ABSTRACT
ZnO nanomaterials have been extensively used as photocatalysts for the removal of pollutants in aqueous environments. This study explores the enhanced photocatalytic performance of porous ZnO coral-like nanoplates synthesized via a one-pot wet-chemical method and subsequent annealing treatment. Characterization through scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), powder X-ray diffraction (XRD), energy-dispersive X-ray spectroscopy (EDX), Raman spectroscopy, photoluminescence (PL) spectroscopy, and Brunauer-Emmett-Teller (BET) measurements confirmed the nanoplates' porous structure, single-crystal structure, 100 nm thickness, and 80 nm pore size. These unique structural characteristics of the ZnO coral-like nanoplates enabled effective photodegradation of the organic dye rhodamine B (RhB) under visible light irradiation. Under simulated sunlight, the ZnO photocatalyst exhibited exceptional performance, achieving a 97.3% removal rate of RhB after 210 minutes of irradiation. The prepared ZnO photocatalyst also showed remarkable photostability and regeneration capability for RhB photodegradation with a decreased efficiency of less than 15% after eight testing cycles. The potential mechanism of the ZnO photocatalyst toward RhB degradation was also studied and is discussed in detail.
ABSTRACT
In this study, activated carbon from corncobs was successfully synthesized by hydrothermal carbonization and hydrochemical activation at low temperatures, followed by pyrolysis. A developed method of hydrochemical activation of hydrochar that uses only small amounts of chemicals is a promising approach. After activation, the activator residues in the hydrothermal product can constantly act as a chemical activator during pyrolysis to form corncob-activated carbon (AHC-KOH), which had specific surface area of 965.028 m2/g and oxygenated functional groups of 0.3780 mmol/g, 31.67 and 4 times, respectively, of those of the inactivated sample. AHC-KOH was used to study the adsorption characteristics of methylene blue (MB). The MB adsorption efficiency of AHC-KOH was the highest at 489.560 mg/g, which was considerably higher than that of activated carbons produced from other biomasses. The isotherm equilibrium and adsorbent kinetics parameters of MB adsorption on AHC-KOH were also determined using the Langmuir isotherm model (R2 = 0.99) and pseudo-second-order kinetic model (R2 > 0.99). Thus, the results indicate that an inexpensive adsorbent produced from corncobs using the above method is a promising material for wastewater treatment.
Subject(s)
Water Pollutants, Chemical , Water Purification , Adsorption , Charcoal/chemistry , Kinetics , Methylene Blue/chemistry , Water Pollutants, Chemical/analysis , Water Purification/methods , Zea maysABSTRACT
In this study, the effect of salinity on the removal of organic matter and nitrogen concentrations in bioreactor was investigated using a hybrid bench scale down-flow hanging sponge (DHS) system for 145 days of operation. The reactor had three identical sections that were filled to 30% volume with Bio-Bact to serve as attached media. The DHS reactor was fed with domestic wastewater that was mixed with increasing concentration of sodium chloride from 0.5 to 3.0% stepwise. The influent and effluent concentrations of BOD5, CODCr, NH4+-N, and TN were analyzed to evaluate the performance of the DHS reactor during the operational period. Results indicate that when salinity was increased from 0.5 to 3.0%, the removal efficiency gradually decreased from 80.3% to 61.5% for CODCr, 76.4%-65.0% for BOD5, 64.1%-48.4% for NH4+-N, and 50%-36% for TN. Besides, the changes in biofilm characteristics with increasing salinity were observed during the operational period. The results indicate that salinity has a significant influence on the removal of organic matters and nitrogen transformation in the biofilm of the bioreactor. Even so, the DHS reactor revealed a good potential for treating saline wastewater.