentrations down to 10 pM with single particle sensitivity. The possibility of integrated sample preparation by manipulation of magnetic particles, combined with the cheap and highly compact lens-free detection makes our system an ideal candidate for point-of-care diagnostic applications.

Label-free genosensor based on immobilized DNA hairpins on gold surface.

In this report, we demonstrate a label-free genosensor based on DNA hairpins coupled to gold coated sensor surfaces. The hairpin probes were labeled with a thiolated moiety for immobilization at the 5' end and with a fluorophore for signal transduction at the 3' end. In the absence of the complement, the fluorophore is quenched by energy transfer to the gold surface. Addition of the target sequence leads to the hairpin unfolding, and releases the fluorescent signal. This built-in property, using a gold film as both the immobilizing substrate and quenching agent, has the advantage of simplicity in design and ease of further integration. Our results showed that lengths of both the stem and the loop structures have significant effects on the sensor performance. Hybridization kinetics was investigated for various probe/target lengths and concentrations. An optimized hairpin probe gave a fluorescent signal increase of 39 folds after hybridization, which is much higher than the earlier reported results. A limit of detection (LOD) down to 0.3 nM for the complementary target DNA detection has been achieved. The developed sensor was further successfully applied for the detection of single-base mismatch targets, as well as for the direct detection of PCR products.

Real-time PCR to study the sequence specific magnetic purification of DNA.

The performance of various molecular techniques using complex biological samples greatly depends on the efficient separation and purification of DNA targets. In recent years, magnetic separation technology making use of small magnetic beads, has gained immense popularity. Most of these methods rely on the non-specific adsorption of DNA/RNA. However, as presented here, when functionalizing the beads with complementary DNA probes, the target of interest can selectively be isolated. Such sequence specific purification was evaluated for short DNA targets by means of simple fluorescent measurements, resulting in purification efficiencies around 80%. Besides standard fluorescent techniques, a real-time PCR (qPCR) method was applied for monitoring the purification of longer DNA targets. This qPCR method was specifically optimized for directly quantifying the purification efficiency of low concentrated DNA targets bound to magnetic beads. Additionally, parameters possibly affecting the magnetic isolation, including the length of the used capture probe or the hybridization location, were investigated. Using optimized conditions in combination with qPCR, purification efficiencies between 60% and 80% were observed and this over a large concentration window. These data also show the power of a direct qPCR approach to monitor the magnetic isolation of DNA at very low concentrations.