The effect of binder types on the breakage and drying behavior of granules in a semi-continuous fluid bed dryer after twin screw wet granulation.

Current study investigated the effect of different binder types on the granule drying process and the granule breakage behavior in a semi-continuous fluid bed dryer integrated in the C25 ConsiGma-system. The studied binders (i.e. hydroxypropyl pea starch, hydroxypropyl methylcellulose E15, polyvinylpyrrolidone K12, and starch octenyl succinate CO 01) required different liquid amounts to produce similar granule quality. These different liquid requirements were translated into different drying conditions for each binder to result in sufficiently dry granules at the end of a drying cycle. By comparing the size distribution of the granules before entering and after exiting the fluid bed dryer, granule breakage could be evaluated. No effect of the binder type on the granule breakage during drying was observed. However, differences in granule breakage were observed for the binders when processed with the horizontal set-up of the C25 system, as granule breakage during pneumatic transport depended on the binder type. Only one binder (hydroxypropyl pea starch) allowed to avoid granule breakage during the entire process. Furthermore, this research showed that the drying process was mainly steered by the liquid requirements for granulation, and that these liquid requirements depended on the binder used.

Influence of binder attributes on binder effectiveness in a continuous twin screw wet granulation process via wet and dry binder addition.

The effect of a wide variety of binders on the quality of granules produced via continuous twin screw wet granulation was studied. Anhydrous dicalcium phosphate was used as poorly soluble filler and was granulated applying dry or wet addition of binders. Furthermore, dry and wet binder characteristics were determined and linked to the binder effectiveness. PVA 4-88 and starch octenyl succinate exhibited the lowest granule friability at low liquid-to-solid ratios, i.e. the highest binder effectiveness, which was attributed to fast binder activation based on the fast wetting kinetics of the binder, to efficient wetting of DCP particles, and to good spreading in the powder bed. The performance of wettability measurements in an early formulation development stage is therefore considered highly important. Additionally, an increased stickiness of the binder surface caused by high binder viscosity and slow dissolution kinetics also positively influenced the binder effectiveness. In conclusion, this study revealed which binder attributes have a critical impact on the granulation process of dicalcium phosphate. Additionally, dry binder addition proved successful for creation of high quality granules.