Sublimation and Diffusion Kinetics of 2,4,6-Trinitrotoluene (TNT) Single Crystals by Atomic Force Microscopy (AFM).

In this article, we report the in-situ nanoscale experimental measurement of sublimation rates, activation energy of sublimation, and diffusion coefficients of 2,4,6-trinitrotoluene (TNT) single crystals in air using atomic force microscopy (AFM). The crystals were prepared by slow evaporation at 5 °C using acetone-dissolved TNT. The mass loss was calculated by monitoring the shrinkage of the surface area of layered islands formed on the surface of the TNT crystals due to sublimation upon isothermal heating at temperatures below the melting point. The results suggest the sublimation process occurs via two-dimensional detachment of TNT molecules from the non-prominent facets on the crystal surface which imitates the nucleation and crystal growth process. Sublimation rates are one order of magnitude smaller than previously reported values. However, the calculated activation energy (112.15 ± 3.2 kJ/mol) and temperature-dependent sublimation rates agree well with the reported values for TNT thin films and microcrystals determined by UV-vis absorbance spectroscopy and quartz crystal microscopy (QCM) (90-141 kJ/mol). The average diffusion coefficient is (4.35 × 10-6 m2/s) which is within the range of the reported theoretical values with an average of 5.59 × 10-6 m2/s, and about 25% less than that determined using thermogravimetric analysis for powder TNT.

Non-Isothermal Sublimation Kinetics of 2,4,6-Trinitrotoluene (TNT) Nanofilms.

Non-isothermal sublimation kinetics of low-volatile materials is more favorable over isothermal data when time is a crucial factor to be considered, especially in the subject of detecting explosives. In this article, we report on the in-situ measurements of the sublimation activation energy for 2,4,6-trinitrotoluene (TNT) continuous nanofilms in air using rising-temperature UV-Vis absorbance spectroscopy at different heating rates. The TNT films were prepared by the spin coating deposition technique. For the first time, the most widely used procedure to determine sublimation rates using thermogravimetry analysis (TGA) and differential scanning calorimetry (DSC) was followed in this work using UV-Vis absorbance spectroscopy. The sublimation kinetics were analyzed using three well-established calculating techniques. The non-isothermal based activation energy values using the Ozawa, Flynn⁻Wall, and Kissinger models were 105.9 ± 1.4 kJ mol-1, 102.1 ± 2.7 kJ mol-1, and 105.8 ± 1.6 kJ mol-1, respectively. The calculated activation energy agreed well with our previously reported isothermally-measured value for TNT nanofilms using UV-Vis absorbance spectroscopy. The results show that the well-established non-isothermal analytical techniques can be successfully applied at a nanoscale to determine sublimation kinetics using absorbance spectroscopy.

Sublimation kinetics and diffusion coefficients of TNT, PETN, and RDX in air by thermogravimetry.

The diffusion coefficients of explosives are crucial in their trace detection and lifetime estimation. We report on the experimental values of diffusion coefficients of three of the most important explosives in both military and industry: TNT, PETN, and RDX. Thermogravimetric analysis (TGA) was used to determine the sublimation rates of TNT, PETN, and RDX powders in the form of cylindrical billets. The TGA was calibrated using ferrocene as a standard material of well-characterized sublimation rates and vapor pressures to determine the vapor pressures of TNT, PETN, and RDX. The determined sublimation rates and vapor pressures were used to indirectly determine the diffusion coefficients of TNT, PETN, and RDX for the first time. A linear log-log dependence of the diffusion coefficients on temperature is observed for the three materials. The diffusion coefficients of TNT, PETN, and RDX at 273 K were determined to be 5.76×10(-6)m(2)/sec, 4.94×10(-6)m(2)/s, and 5.89×10(-6)m(2)/s, respectively. Values are in excellent agreement with the theoretical values in literature.

In situ direct measurement of vapor pressures and thermodynamic parameters of volatile organic materials in the vapor phase: benzoic acid, ferrocene, and naphthalene.

We report the direct determination of vapor pressures and optical and thermodynamic parameters of powders of low-volatile materials in their vapor phase using a commercial UV/Vis spectrometer. This methodology is based on the linear proportionality between the density of the saturated gas of the material and the absorbance of the gas at different temperatures. The vapor pressure values determined for benzoic acid and ferrocene are in good agreement with those reported in the literature with ∼2-7 % uncertainty. Thermodynamic parameters of benzoic acid, ferrocene, and naphthalene are determined in situ at temperatures below their melting points. The sublimation enthalpies of the investigated organic molecules are in excellent agreement with the ICTAC recommended values (less than 1 % difference). This method has been used to measure vapor pressures and thermodynamic parameters of organic volatile materials with vapor pressures of ∼0.5-355 Pa in the 50-100 °C temperature range.

