ABSTRACT
We present an experimental study of stick-jump (SJ) evaporation of strongly pinned nanoliter volume sessile water droplets drying on micropatterned surfaces. The evaporation is studied on surfaces composed of photolithographically micropatterned negative photoresist (SU-8). The micropatterning of the SU-8 enables circular, smooth, trough-like features to be formed which causes a very strong pinning of the three phase (liquid-vapor-solid) contact line of an evaporating droplet. This is ideal for studying SJ evaporation as it contains sequential constant contact radius (CCR) evaporation phases during droplet evaporation. The evaporation was studied in nonconfined conditions, and forced convection was not used. Micropatterned concentric circles were defined having an initial radius of 1000 µm decreasing by a spacing ranging from 500 to 50 µm. The droplet evaporates, successively pinning and depinning from circle to circle. For each pinning radius, the droplet contact angle and volume are observed to decrease quasi-linearly with time. The experimental average evaporation rates were found to decrease with decreasing pining radii. In contrast, the experimental average evaporation flux is found to increase with decreasing droplet radii. The data also demonstrate the influence of the initial contact angle on evaporation rate and flux. The data indicate that the total evaporation time of a droplet depends on the specific micropattern spacing and that the total evaporation time on micropatterned surfaces is always less than on flat, homogeneous surfaces. Although the surface patterning is observed to have little effect on the average droplet flux-indicating that the underlying evaporation physics is not significantly changed by the patterning-the total evaporation time is considerably modified by patterning, up to a factor or almost 2 compared to evaporation on a flat, homogeneous surface. The closely spaced concentric circle pinning maintains a large droplet radius and small contact angle from jump to jump; the result is a large evaporation rate leading to faster evaporation.
ABSTRACT
Nanoscale probes have been developed for the online characterization of the electrical properties of biological cells by dielectric spectroscopy. Two types of sensors have been designed and fabricated. The first one is devoted to low (<10 MHz) frequency range analysis and consists of gold nanoelectrodes. The second one works for high (>40 Hz) frequency range analysis and consists of a gold nanowire. The patterning of the sensors is performed by electron beam lithography. These devices are integrated in a microfluidic channel network for the manipulation of the cells and for the improvement of the performances of the sensors. These devices are used for the analysis of a well-characterized biological model in the area of the ligand-receptor interaction. The purpose is to monitor the interaction between the lactoferrin (the ligand) and the nucleolin and sulfated proteoglycans (the receptors) present or not on a set of mutant Chinese hamster ovary cell lines and their following internalization into the cytoplasm. Initial measurements have been performed with this microsystem and they demonstrate its capability for label-free, real-time, analysis of a dynamic mechanism involving biological cells.
