The development of an inline Raman spectroscopic analysis method as a quality control tool for hot melt extruded ramipril fixed-dose combination products.

Currently in the pharmaceutical industry, continuous manufacturing is an area of significant interest. In particular, hot-melt extrusion (HME) offers many advantages and has been shown to significantly reduce the number of processing steps relative to a conventional product manufacturing line. To control product quality during HME without process interruption, integration of inline analytical technology is critical. Vibrational spectroscopy (Raman, NIR and FT-IR) is often employed and used for real-time measurements because of the non-destructive and rapid nature of these analytical techniques. However, the establishment of reliable Process Analytical Technology (PAT) tools for HME of thermolabile drugs is challenging. Indeed, the Raman effect is inherently weak and might be subject to interference. Moreover, during HME, heating and photodecomposition can occur and disrupt spectra acquisition. The aim of this research article was to explore the use of inline Raman spectroscopy to characterise a thermolabile drug, ramipril (RMP), during continuous HME processing. Offline measurements by HPLC, LC-MS and Raman spectroscopy were used to characterise RMP and its main degradation product, ramipril-diketopiperazine (RMP-DKP, impurity K). A set of HME experiments together with inline Raman spectroscopic analyses were performed. The feasibility of implementing inline Raman spectroscopic analysis to quantify the level of RMP and RMP-DKP in the extrudate was addressed. Two regions in the Raman spectrum were selected to differentiate RMP and RMP-DKP. When regions were combined, a principle component analysis (PCA) model defined by these two main components (PC 1 = 50.1% and PC 2 = 45%) was established. Using HPLC analyses, we were able to confirm that the PC 1 score was attributed to the level of RMP-DKP, and the PC 2 score was related to the RMP drug content. Investigation of the PCA scatterplot indicated that HME processing temperature was not the only factor causing RMP degradation. Additionally, the plasticiser content, feeding speed and screw rotating speed contributed to RMP degradation during HME processing.

A comparative study between hot-melt extrusion and spray-drying for the manufacture of anti-hypertension compatible monolithic fixed-dose combination products.

The purpose of this work was to investigate the application of different advanced continuous processing techniques (hot melt extrusion and spray drying) to the production of fixed-dose combination (FDC) monolithic systems comprising of hydrochlorothiazide and ramipril for the treatment of hypertension. Identical FDC formulations were manufactured by the two different methods and were characterised using powder X-ray diffraction (PXRD) and modulated differential scanning calorimetry (mDSC). Drug dissolution rates were investigated using a Wood's apparatus, while physical stability was assessed on storage under controlled temperature and humidity conditions. Interestingly both drugs were transformed into their amorphous forms when spray dried, however, hydrochlorothiazide was determined, by PXRD, to be partially crystalline when hot melt extruded with either polymer carrier (Kollidon® VA 64 or Soluplus®). Hot melt extrusion was found to result in significant degradation of ramipril, however, this could be mitigated by the inclusion of the plasticizer, polyethylene glycol 3350, in the formulation and appropriate adjustment of processing temperature. The results of intrinsic dissolution rate studies showed that hot-melt extruded samples were found to release both drugs faster than identical formulations produced via spray drying. However, the differences were attributable to the surface roughness of the compressed discs in the Wood's apparatus, rather than solid state differences between samples. After a 60-day stability study spray dried samples exhibited a greater physical stability than the equivalent hot melt extruded samples.