ABSTRACT
This manuscript presents a wavelength-division multiplexing (WDM)-based photonic beamformer for an RF phased array antenna transmitter, capable of simultaneously generating multiple beams using the same optical spectrum. In the proposed architecture, for each RF beam, a WDM signal comprising the modulated RF sidebands undergoes complex-valued filtering, while another WDM signal with the same channels, but carrying only optical carriers, goes through an optical frequency-shifting stage. The proposed architecture allows the same WDM channels to be reused for multiple RF beams. The detection of the frequency-shifted optical carrier and the filtered RF sideband of each WDM channel at the photodetector produces a frequency-converted, correctly weighted signal to be fed to each antenna element. The features described herein are analytically derived, numerically simulated, and experimentally demonstrated. Results showcase two independent beams being transmitted in different directions.
ABSTRACT
Automotive light detection and ranging (LiDAR) requires accurate and computationally efficient range estimation methods. At present, such efficiency is achieved at the cost of curtailing the dynamic range of a LiDAR receiver. In this Letter, we propose using decision tree ensemble machine learning models to overcome such a trade-off. Simple and yet powerful models are developed and proven capable of performing accurate measurements across a 45-dB dynamic range.
ABSTRACT
Ubiquitous satellite communications are in a leading position for bridging the digital divide. Fulfilling such a mission will require satellite services on par with fibre services, both in bandwidth and cost. Achieving such a performance requires a new generation of communications payloads powered by large-scale processors, enabling a dynamic allocation of hundreds of beams with a total capacity beyond 1 Tbit s-1. The fact that the scale of the processor is proportional to the wavelength of its signals has made photonics a key technology for its implementation. However, one last challenge hinders the introduction of photonics: while large-scale processors demand a modular implementation, coherency among signals must be preserved using simple methods. Here, we demonstrate a coherent photonic-aided receiver meeting such demands. This work shows that a modular and coherent photonic-aided payload is feasible, making way to an extensive introduction of photonics in next generation communications satellites.
ABSTRACT
In this Letter, we propose a monitoring and control system (MCS) for operating tunable optical delay lines (TODLs), regardless of their operation principle and implementation technology. The monitoring system resorts to two out-of-band pilot tones added to the input optical signal. The amplitude and phase difference between tones are retrieved to the control system, which calculates and applies the TODL control signals. The MCS was validated using a Mach-Zehnder delay interferometer-based TODL, implemented in three different silicon photonic integrated circuits (PICs). The three PICs resort to different kinds of phase shifters based on thermo-optic, carrier-injection, and carrier-depletion effects. The proposed MCS enabled tuning the delay within the entire range of the TODL in all tested PICs. The scalability of the MCS for large-scale photonic beamformers is discussed.
ABSTRACT
The design and dimensioning of a photonic-aided payload for a multi-beam high-throughput communications satellite is a complex problem in which the antenna, RF and photonic subsystems must be considered as a whole for achieving best performance with lowest mass and power consumption. In this paper, we propose and dimension the receiving stage of a communications satellite comprising a phased array antenna (PAA) feeding a multibeam photonic beamforming system (PBS). The PBS uses a single wavelength and resorts to heterodyne detection such that the retrieved beams are frequency downconverted. End-to-end system modeling shows that the complexity of the PAA and PBS can be traded-off for signal-to-noise ratio (SNR) or power consumption without compromising the beam width. The dimensioning of a realistic scenario is presented, showing that an SNR and beam crosstalk on the order of 20 dB are achievable with a total power consumption below 1 kW for a typical number of 100 antenna elements (AEs).
ABSTRACT
In this Letter, we investigate the influence of the phase and power of pump and signal waves on the gain of a four-mode phase-sensitive amplifier (PSA) built with a highly nonlinear fiber (HNLF), using a copier + PSA scheme to generate phase- and frequency-correlated idler waves. Using such an amplifier, low-noise amplification of a 10 Gsymbol/s quadrature phase-shift keying (QPSK) signal, with net gain of â¼20 dB and less than 1 dB optical signal-to-noise ratio (OSNR) penalty at a bit error ratio (BER) of 10(-3), was achieved. We also verified an additional net gain of 11.6 dB when switching from phase-insensitive to phase-sensitive operation, which is in good agreement with theoretical predictions of 12 dB.
ABSTRACT
We propose an OTDM to WDM converter which enables wavelength tunability, flexible OTDM tributary to WDM channel mapping and modulation format transparency. The converted signals are obtained by four-wave mixing (FWM) the input 160 Gb/s OTDM signal with a multi-wavelength sampling pulse train (SPT). The generation of the multi-wavelength SPT starts by multicasting an optical clock signal. The multicast pulses are then individually delayed and reshaped by a programmable optical processor (POP), resulting in flexible generation of the SPT. Error-free performance was achieved in different OTDM tributary to WDM channel mappings. In addition, intermediate rate conversion (2x80 Gb/s) was also achieved simply by reconfiguring the POP.