Rapid estimation of thermodynamic parameters and vapor pressures of volatile materials at nanoscale.

Non-isothermal measurements of thermodynamic parameters and vapor pressures of low-volatile materials are favored when time is a crucial factor to be considered, such as in the case of detection of hazardous materials. In this article, we demonstrate that optical absorbance spectroscopy can be used non-isothermally to estimate the thermodynamic properties and vapor pressures of volatile materials with good accuracy. This is the first method to determine such parameters in nanoscale in just minutes. Trinitrotoluene (TNT) is chosen because of its low melting temperature, which makes it impossible to determine its thermodynamic parameter by other rising-temperature techniques, such as thermogravimetric analysis (TGA). The well-characterized vapor pressure of benzoic acid is used to calibrate the spectrometer in order to determine the vapor pressure of low-volatile TNT. The estimated thermodynamic properties of both benzoic acid and TNT are in excellent agreement with the literature. The estimated vapor pressure of TNT is one order of magnitude larger than that determined isothermally using the same method. However, the values are still within the range reported in the literature. The data indicate the high potential for use of rising-temperature absorbance spectroscopy in determining vapor pressures of materials at nanometer scale in minutes instead of hours or days.

Thermo-optical determination of vapor pressures of TNT and RDX nanofilms.

Accurate thermodynamic parameters of thin films of explosives are important for understanding their behavior in the nanometer scale as well as in standoff detection. Using UV-absorbance spectroscopy technique, accurate thermodynamic parameters such as activation energies of sublimation, sublimation rates, and vapor pressures of the explosives cyclotrimethylenetrinitramine (RDX) and 2,4,6-trinitrotoluene (TNT) were determined. The values of these parameters are in excellent agreement with those reported using traditional experiments based on gravimetry. In terms of the Clapeyron equation, the dependence of RDX and TNT vapor pressures on temperature can be described by the relations LnP (Pa)=39.6-15459/T (K) and LnP (Pa)=34.9-12058/T (K), respectively. Heats of sublimation of RDX and TNT were also determined to be 128kJ/mol and 100.2kJ/mol, respectively.

Simple method for determining the vapor pressure of materials using UV-absorbance spectroscopy.

Accurate thermodynamic parameters of thin films of materials are crucial in understanding their behavior in the nanometer scale. A new and simple method for determining the vapor pressure and thermodynamic properties of nanometer thick films of materials was developed based on UV-absorbance spectroscopy. Well-characterized benzoic acid was used to calibrate the spectrometer and the experimental conditions. The thermodynamic properties of pentaerythritol tetranitrate (PETN) were determined to validate the use of this new method. The estimated values of the thermodynamic parameters of PETN are in excellent agreement with the values reported using the most widely used Knudsen effusion method for determining vapor pressure lower than 1 pascal. The elegance of this method is its simplicity. The results indicate that UV-absorbance spectroscopy is a model-free and powerful technique in determining thermodynamic parameters in the nanoscale.

Early events in 2,4,6-trinitrotoluene (TNT) degradation by porphyrins: binding of TNT to porphyrin by hydrophobic and hydrogen bonds.

The interaction of meso-tri(4-sulfonatophenyl)mono(4-carboxyphenyl) porphyrin (C1TPP) with 2,4,6-trinitrotoluene (TNT) has been explored by UV-vis and fluorescence spectroscopy. The influence of temperature on the interaction has also been studied. C1TPP binds to TNT at pH 7.0 at room temperature via 1.94 kcal/mole hydrogen bonds with absorbance loss at 412-413 nm and the appearance of a new peak at 422-424 nm. The hydrogen binding of TNT to C1TPP was confirmed by the dissolution of the complex upon the addition of urea. Increasing the temperature results in the appearance of a new absorbance peak at 540 nm and absorbance loss at 515 nm with activation energy of 29.7 kcal/mole in the range of the hydrophobic bond energy. This suggests the hydrophobic bonding of TNT with the pyrrole nitrogens in the porphyrin. Increasing the concentration of the TNT in the solution quenches the fluorescence of the porphyrin following the Stern-Volmer equation. The association constants calculated from absorbance and fluorescence are expectedly similar.