ABSTRACT
Background: In endodontics, glide path creation has been extensively considered a mandatory clinical step to improve the safety and efficiency of rotary nickel-titanium instruments. The high anatomic variations in the mesiobuccal (MB) root of the maxillary molars are observed in the form of canal configuration, number, and position.The aim of this study was to evaluate the negotiability of MB canals in maxillary molars using different pathfiling systems (ProGlider, R-pilot, HyFlex electrical discharge machining [EDM], WaveOne Gold Glider, and C-Pilot). Materials and Methods: This in vitro study included 125 maxillary first molars with closed apex. Before preparation, all teeth were scanned by periapical radiograph for review of the presence of second MB (MB2) canals, without any resorption or calcification, and moderate curve of MB root canal. Subsequently, the access cavity was prepared with a Diamond Fissure Bur. Then, the samples were divided into five groups (ProGlider, R-pilot, HyFlex EDM, WaveOne Gold Glider, and C-Pilot). Certain relevant indices were recorded for analysis, such as the negotiability of the glide path file in the MB canals, file fracture rate, and negotiation speed. The level of significance P value was set at 0.05. Results: In this study, HyFlex EDM was the only path file that could not reach the full working length (WL) in some cases. The highest frequency of file fracture in the MB2 was observed with HyFlex EDM (24%); nevertheless, R-Pilot presented an intermediate fracture rate (16%), and both ProGlider and WaveOne Gold Glider were the safest files (4%) in this regard. However, there were no significant differences between the groups (P = 0.065). The lowest and the highest average time of reaching full WL was observed with WaveOne Gold Glider and HyFlex EDM; nonetheless, there was no significant difference between the four rotary groups. The average number of pecks in HyFlex EDM was significantly higher in comparison to those reported for WaveOne Gold Glider and ProGlider. Conclusion: Path files used for glide path preparation in the MB2 canals of maxillary molars should be flexible with low taper. The use of HyFlex EDM in the MB2 canals is not recommended due to its high taper.
ABSTRACT
Missed canals pose a potential risk in the treatment of teeth with anatomical variations, even when multi-angled radiographs have been used. Incomplete mechanical and chemical debridement of the root canal system can lead to treatment failure. Therefore, clinicians must have adequate knowledge of normal root canal systems as well as any possible variations in order to prevent any failure during or after the treatment of teeth with anatomical variations. Any case report of such rare variations would add to this critically required body of knowledge. The current case report presents the diagnosis and endodontic treatment of a maxillary first premolar with one root and three canals (one palatal and two buccal canals, all buccolingually positioned, bifurcating in the apical region), which was different from premolars with 3 canals reported up to now. This configuration describes an unusual root canal system for the maxillary first premolar and does not fit into any of the well-known root canal classification systems.
ABSTRACT
Paresthesia can result from some post-endodontic problems, including bacterial infections or mishaps which occur during the cleaning, shaping, and filling of the root canal. There are pharmacological and instrumental methods for the treatment of paresthesia; however, if presenting symptoms are suggestive of nerve injury, surgical approaches, such as intentional replantation, could be considered. In this case report study, we treated paresthesia that had occurred after endodontic treatment using intentional replantation. This case report describes the use of intentional replantation of a mandibular premolar as a successful technique to treat paresthesia involving the lower lip.
ABSTRACT
Introduction: The purpose of this study was to evaluate the thickness of the remaining dentine wall in the danger zone of the second mesiobuccal (MB2) canals using cone-beam computed tomography (CBCT) in maxillary first molars following preparation by means of HERO 642 rotary instruments with different tapers. Methods and Materials: The study samples included twenty-five mesiobuccal roots of maxillary first molars. A two-step method was employed to prepare the MB2 canals applying HERO 642 instruments: using a 0.02 taper (step 1), and a 0.04 taper (step 2). The roots were scanned before preparation, and after each step. The thickness of the dentine wall was recorded at the CEJ level, as well as 2 mm and 4 mm below the CEJ. The repeated-measures ANOVA in conjunction with the Cochran tests were used to compare the changes in the thickness of the root canal wall. Results: There was no area with dentine thickness of <0.5 mm before preparation. A significant reduction in dentine thickness occurred following the preparation with both 0.02 and 0.04 files at all three levels compared with the pre-instrumentation values (P< 0.05). However, areas with dentine thickness of < 0.5 mm after preparation using 0.04 files were significantly more than those resulting from the application of 0.02 files both at the CEJ and 2 mm-below-CEJ points, but the differences were not significant at the 4mm-below-CEJ level. Conclusion: Within the limitations of the present in vitro study, the use of larger taper instruments in MB2 root canals of maxillary first molars increased the quantity of samples with dentine thickness less than 0.5 millimeter at the coronal level of the root canal. It was concluded that instruments with large tapers, should be used with caution in troughing or preparing such root canals to reduce the risk of strip perforation.
ABSTRACT
Our article aimed to present a curious case of a mandibular premolar with a C-shaped root canal and to review the available literature on this anatomical variation. Mandibular premolar teeth account for the greatest endodontic challenges in the course of treatment on account of the morphological variations in their root canal systems, including extra root(s)/canal(s) or a C-shaped configuration. A 20-year-old female patient was referred to the Department of Endodontics of Mashhad Faculty of Dentistry, suffering from abscess, and pain while chewing. On examination the culprit was found to be the left mandibular first premolar. Following special tests and periapical radiography, we found an amalgam restoration proximate to the non-vital pulp chamber, as well as an unusually complex root canal anatomy with periapical radiolucency. A non-surgical root canal treatment with the aid of a dental operating microscope was considered as the treatment plan. Clinicians should always anticipate the presence of a C-shaped configuration in mandibular premolars, and make use of all the available tools to locate and treat such cases. A substantial knowledge of root canal anatomy would be prudent to ensure a successful outcome ensuing surgical and non-surgical root canal treatments.
