Fouling Resistance of Brush-Modified Elastomers.

The most effective antifouling coatings are designed to slowly release biocides that target a broad spectrum of marine organisms. However, as biocides have a deleterious effect on marine life, there is demand for environmentally friendly coatings that resist fouling through physical interactions. We propose a simple platform for the development of such coatings based on bottlebrush-modified elastomers. The bottlebrush additives were synthesized to have side chain chemistries that are known to be fouling-resistant, and these were incorporated in a commercial elastomer through blending and/or covalent attachment. The fouling performance of these coatings was highly variable, with area coverages of hard and soft foulants ranging from 1.4% to 7.2% and 29.1% to 64.0%, respectively, across a set of eight materials. The origin of these differences was explained by examining the structure of the coating surface through chemical imaging by time-of-flight secondary ion mass spectrometry (TOF-SIMS) and topographic imaging by atomic force microscopy (AFM). We found that fouling by certain soft and hard fouling organisms was primarily influenced by surface composition, which was controlled by both the chemistry and loading level of the bottlebrush additive, and was independent of the inherent surface roughness. While no type of coating could resist all soft and hard foulants, a formulation based on a bottlebrush copolymer additive with both siloxane and fluorinated monomers was effective against nearly all organisms encountered in the study.

Potential impacts from simulated vessel noise and sonar on commercially important invertebrates.

Human usage of coastal water bodies continues to increase and many invertebrates face a broad suite of anthropogenic stressors (e.g., warming, pollution, acidification, fishing pressure). Underwater sound is a stressor that continues to increase in coastal areas, but the potential impact on invertebrates is not well understood. In addition to masking natural sound cues which may be important for behavioral interactions, there is a small but increasing body of scientific literature indicating sublethal physiological stress may occur in invertebrates exposed to high levels of underwater sound, particularly low frequency sounds such as vessel traffic, construction noise, and some types of sonar. Juvenile and sub-adult blue crabs (Callinectes sapidus) and American lobsters (Homarus americanus) were exposed to simulated low-frequency vessel noise (a signal was low-pass filtered below 1 kHz to ensure low-frequency content only) and mid-frequency sonar (a 1-s 1.67 kHz continuous wave pulse followed by a 2.5 to 4.0 kHz 1-s linear frequency modulated chirp) and behavioral response (the animal's activity level) was quantified during and after exposure using EthoVision XT™ from overhead video recordings. Source noise was quantified by particle acceleration and pressure. Physiological response to the insults (stress and recovery) were also quantified by measuring changes in hemolymph heat shock protein (HSP27) and glucose over 7 days post-exposure. In general, physiological indicators returned to baseline levels within approximately 48 h, and no observable difference in mortality between treatment and control animals was detected. However, there was a consistent amplified hemolymph glucose signal present 7 days after exposure for those animals exposed to mid-frequency sound and there were changes to C. sapidus competitive behavior within 24 h of exposure to sound. These results stress the importance of considering the impacts of underwater sound among the suite of stressors facing marine and estuarine invertebrates, and in the discussion of management actions such as protected areas, impact assessments, and marine spatial planning efforts.

Iodine-infused aeration for hull fouling prevention: a vessel-scale study.

Biofouling is a significant economic and ecological problem, causing reduced vessel performance and increases in fuel consumption and emissions. Previous research has shown iodine vapor (I2)-infused aeration to be an environmentally friendly method for deterring the settlement of fouling organisms. An aeration system was deployed on a vessel with hull sections coated with two types of antifoulant coatings, Intersleek® 1100 (fouling-release) and Interspeed® BRA-640 (ablative copper biocide), as well as an inert epoxy barrier coating, to assess the effectiveness of aeration in conjunction with common marine coatings. I2-infused aeration resulted in consistent reductions of 80-90% in hard fouling across all three coatings. Additionally, aeration reduced the soft fouling rate by 45-70% when used in conjunction with both Intersleek® and Interspeed® BRA versus those coatings alone. The results of this study highlight the contribution of I2-infused aeration as a standalone mechanism for fouling prevention or as a complement to traditional antifouling coatings.