Reducing Aerosol Emissions by Decoupled Parameter Management during the CO2 Capture Process in a Multi-stage Circulation Absorber.

Aerosol emissions from the CO2 capture process have a significant impact in terms of solvent loss and environmental pollution. Here, we propose a novel approach with multi-stage circulation for CO2 capture and synergistic aerosol reduction, which divides the absorption section into three circulation stages and reduces aerosol emissions through decoupled operation of the three absorption sections and the management of solvent CO2 loadings. Experimental results show that with the decoupled management of the liquid-gas ratio and solvent temperature in absorption sections, the aerosol mass concentration at the outlet of the 3rd absorption section can be reduced by 25.6% to a minimum of 349.7 mg/m3 at a liquid-gas ratio of 43.2 L/m3 and a solvent temperature of 303 K. Furthermore, aerosol removal is performed by setting up a water wash section after the absorption section. The aerosol mass concentration at the outlet of the absorber is reduced to 168.6 mg/m3 with the regulation of the wash water temperature and flow rate. In addition, improvements are proposed for the combination of the utilization of recovered solvents and the co-removal of SO2. This study provides innovative insights into the design of the CO2 capture system and the reduction of aerosol emissions, which are of great significance for the mitigation of global warming and the control of environmental pollution.

Tuning Ionic Liquid-Based Catalysts for CO2 Conversion into Quinazoline-2,4(1H,3H)-diones.

Carbon capture and storage (CCS) and carbon capture and utilization (CCU) are two kinds of strategies to reduce the CO2 concentration in the atmosphere, which is emitted from the burning of fossil fuels and leads to the greenhouse effect. With the unique properties of ionic liquids (ILs), such as low vapor pressures, tunable structures, high solubilities, and high thermal and chemical stabilities, they could be used as solvents and catalysts for CO2 capture and conversion into value-added chemicals. In this critical review, we mainly focus our attention on the tuning IL-based catalysts for CO2 conversion into quinazoline-2,4(1H,3H)-diones from o-aminobenzonitriles during this decade (2012~2022). Due to the importance of basicity and nucleophilicity of catalysts, kinds of ILs with basic anions such as [OH], carboxylates, aprotic heterocyclic anions, etc., for conversion CO2 and o-aminobenzonitriles into quinazoline-2,4(1H,3H)-diones via different catalytic mechanisms, including amino preferential activation, CO2 preferential activation, and simultaneous amino and CO2 activation, are investigated systematically. Finally, future directions and prospects for CO2 conversion by IL-based catalysts are outlined. This review is benefit for academic researchers to obtain an overall understanding of the synthesis of quinazoline-2,4(1H,3H)-diones from CO2 and o-aminobenzonitriles by IL-based catalysts. This work will also open a door to develop novel IL-based catalysts for the conversion of other acid gases such as SO2 and H2S.

Comparison of the Effectiveness and Safety of Vildagliptin Add-On to Metformin Versus Other Oral Dual Antidiabetes Agents in Patients with Type 2 Diabetes: The China Prospective Diabetes Study.

INTRODUCTION: The efficacy and safety of vildagliptin alone or with metformin is well established by randomized trials, but it is unknown whether it can be extrapolated to the real-world setting in Chinese patients with type 2 diabetes mellitus (T2DM). This study aimed to assess the effectiveness and safety of vildagliptin add-on to metformin versus dual oral antidiabetes drug (OAD), non-vildagliptin combination therapies in real-world Chinese patients with T2DM. METHODS: The China Prospective Diabetes Study was a post-marketing, prospective, multicenter, observational, real-world study conducted in 52 centers. Patients inadequately controlled with OAD monotherapy and who initiated vildagliptin add-on to metformin (VM cohort) or two OADs other than vildagliptin (comparator cohort) were included for the present analysis. The composite primary endpoint was glycated hemoglobin (HbA1c) < 7% and without tolerability events (hypoglycemia, weight gain ≥ 3%, or discontinuation due to gastrointestinal events) at 12 months. Secondary endpoints included change in HbA1c from baseline, subgroup analysis, and tolerability. Propensity score matching analysis was performed to adjust for baseline covariates imbalance (body mass index (BMI) and HbA1c). RESULTS: A total of 604 patients received VM and 670 received comparator therapy. Patients who received VM were younger, more obese, and had a higher baseline HbA1c and a shorter duration of T2DM. After propensity score matching, there were 530 patients per cohort. After 12-month treatment, the success rates of the composite primary endpoint were 50.9% and 33.0% in the VM and comparator cohorts, respectively (P < 0.001; odds ratio = 2.10, 95% confidence interval (CI) 1.64-2.70). Furthermore, the success rates of the composite endpoint were higher with VM across geographic area, BMI, and baseline HbA1c subgroups. Fewer tolerability events occurred in the VM cohort versus the comparator cohort (8.3% vs. 16.2%, P < 0.001; relative risk = 0.51, 95% CI 0.36-0.72). CONCLUSION: Compared with dual OAD non-vildagliptin combination therapies, vildagliptin add-on to metformin is effective and safe to achieve glycemic control in Chinese patients with T2DM. FUNDING: Novartis.

