Biopolymer Meets Nanoclay: Rational Fabrication of Superb Adsorption Beads from Green Precursors for Efficient Capture of Pb(II) and Dyes.

Renewable, green, and safe natural biopolymer-derived materials are highly desired for the purification of pollutants, but significantly improving their performance without the introduction of additional harmful chemicals remains a huge challenge. Based on the concept of "structure optimization design", environment-friendly composite beads (named SA/PASP/RE) with excellent adsorption performance and recyclability were rationally constructed through a green ionic crosslinking route, using the completely green biopolymer sodium alginate (SA), sodium salt of polyaspartic acid (PASP), and the natural nanoclay rectorite (RE) as starting materials. The nano-layered RE was embedded in the polymer matrix to prevent the polymer chain from becoming over-entangled so that more adsorption sites inside the polymer network were exposed, which effectively improved the mass transfer efficiency of the adsorbent and the removal rate of contaminants. The composite beads embedded with 0.6% RE showed high adsorption capacities of 211.78, 197.13, and 195.69 mg/g for Pb(II) and 643.00, 577.80, and 567.10 mg/g for methylene blue (MB) in Yellow River water, Yangtze River water, and tap water, respectively. And the beads embedded with 43% RE could efficiently adsorb Pb(II) and MB with high capacities of 187.78 mg/g and 586.46 mg/g, respectively. This study provides a new route to design and develop a green, cost-effective, and efficient adsorbent for the decontamination of wastewater.

Multiple interface coupling on natural tourmaline enables high-efficiency removal of antibiotic: Superior property and mechanism.

Reasonably designing highly active, environmentally friendly, and cost-effective catalysts for efficient elimination of pollutants from water is desirable but challenging. Herein, an efficient heterogeneous photo-Fenton catalyst tourmaline (TM)/tungsten oxide (WO3-x) (named TW10) containing tungsten/boron/iron (W/B/Fe) synergistic active centers and 90% of cheap natural tourmaline (TM) mineral rich in Fe and B elements. The TW10 catalyst can quickly activate peroxymonosulfate (PMS) to generate massive active free radicals, which may induce the rapid and efficient degradation of tetracycline (TC). The TW10/PMS/Visible light system can effectively degrade up to 98.7% of tetracycline (TC) in actual waters (i.e. seawater, Yellow River, and Yangtze River water), and the catalytic degradation rates reach 1.65, 5.569, and 2.38 times higher than those of TM, WO3-x, and commercial P25 (Degussa, Germany), respectively. In addition, the catalyst can be recycled and reused multiple times. Electron spin resonance spectroscopy (EPR), X-ray photoelectron spectroscopy (XPS), and liquid chromatograph-mass spectrometer (LC-MS) analyses confirm that the synergistic catalytic effect of W/B/Fe sites on the TW10 catalyst accelerates the electron transfer between Fe(II) and Fe(III), as well as between W(V) and W(VI), and thus promotes the rapid degradation of TC. The catalytic reaction mechanism and degradation pathway of TC were explored. This work provides a feasible route for the design and development of new eco-friendly and efficient catalyst.

Carbon-in-Silicate Nanohybrid Constructed by In Situ Confined Conversion of Organics in Rectorite for Complete Removal of Dye from Water.

The complete removal of low concentration organic pollutants from wastewater to obtain clean water has always been a highly desired but challenging issue. In response to this, we proposed a new strategy to fabricate a carbon-in-silicate nanohybrid composite by recycling dye-loaded layered clay adsorbent and converting them to new heterogeneous carbon-in-silicate nanocomposite through an associated calcination-hydrothermal activation process. It has been confirmed that most of the dye molecules were present in waste rectorite adsorbent using an intercalation mode, which can be in situ converted to carbon in the confined interlayer spacing of rectorite. The further hydrothermal activation process may further improve the pore structure and increase surface active sites. As expected, the optimal composite shows extremely high removal rates of 99.6% and 99.5% for Methylene blue (MB) and Basic Red 14 (BR) at low concentrations (25 mg/L), respectively. In addition, the composite adsorbent also shows high removal capacity for single-component and two-component dyes in deionized water and actual water (i.e., Yellow River water, Yangtze River water, and seawater) with a removal rate higher than 99%. The adsorbent has good reusability, and the adsorption efficiency is still above 93% after five regeneration cycles. The waste clay adsorbent-derived composite adsorbent can be used as an inexpensive material for the decontamination of dyed wastewater.

Chitosan-based composite hydrogel with a rigid-in-flexible network structure for pH-universal ultra-efficient removal of dye.

Polysaccharide-based hydrogel adsorbents become popular because of their high adsorption capacity and fast adsorption rate, but their low removal rate and poor pH resistance have always been fatal shortcomings. Herein, a feasible strategy was proposed to strengthen the ability of hydrogel adsorbent to remove organic pollutants (i.e., dye) by incorporating natural rectorite (REC) into chitosan-g-poly (2-acrylamido-2-methyl-propane-sulfonic-acid) hydrogel network to form a rectorite-in-polymer network structure. The introduction of less dosage of REC (1.2 wt%) into the hydrogel facilitates to improve its adsorption capacities toward methylene blue (MB) in deionized water, tap water, seawater, Yangtze River water, and Yellow River water (1083.39-1303.49 mg/g); while incorporating higher content of REC (15.8 wt% REC) helps to improve the removal rate (99.6% for MB in real waters), which are greatly superior to commercial activated carbons. The adsorbent keeps high adsorption efficiency in a broad pH range (2-11), and can be reused for >4 times.

