ABSTRACT
The manganese oxide graphene oxide (Mn3O4/rGO) composite heterojunction with copper oxide is useful for the production of an electrochemical supercapacitor. The graphene oxide and manganese oxide composite have been synthesized by adopting a method of co-precipitation. The composite of Mn3O4/rGO was synthesized with different concentrations of Mn3O4 and rGO. The structural, morphological, electrochemical and supercapacitive properties of Mn3O4/rGO composite have been examined. The electrochemical and supercapacitive properties have been studied with regard to different substrates. The Mn3O4/rGO composite was deposited on different substrates such as steel, copper and brass. The CuO/Mn3O4/rGO shows relatively better specific capacitance (856 F g-1) and better stability (82% retention after 2000 cycles) than other substrates used. The present work describes the development of cost-effective and high-performance CuO/Mn3O4/rGO-based nanomaterials for supercapacitors. The CuO/Mn3O4/rGO composite can be used as a flexible supercapacitor device.
ABSTRACT
The effect of ultrasonic treatment and deposition time on nanoflake-like Co(OH)2 thin films were prepared using the potentiostatic mode of electrodeposition method on stainless steel substrates by a nitrate reduction reaction. After ultrasonic treatment, we used stainless steel substrates for deposition of the nanoflakes like Co(OH)2 thin films. The effect of deposition times and electrolytes on different physico-chemical properties of Co(OH)2 was investigated in detail, such as X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM), energy dispersive X-ray spectroscopy (EDS), and electrochemical testing. After ultrasonic treatment Co(OH)2 thin films had devolvement of the uniform and interconnected formation of nanoflakes nanostructures. Supercapacitor performance of the Co(OH)2 electrodes suggest that, specific capacitance are depends on the surface morphology, and Co(OH)2 electrodes after ultrasonic treatment exhibited higher performance than without ultrasonication. The maximum specific capacitance of the 30â¯min. deposited Co(OH)2 nanoflakes exceeded 276â¯Fg-1 in 0.5M KOH electrolyte at 5â¯mVs-1 scan rate.
ABSTRACT
In this paper, we chemically synthesized interconnected nanoflake-like CdS thin films for photoelectrochemical solar cell applications and subsequently irradiated them with electron beam irradiation at various doses of irradiation. The as-synthesized and irradiated samples were characterized by means of X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM), high-resolution transmission electron microscopy (HR-TEM), and electrochemical measurements. XRD and XPS results confirmed the formation of CdS with a hexagonal crystal structure. FE-SEM and HR-TEM studies confirmed the photoelectrochemical performance, which was dependent on the surface morphology. The calculated values for efficiency demonstrated an outstanding photoelectrochemical performance with a fill factor of 0.38 and efficiency of 3.06% at 30â¯kGy. The high photoelectrochemical performance may be due to the interconnected nanoflake-like nanostructure and higher active surface area of the CdS samples. These results show that the electron beam irradiation is capable as an electrode for photoelectrochemical solar cells.