Highly Stretchable Strain Sensors Using an Electrospun Polyurethane Nanofiber/Graphene Composite.

A highly flexible and stretchable strain sensor has been prepared by coating chemical reduction of graphene oxide on electrospun polyurethane nanofiber mats. The sensor exhibits an ohmic behavior regardless of applied strains and the current monotonically increases with the increase of the tensile strain. The morphology and stability of electrospun polyurethane nanocomposite mats were also studied. The flexible and stretchable strain sensor has great potential for practical application such as efficient human-motion detection. This cheap and simple process of graphene layer provides an effective fabrication for graphene stretchable electronic devices and strain sensors due to excellent stability and electrical proper.

[Multi-centered, randomized controlled clinical study on Chinese medicine formula particles for hyperlipidaemia associated with highly active antiretroviral therapy].

OBJECTIVE: To observe the effect and safety of Xiaozhi particles, integrated taohong Siwu tang and Erchen tang and Xuezhikang capsule in treating hyperlipidaemia (HLP) associated with highly active antiretroviral therapy (HAART). METHOD: In the multi-centered, randomized controlled clinical study, 180 hyperlipidaemia associated with highly active antiretroviral therapy cases were divided into the treatment group treated by Xiaozhi particles, integrated Taohong Siwu tang and Erchen tang, and the control group treated by Xuezhikang capsule. The treatment course was 12 weeks. The total cholesterol (Tch), triglyceride (TG), low density lipoprotein (LDL) and high-density lipoprotein(HDL) were observed. RESULT: After 12 weeks, compared with Xuezhikang capsule, the change difference of Tch, LDL, HDL in the Chinese traditional medicine formula groups of patients is significant (P < 0.05), the change of the TG has no significant difference. The effect of Tch, LDL in Xuezhikang capsule groups is better than in traditional Chinese medicine formula group,but the effect of HDL in traditional Chinese medicine formula group is better than in Xuezhikang capsule groups. CONCLUSION: Integrated Taohong Siwu tang and Erchen tang, Xiaozhi particles and Xuezhikang capsule can be used to control the hyperlipidaemia associated with highly active antiretroviral therapy as one of the main Chinese native medicine preparation.

[Inhibition of sulfite oxidation catalyzed by heavy metals in dual alkali flue gas desulfurization slurry].

Heavy metals accumulated in slurry of dual alkali flue gas desulfurization (FGD) present a significant catalysis to SO3(2-) oxidation, resulting in a waste of effective components for desulfurization. Na2S was adopted to precipitate heavy metal ions in FGD slurry, and the oxidation rate of SO3(2-) was obtained under different concentrations of heavy metal ions, to reveal the inhibition effect of Na2S on SO3(2-) oxidation catalyzed by heavy metal ions. Mn2+ showed a remarkable catalysis to SO3(-2) oxidation, as the initial oxidation rate of SO3(2-) was tripled to 0.65 mmol/(L x min) by adding 1.0 mmol/L Mn2+ into the slurry. SO3(2-) was catalytically oxidized rapidly with the reaction order 0.169 of Mn2+ within first 60 minutes, so it is of great importance to control the concentration of Mn2+ to inhibit SO3(2-) oxidation. At initial pH value of 6.50-8.50, Na2S removed heavy metal ions effectively from FGD slurry. Higher pH value favored the removal of heavy metal ions. The removal efficiencies of Mn2+, Zn2+, Ni2+ and Cd2+ were 91.0%, 88.1%, 85.5%, and above 99.9% respectively under the conditions of initial pH value 8.50 and Na2S dosage 240.0 mg/L. Mn2+ could be used as an indicator for the concentration of the heavy metal ions in the slurry. As the Mn2+ concentration decreased from 1.0 mmol/L to 5.0 x 10(-3) mmol/L by adding Na2S, the initial oxidation rate of SO3(2-) decreased by 64.6% to 0.23 mmol/(L x min). The desulfurization efficiencies increase 3.8%-5.1% by adding Na2S in a pilot scale setup. It comes to conclusion that heavy metal ions precipitation by adding Na2S with an indicator of Mn2+ to inhibit catalytic oxidation of SO3(2-) is feasible to reduce the consumption of desulfurizer in FGD slurry.