Sustainable green conversion of coal gangue waste into cost-effective porous multimetallic silicate adsorbent enables superefficient removal of Cd(II) and dye.

Converting solid wastes into new materials for wastewater decontamination is a feasible "one stone, three birds" strategy to achieve sustainable value-added utilization of resources and minimize waste emissions, but significant challenges remain. In response to this, we proposed an efficient "mineral gene reconstruction" method to synchronously transform coal gangue (CG) into a green porous silicate adsorbent without using any harmful chemicals (i.e., surfactants, organic solvents). The one of the synthesized adsorbents with a high specific surface area (582.28 m2/g) and multimetallic active centres shows outstanding adsorption performance (adsorption capacities: 168.92 mg/g for Cd(II), 234.19 mg/g for methylene blue (MB); removal rate: 99.04% for Cd(II) and 99.9% for MB). The adsorbent can also reach a high removal rate of 99.05%∼99.46% and 89.23%∼99.32% for MB and Cd(II) in real water samples (i.e., Yangtze River, Yellow River, seawater and tap water), respectively. After 5 adsorption-desorption cycles, the adsorption efficiency remained above 90%. The adsorbents mainly adsorbed Cd(II) by electrostatic attraction, surface complexation and partial ion exchange and MB by electrostatic and hydrogen bonding interactions. This study provides a sustainable and promising platform for developing a new-generation cost-efficient adsorbent from waste for clean water production.

Core-shell alginate beads as green reactor to synthesize grafted composite beads to efficiently boost single/co-adsorption of dyes and Pb(II).

A series of sodium alginate (SA) grafted polymer composite beads were synthesized by a solution free-radical graft polymerization reaction performed in a surface crosslinked alginate bead reactor. The outer surface of the precursor droplet containing reactants including SA, acrylamide (AM), N,N'-methylene-bis-acrylamide (MBA), ammonium persulfate (APS), sepiolite (SP) and gelatin (GE) was instantly crosslinked with Ca2+ ions to form a capsule-like bead when it was dropped into aqueous solution of calcium chloride, and simultaneously the reactants inside the capsule-like "bead reactor" were polymerized in-situ to form new composite beads with crosslinked network structure, abundant functional groups, excellent single or co-adsorption ability and easily separable advantages. The optimal composite bead shows high adsorption capacities of 390.78, 1425.65 and 533.91 mg/g toward Methylene Blue (MB), Basic Fuchsin (BF) and Pb(II), respectively. After adsorption with the composite bead, 99.71% of MB, 99.99% of BF and 99.97% of Pb(II) were removed from original dye or Pb(II) solutions. Moreover, above 99.22% of BF and 95.33% of Pb(II) was co-removed from their binary mixture (BF concentration, 100 mg/L; Pb(II) concentration, 50 mg/L). This paper provides a simple green way to synthesize efficient and recyclable biopolymer-based adsorbents capable of purifying dyes and heavy metal ions in water.

Effect of Diplopia on Daily Life and Evaluation of Nursing Measures Following Strabismus Surgery.

PURPOSE: To investigate the effect of diplopia on the daily life of patients after strabismus surgery and to explore appropriate nursing care measures. METHODS: A total of 200 patients who developed postoperative diplopia underwent telephone follow-up to evaluate the influence of diplopia on their daily lives. SPSS 19.0 statistical software was utilized for data analysis. RESULTS: Postoperative diplopia affected patients' physical activity (49%), attention (39.2%), work and study (24.5%), emotions (19.5% ), and housework performance (17% ), whereas it did not influence the quality of sleep. Potential risk factors associated with diplopia, such as duration of diplopia, gender, and age, were analyzed by uni- and multivariate regression analysis. Quality of life was significantly and negatively correlated with the duration of diplopia, but not correlated with gender or age. CONCLUSION: Postoperative diplopia affects the quality of life in partial patients. The nursing staff should provide nursing care, health education, and explicit instructions to the patients after discharge. In addition, nursing care should be sustained by subsequent telephone follow-up.

[The Nursing of 20 Cases of High Myopia Complicated with Fixed Esotropia].

To summarize the nursing experience of 20 cases of high myopia complicated with fixed esotropia. Before surgery, psychological nursing and self-care education were necessary. After the operation, ocular symptoms and complications should be closely observed and treatment in a timely manner. Explicit instructions after discharge and telephone follow-up played a pivotal role in improving clinical efficacy, preventing complications and enhancing patients' quality of life.

Two-dimensional liquid chromatography-tandem mass spectrometry coupled with isobaric tags for relative and absolute quantification (iTRAQ) labeling approach revealed first proteome profiles of pulmonary alveolar macrophages infected with porcine circovirus type 2.

Porcine circovirus type 2 (PCV2) has been identified as the essential causal agent of postweaning multisystemic wasting syndrome, which has spread worldwide. Monocyte/macrophage lineage cells are the major target cells of PCV2. To discover cellular protein responses of pulmonary alveolar macrophages (PAMs) to PCV2 infection, two-dimensional liquid chromatography-tandem mass spectrometry coupled with isobaric tags for relative and absolute quantification (iTRAQ) labeling was employed to quantitatively identify the proteins that were differentially expressed in PAMs from the PCV2-infected group compared to the uninfected control group. A total of 145 cellular proteins in PAMs that were significantly altered at different time periods post-infection were identified. These differentially expressed proteins were related to the biological processes of binding, cell structure, signal transduction, cell adhesion, etc., and their interactions. The high number of differentially expressed proteins identified should be very useful to elucidate the mechanism of replication and pathogenesis of PCV2 in the future.