ABSTRACT
Two water-soluble binders of carboxymethyl cellulose (CMC) and sodium alginate (SA) have been studied in comparison with N-methylpyrrolidone-soluble poly(vinylidene difluoride-co-hexafluoropropylene) (PVdF-HFP) to understand their effect on the electrochemical performance of a high-voltage lithium nickel manganese oxide (LNMO) cathode. The electrochemical performance has been investigated in full cells using a Li4 Ti5 O12 (LTO) anode. At room temperature, LNMO cathodes prepared with aqueous binders provided a similar electrochemical performance as those prepared with PVdF-HFP. However, at 55 °C, the full cells containing LNMO with the aqueous binders showed higher cycling stability. The results are supported by intermittent current interruption resistance measurements, wherein the electrodes with SA showed lower resistance. The surface layer formed on the electrodes after cycling has been characterized by X-ray photoelectron spectroscopy. The amount of transition metal dissolutions was comparable for all three cells. However, the amount of hydrogen fluoride (HF) content in the electrolyte cycled at 55 °C is lower in the cell with the SA binder. These results suggest that use of water-soluble binders could provide a practical and more sustainable alternative to PVdF-based binders for the fabrication of LNMO electrodes.
Subject(s)
Electric Power Supplies , Water , Electrodes , Electrolytes , Nickel/chemistry , Water/chemistryABSTRACT
Lithium-O2 (Li-O2) batteries are currently limited by a large charge overpotential at practically relevant current densities, and the origin of this overpotential has been heavily debated in the literature. This paper presents a series of electrochemical impedance measurements suggesting that the increase in charge potential is not caused by an increase in the internal resistance. It is proposed that the potential shift is instead dictated by a mixed potential of parasitic reactions and Li2O2 oxidation. The measurements also confirm that the rapid potential loss near the end of discharge ("sudden death") is explained by an increase in the charge transport resistance. The findings confirm that our theory and conclusions in ref 1, based on experiments on smooth small-area glassy carbon cathodes, are equally valid in real Li-O2 batteries with porous cathodes. The parameter variations performed in this paper are used to develop the understanding of the electrochemical impedance, which will be important for further improvement of the Li-air battery.
ABSTRACT
The effects of Li2CO3 like species originating from reactions between CO2 and Li2O2 at the cathode of non-aqueous Li-air batteries were studied by density functional theory (DFT) and galvanostatic charge-discharge measurements. Adsorption energies of CO2 at various nucleation sites on a stepped (11Ì 00) Li2O2 surface were determined and even a low concentration of CO2 effectively blocks the step nucleation site and alters the Li2O2 shape due to Li2CO3 formation. Nudged elastic band calculations show that once CO2 is adsorbed on a step valley site, it is effectively unable to diffuse and impacts the Li2O2 growth mechanism, capacity, and overvoltages. The charging processes are strongly influenced by CO2 contamination, and exhibit increased overvoltages and increased capacity, as a result of poisoning of nucleation sites: this effect is predicted from DFT calculations and observed experimentally already at 1% CO2. Large capacity losses and overvoltages are seen at higher CO2 concentrations.