Evaluation of a wearable fabric-based sensor for accurate sodium determination in sweat during exercise.

INTRODUCTION: Newly developed wearable fabric sensors (WFS) can increase the ease and accuracy of sweat sodium measurements by performing simultaneous sampling and analysis on the body during exercise. PURPOSE: Determine the accuracy of a WFS for measurement of sodium concentration in sweat. METHODS: Subjects wore a WFS prototype and sweat collectors on their forearm during cycle ergometry. Subjects exercised at a moderate intensity (~ 65% heart rate reserve) for 30-60 min. Sweat samples were collected and analyzed using a commercial sweat sodium analyzer (SSA) every 10-15 min. WFS were adhered with an armband and connected to custom built electronics. Accuracy was determined by comparing predicted WFS concentration to the actual concentration from the commercial SSA and analyzed statistically using ANOVA and Bland-Altman plots. RESULTS: A total of 19 subjects completed the study. The average sweat sodium concentration was 59 mM ± 22 mM from a SSA compared with 54 mM ± 22 mM from the WFS. Overall, the average accuracy of the WFS was 88% in comparison to the SSA with p = 0.45. A line of best fit comparing predicted versus actual sweat sodium concentration had a slope of 0.99, intercept of - 4.46, and an r2 of 0.90. Bland-Altman analysis showed the average concentration difference between the WFS and the SSA was 5.35 mM, with 99% of data points between ± 1.96 times the standard deviation. CONCLUSION: The WFS accurately predicted sweat sodium concentration during moderate intensity cycle ergometry. With the need for precise assessment of sodium loss, especially during long duration exercise, this novel analysis method can benefit athletes and coaches. Further research involving longer duration and more intense exercise is warranted.

Graphene oxide electrocatalyst on MnO2 air cathode as an efficient electron pump for enhanced oxygen reduction in alkaline solution.

Graphene oxide (GO) was deposited on the surface of a MnO2 air cathode by thermal evaporation at 50°C from a GO colloidal suspension. Fourier transformed infrared spectroscopy and field emission scanning electron microscopy confirmed the presence of GO on the MnO2 air cathode (GO-MnO2). Voltammetry and chrono-amperometry showed increased currents for the oxygen reduction reaction (ORR) in 6 M KOH solution for GO-MnO2 compared to the MnO2 cathode. The GO-MnO2 was used as an air cathode in an alkaline tin-air cell and produced a maximum power density of 13 mW cm(-2), in contrast to MnO2, which produced a maximum power density of 9.2 mW cm(-2). The electrochemical impedance spectroscopy results suggest that the chemical step for the ORR is the rate determining step, as proposed earlier by different researchers. It is suggested that the presence of GO and electrochemically reduced graphene oxide (ERGO) on the MnO2 surface are responsible for the increased rate of this step, whereby GO and ERGO accelerate the process of electron donation to the MnO2 and to adsorbed oxygen atoms.

Sensitive voltammetric determination of paracetamol by poly (4-vinylpyridine)/multiwalled carbon nanotubes modified glassy carbon electrode.

A novel glassy carbon electrode (GCE) modified with a composite film of poly (4-vinylpyridine) (P4VP) and multiwalled carbon nanotubes (P4VP/MWCNT GCE) was used for the voltammetric determination of paracetamol (PCT). This novel electrode displayed a combined effect of P4VP and MWCNT on the electro-oxidation of PCT in a solution of phosphate buffer at pH 7. Hence, conducting properties of P4VP along with the remarkable physical properties of MWCNTs might have combined effects in enhancing the kinetics of PCT oxidation. The P4VP/MWCNT GCE has also demonstrated excellent electrochemical activity toward PCT oxidation compared to that with bare GCE and MWCNT GCE. The anodic peak currents of PCT on the P4VP/MWCNT GCE were about 300 fold higher than that of the non-modified electrodes. By applying differential pulse voltammetry technique under optimized experimental conditions, a good linear ratio of oxidation peak currents and concentrations of PCT over the range of 0.02-450 µM with a limit of detection of 1.69 nM were achieved. This novel electrode was stable for more than 60 days and reproducible responses were obtained at 99% of the initial current of PCT without any influence of physiologically common interferences such as ascorbic acid and uric acid. The application of this electrode to determine PCT in tablets and urine samples was proposed.